Rust-Oleum EpoxyShield | 238475 | Specification | Rust-Oleum EpoxyShield 238475 Specification

TECHNICAL DATA
ESH-02
EPOXYSHIELD®
CONCRETE ETCH
.DESCRIPTION AND USES
.
.PRODUCT APPLICATION (cont.)
EpoxyShield® Concrete Etch is comprised of citric acid
crystals designed to provide effective cleaning and etching
for preparing concrete floors in garages and other
residential areas prior to coating. Concrete Etch removes
laitance and creates a surface profile to promote adhesion
of the coating. Concrete Etch is intended for use on bare
concrete surfaces. There is no benefit for use on
previously coated floors.
PRODUCTS
238475
APPLICATION
Scrub the floor with a stiff bristle brush and make sure the
floor stays wet during this process until you are ready to
rinse. In garages,pay special attention to the area where
the vehicle tires normally stand. Continue to scrub while
rinsing to ensure all contaminates are washed away.
Squeegee off excessive water or puddles and allow to dry
thoroughly.
For best results, clean a 10x10 foot (3x3 meters) sections
at a time. Completely wash, rinse, and squeegee each
section before moving on the next. When all sections have
been completed in this manner, then re-rinse the
squeegee the entire floor.
When the floor is dry, rub your hand on the concrete and
check for a white film. If a white dust or powder is
evidence, repeat the rinsing process being sure to
thoroughly scrub during the rinse. Once the concrete is
free of surface residue, you are ready to begin application
of the coating.
.
Concrete Etch
APPEARANCE
.
Small white granules.
PACKAGING
.
Reinforced carton containing 1 pound bag (450 grams) of
white granules.
PRODUCT APPLICATION
.
.
SURFACE PREPARATION
Allow new concrete to cure for a minimum of 28 days.
Sweep away all loose dirt and debris. Clean and remove
any oil spots or spills and wash floor with a suitable
detergent or degreasing solution and rinse thoroughly.
MIXING
For best results when using the Concrete Etch, the
concrete should be damp but free of puddles. Mix the
entire contents of the Concrete Etch granules with 2
gallons (7.58 liters) of water. Use a plastic sprinkling can
to evenly distribute the Concrete Etch solution.
1
Form: CS2858
Rev.: 081913
TECHNICAL DATA
EPOXYSHIELD® CONCRETE ETCH
.PHYSICAL PROPERTIES
.
CONCRETE ETCH
Solids
By Weight
100%
By Volume
100%
Solvents
None
Shelf Life
Safety
For additional information, see MSDS
Unlimited
Calculated values may vary slightly from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
An RPM Company
Phone: 877•385•8155
www.rustoleum.com
Form: CS2858
Rev.: 081913

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project