Roof Zone 65002 User manual
TM Folding Warning Line System Part #65002 & 65003 www.roofzone.com Set Up: 1) Pull Up 2) Pull Out 3) Push Down Break Down: 1) Pull Out 2) Pull Up 3) Lock Closed CAUTION: READ AND FOLLOW INSTRUCTIONS CAREFULLY BEFORE USE! The following are basic warning line setup instructions. For complete guidelines, see OSHA 1926.501 and 1926.502 Fall Protection Standard and your local and state requirements. Part #08245 TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336 www.tiedown.com (404) 344-0000 Fax (404) 349-0401 E1420; 060115 1. The warning line shall be erected around all sides of the roof work area. 2. When mechanical equipment is not used, the warning line shall be erected not less than 6 feet from the roof edge. 3. When mechanical equipment is being used, the warning line shall be erected not less than 6 feet from the roof edge which is parallel to the direction of mechanical equipment operation, and not less than 10 feet from the roof edge which perpendicular to the direction of mechanical equipment operation. 4. Flags shall be rigged/supported so that its lowest point is no less than 34" and its highest point is no more that 39" from the walking/working surface.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
Mutual Industries 15903-41-3 105 ft. OSHA Yellow Pennants Perimeter Markers (3-Pack) Instructions / Assembly