Clean-N-Dip 655G1 1 gal. Safe Removal Concentrate for Spray Guns, Tips and Other Accessories Specification

Clean-N-Dip 655G1 1 gal. Safe Removal Concentrate for Spray Guns, Tips and Other Accessories Specification
Material Safety Data Sheet
U. S. Department of Labor
May be used to comply with
OSHA’s Hazard Communication Standard,
29 CFR 1910.1200. Standard must be
consulted for specific requirements.
Occupational Safety and Health Administration
(Non-Mandatory Form)
Form Approved
OMB No. 1218-0072
Note: Blank spaces are not permitted. If any item is not applicable, or no
information is available, the space must be marked to indicate that.
IDENTITY (As Used on Label and List)
CLEAN-N-DIP CONCENTRATE
Section I
Manufacturer’s Name
Manufacturer’s Code: 655
Sunnyside Corporation
Address (Number, Street, City, and ZIP Code)
225 Carpenter Avenue
Wheeling, IL 60090
Emergency Telephone Number
Chem Trec
(800) 424-9300
Telephone Number for Information
(847) 541-5700
Date Prepared
Signature of Preparer (optional)
09/19/11
Section II-Hazardous Ingredients/Identity Information
Hazardous Components ( Specific Chemical Identity; Common Name(s)) OSHA PEL ACGIH TLV Other Limits % (optional)
Benzyl Alcohol (100-51-6)
Not Established
40-60%
Non-Hazardous Components
N/A
40-60%
Section III- Physical/Chemical Characteristics
Boiling Point
1000 C, 2120 F
Specific Gravity (H20=1)
1.01
Vapor Pressure (mm Hg.) 13mm Hg at 25 0C
Melting Point
N/A
Vapor Density (AIR =1)
Evaporation Rate (Butyl Acetate=1) <1.
8.6-8.7
Solubility in Water
Considerable
Appearance and Odor
Milky white, faint aromatic odor
Section IV- Fire and Explosion Hazard Data
Flash Point (Method Used)
Extinguishing Media
over 2000F
Flammable Limits
LEL
N/A
UEL
N/A
Use C02 , foam, or dry chemical to extinguish fire.
Special Fire Fighting Procedures. Wear self-contained, positive pressure breathing apparatus and full firefighting protective clothing.
Hazard Rating for Flammability 1
Unusual Fire and Explosion Hazards Decomposition under fire conditions will generate carbon monoxide and may generate other
toxic vapors.
N/A = Not Applicable
Section V-Reactivity Data
Stability
Conditions to Avoid
Unstable
X
Stable
Hot or cold Storage
REACTIVITY = 0
Incompatibility (Materials to Avoid)
Strong oxidizers, acids and alkalies
Hazardous Decomposition or Byproducts
Thermal decomposition (combustion) will produce carbon monoxide and dioxide.
Hazardous
Polymerization
Conditions to Avoid
May Occur
N/A
X
Will Not Occur
Section VI-Health Hazard Data
Route(s) of Entry:
Inhalation
Skin
1
1
Ingestion
1
Health Hazards (Acute and Chronic) Direct contact or exposure to mists and vapor may cause slight to moderate eye irritation.
Prolonged or repeated exposure to product, vapors, or mists may cause slight skin irritation. Ingestion may cause moderate to
severe irritation of the gastrointestinal tract. Inhalation exposure to vapor or mists may cause moderate to severe irritation of the
respiratory tract.
Carcinogenicity:
NTP
IARC monographs
OSHA Regulated
1
Not listed
Not regulated
Signs and Symptoms of Exposure: Eye Contact: a stinging sensation, excess blinking and tear production, redness and swelling
of the conjunctive. Skin Contact: redness and a burning sensation. Prolonged or widespread contact may result in the absorption of
potentially harmful amounts of material, with identical symptoms as ingestion. Ingestion: nausea, headache, dizziness, and
abdominal pain. Inhalation: headache, nausea, coughing, chest pain and vomiting.
Medical Conditions Generally Aggravated by Exposure
None known
Emergency and First Aid Procedures Inhalation-remove victim to fresh air and seek medical attention if irritation persists.
Eyes-immediately flush exposed areas with large quantities of water for at least 15 minutes. Skin- immediately flush skin with
large amounts of water for at least 15 minutes while removing contaminated clothing. If irritation is evident or discoloration
persists, seek medical attention. Ingestion-do not induce vomiting unless directed by medical personnel. Drink large quantities of
water or milk. Seek medical attention.
Section VII-Precautions for Safe Handling and Use
Steps to Be Taken in Case Material is Released or Spilled Remove any source of ignition. Dike spill using soil, sand, or
absorbent. Soak up with suitable, non -combustible absorbent material, collect in suitable containers for disposal. Recover free
product, if possible. Prevent flow to sewer and public waters. For water spill, notify downstream users of possible contamination.
Waste Disposal Method
Dispose of in accordance with all Local, State and Federal regulations.
Precautions to Be Taken in Handing and Storing
Store at temperatures between 320F-1100F,keep container tightly closed.
Empty containers should be thoroughly rinsed with water and disposed of according to local regulations.
Section VIII-Control Measures
Respiratory Protection (Specify Type) Use NIOSH approved chemical cartridge (organic vapor) respiratory equipment when
spraying material (full face respirator is recommended)
Local Exhaust Sufficient to maintain air concentration as required by OSHA
Special
N/A
Ventilation
Mechanical (General)
Protective Gloves
Other Protective Clothing or Equipment
Eye wash as needed.
N/A = Not applicable
Maintain adequate ventilation
Other
N/A
Eye Protection Eye protection for application and removal such as
chemical splash goggles.
Impervious coveralls, apron, boots, as necessary to prevent skin contact.
Butyl rubber, Neoprene gloves
Section IX-Additional Information
This product does not contain any chemicals that are reportable under Section 313 of Title III of the Superfund Amendments and
Reauthorization Act of 1986 and 40 CFR Part 372.
TRANSPORTATION:
Not regulated.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement