Boyel Living SL-SLC18188 Installation guide

Boyel Living SL-SLC18188 Installation guide
Step 4 Parts list
NO.
PART NAME
Body
Washer
Screw
Washer
Gasket
Lock nut
Spray
© ONO | ON =
Washer
KITCHEN FAUCET
INSTALLATION INSTRUCTION
INIA
—
=
KITCHEN FAUCET
N
RECOMMENDED TOOLS
The tools might be applied to the following places:
Tools You Will Need: Sy
AS S
Plumber's putty
y
y
DD
DD
Pipe tape ZZ
Y =
Philips Screwdriver pliers Adjustable wrench
8
—
Notice:
1.Cleaning ( | | —
Before installation, shut off the water supply valves and clean up the water supply system.
2.Mounting hole
Make sure the mounting hole size is between ÿ33mm- SS 35mm as show in the diagram.
3.Protection
Clean the area of the mounting holes before installation.
To preserve the delicate finish of the faucet,please do not scratch, but use a soft cloth to wipe around it. Lo
Do not tighten the faucet too hard,so as to avoid deformation of fracture.
Parameter: —
1.Water pressure Ч |||!
Min:0.05Mpa Max:0.75Mpa NE
2.Temperature of water supply <85%C Xe
3.Working Temperature20°C |
\ | | a
3)
& aux,
Attention: TD В
for easy installation, you will need:
1.To read all the installation instruction completely before
beginning.
2.To read all the warning, attention and maitenance
information.
3.To purchase the proper supply lines.
Step1 Faucetinstallation
dé
1.At first, instill the washer in the groove of the 2.Put the faucet into the installation hole.
bottom of the faucet, and then screw the lock nut (Suggestion:
diameter 35MM for installation hole )
Put the washer and gasket on the lock nut as
shown, then tighten with screws.
on It. Tighten the hot and cold hose with the
body of the faucet.
-04-
-03-
3.Connect the flexible hoses to water supply valve,
and tighten it with adjustable wrench. Don't over
tighten avoiding damage the washer.
Maintenance:
1.Operate the faucet gently in order for a sustainable use.
2.Always blot dry any water from faucet surface.Clean with a damp non-abrasive sponge
and wipe it with a clean soft cloth should be helpful to maintain good finish of the faucet.
To remove water spots,apply warm water and a soft cloth.Make certain to rinse thoroughly
with water immediately after cleaner.
3.Although the finish is extremely durable,it can be damaged by some cleaners.Do not use
detergent powder, polishingpowder,granular detergent or nylon brush to clean.
4.Do not use acidic detergents.If happened,it must be rinsed property and wiped dry with a
soft cloth.
5.When the air temperature is below 0 C, heating solution in the house is a must.
6.5hut off the water supply valves while it will not be in use for a long time.
7.We reserve the right to make revisions in the design of faucets without notice.
Step 2 Checking and testing
М
Note:Don't lost the O-ring filter.
1. Turn on the hot and cold water for 1 minute In 2.Check all connection at arrows for leaks,
order to check the outlet re-tighten It If necessary.
BUT DON'T OVER TIGHTEN
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement