Lokk Latch 50082 Operating instructions

Lokk Latch 50082 Operating instructions
 Lokk-Latch Deluxe Re-keying Assembly
External Access Kit (EAK)
TO DISASSEMBLE
Step 1: Remove bracket plate from housing using
finger to rotate piece out.
BRACKET
HOUSING
Step 2: Remove push button assembly.
Step 3: A. Remove clip. B. Remove Lock Cylinder
CLIP
TO ASSEMBLE
Step 1: A. Insert lock cylinder into push button
B. Push clip under guiding rails all the way towards
lock
Step 2 : Insert push button assembly into housing
cavity. Make sure Lock Cylinder is at the bottom of
the push button when installing onto fence post (!)
Step 3 : À. Position bracket plate with the hole
directly over the Lock Cylinder Tail as shown.
B. Push down and snap bracket plate into groove.
— LOCK CYLINDER
AT BOTTOM
LOCK CYLINDER TAIL
Lokk-Latch Deluxe Re-keying Assembly
Latch Body
TO DISASSEMBLE
Step 1: Unscrew three Philips head screws and
remove mounting bracket
| BRACKET |
| BODY |
Step 2 : Remove lock cartridge assembly by
pushing face of Lock Cylinder through Body
de
E | Ca
mz {
Co
—
|
\
Step 3 : Remove Disc, Bush, and Spring from Lock
Cartridge assembly.
CARTRIDGE | | SPRING
BUSH | | DISC
Step 4 : A. Un-clip the hook on the Lock Cartridge
and open as shown
B. Remove Lock Cylinder
TO ASSEMBLE
Step 1 A. Insert Lock Cylinder back into Lock
Cartridge and re-hook the clip.
B. Lock Tail should be horizontal as shown
I (iS LOCK TAIL | В
Step 2 : Install Spring and Bush into cartridge.
Squeeze the sides of Lock Cartridge making sure
both Lugs of the Bush fit as shown
Step 3 : A. Insert Disc making sure Lock Tail slides
into the slot in the center of the Disc.
(1) -Double check the Bush to ensure both Lugs are
still inside the slots on the Lock Cartridge
DISC
Step 4 : A. Make sure the Disc is turned so that it
leans up against the left hand side of the housing.
B. Push Lock Cartridge assembly back into housing
using the internal guides.
Step 5 : Check that the face of the Lock Cylinder is
flush with outer body and not at an angle
Step 6 : Re-determine the proper handing of the
bracket and reinsert the three screws as shown.
DO NOT insert a screw into the hole that is located
second up from the bottom (X).
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement