Carlon B618RR-UPC Round Old Work Electrical Box (Case of 8) Instructions

Carlon B618RR-UPC Round Old Work Electrical Box (Case of 8) Instructions
 LAMSON & SESSIONS
B618R INSTALLATION INSTRUCTIONS
1. Using the template, mark and center punch the one center and the three outer holes.
2. Using a 1/2" drill bit, drill three relief holes at 120° separation on the outer edge of the circle.
3. Use a saber saw to cul out 47 hole.
7, Strip 5/8” of insulating jacket from wire or asaurkSpecitied by device literature,
8. Push stripped wires from outside into appropriate clamping window.
8. When stripped wires are visible, bend 90°
10, Continue wire insertion until cuter jacket {s under clamping shoe.
11. Band N-M cable 90° at point of entry under clamp shoe,
12. Pult N-M cable from outside box untif clamp shoe has engaged,
13. Push excess cable into inner wall,
\ 14. Insert box into opening of mountinig surface,
18. Tighten diagonal screws to secure swing clamg to inside wall
“ 16. Proceed with wiring per device instructions.
FORM NO. 618 REV, 1/87
|522
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement