Home Decorators Collection U-BN144FONS05 72 in. L - 144 in. L Telescoping Premium 1 in. Single Rod Kit Installation guide

DRAPERY ROD SET INSTALLATION GUIDE
Note:
Finial shown is for illustration purposes only.
It may not represent the style of finial purchased.
For larger width windows, two persons may be required for easier leveling.
Tools needed:
Tape Measure, Pencil, Drill & Bit Set, Philips head
Screwdriver, Level
110 & "”& 00)
Philipshead
Screwdriver
Tape Measure Pencil Drill & Bit Set Level
BRACKET INSTALLATION
STEP 1.
Place brackets against wall or ceiling at desired locations т
and mark screw holes. Use tape measure and level to make |
sure marked screw holes are horizontal to each other.
STEP 2A. (FOR MOUNTING TO DRYWALL, CEILING,
OR PANELING)
Pre-drill two pilot holes for each bracket ( 1/4” drill bit) and CEILING MOUNT DRY WALL
insert anchors into wall/ceiling and insert screws into wall
anchors. "OR (x + |
STEP 2B. (FOR MOUNTING TO WOOD OR STUDS) STUDS - |
If mounting directly into wood or studs, pre-drill two pilot
holes for each bracket ( 1/4” drill bit) and install bracket on 5
the wall with screws provided.
STEP 3.
Determine projection of brackets. Loosen projection screw,
slide bracket to desired position and tighten projection
screw. Repeat for each bracket.
PROJECTION
ROD INSTALLATION
STEP 4.
Detach finial from inner rod.
STEP 5.
Attach finial to extra outer rod. Assemble rod and
shirr drapery treatment onto rod.
STEP 6.
Extend rod to desired width and place it into the brackets.
Adjust draperies to desired position.
FINAL ADJUSTMENT
STEP 7.
Secure each rod by tightening screws provided.