Rust-Oleum EpoxyShield 262245 Instructions

Rust-Oleum EpoxyShield 262245 Instructions
== RUST-OLEUM’
CORPORATION
www.rustoleum.com
11 Hawthorn Pkwy., Vernon Hills, IL 60061 1-877-815-2536
"
TRUSTED GUaLITY SINCE 190%:
RUSTOLEUM
a, pr —— SED = = = —,
= ING = 1 Nal
Th IX y TU
>
a
A - \
EPOXYSHIELD® BLACKTOP FILLER SEALER
APPLICATION INSTRUCTIONS
SURFACE PREPARATION: To ensure proper adhesion and promote maximum service life, clean the
entire driveway surface making sure it is free of dirt, debris, oil, and grease. Trim any grass or weeds
overgrowing onto the driveway. Clean out all cracks and holes using a screwdriver or wire brush.
Remove any remaining dirt and debris by sweeping with a stiff bristled broom. Clean heavy grease
and oil spots with EpoxyShield Blacktop Cleaner & Degreaser (sold separately). Thoroughly rinse
entire driveway with fresh water and allow the surface to dry before application. Repair major cracks
and/or holes in the surface prior to coating with EpoxyShield Patch & Crack Filler (sold separately).
Follow instructions on the package. Trowel patch & crack filler into small holes up to 1" deep or pour
into cracks up to 2" wide. Note: Newly paved asphalt surfaces must be allowed to cure for a minimum
of six months or a full summer's season prior to application of any coating.
APPLICATION: Apply only when air, material, and surface temperatures are between 50-90°F (10-
32°C) and the surface temperature should not exceed 100°F (38°C). No rain should be forecasted for
48 hours. Stir coating thoroughly to re-disperse any settled pigment. (Optional: Use brush to trim
If you have any questions or concerns regarding this product please contact Rust-Oleum
product support at (877) 385-8155
de RUST-OLEUM
CORPORATION
www.rustoleum.com
11 Hawthorn Pkwy., Vernon Hills, IL 60061 1-877-815-2536
edges of the driveway before applying to entire surface). Pour out % of the container and work the
product across the blacktop using an 18-24" floor or driveway squeegee. Avoid applying coating is
direct sunlight. If pavement is extremely hot, apply a fine water mist to the coating surface and brush
out any remaining water puddles. Coverage range is based on proper application. Coverage will vary
depending on the condition of the asphalt surface and will ultimately depend on the pavement
porosity. Extreme porous pavement may significantly reduce product coverage. Application that is
too thick may result in peeling. For asphalt in poor condition, a 2-coat application will improve
uniform look and appearance. Do not mix or blend this product with any other driveway coating
product. Do not dilute. CLEAN-UP Wash tools and equipment with warm water and a mild detergent
immediately after use.
If you have any questions or concerns regarding this product please contact Rust-Oleum
product support at (877) 385-8155
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement