www.numatic.co.uk
GB
Original Instructions -
CAUTION Read instructions before using the machine.
BS8 / BA8
x 4
CV / CVD 900 Drum Assembly
Kit BS8 / BA8
Assembly
On / Off
Using the Machine
Warning
You must make sure all waste material has been emptied from machine AFTER use.
Make sure all filters are clean BEFORE every use.
Emptying the Machine
CV / CVD 570
CV / CVD 900
Cleaning the Filters
Do not replace filter until completely dry!
1
4
7
5
8
10 11
2
Changing the Cable
3
6
9
Changing the Cable
Rating Label
1
8
9
6
7
10
4
5
2
3
Company Name & Address
Machine Description
Voltage / Frequency
Power rating
Weight (ready to use)
IPX Rating
WEEE Logo
Class 2 Symbol
CE Mark
Machine yr/wk Serial number
1
2
3
4
IPXX
Safety Critical Component:
Mains Lead
H05VV-F 10m x 2 x 1.0mm²
H05VV-F 10m x 2 x 1.5mm²
(115v ) H05VV-F 10m x 2 x 2.5mm²
7
WEEE Legislation
(Waste, Electrical and Electronic Equipment)
Vacuum cleaner, accessories and packaging should be sorted for environmentally - friendly recycling.
(Only for EU Countries)
Do not dispose of vacuum cleaner into household waste! According to the European Directive 2012/19/EU on waste electrical and electronic equipment and its incorporation into national law.
Vacuum cleaners that are no longer suitable for use must be separately collected and sent for recovery in an environmentally - friendly manner.
5
6
8
9
10
Ear Protection Safety Footwear Head Protection Safety Gloves Eye Protection
Protective
Clothing
Dust / Allergens
Protection
Hi Vis Jacket
In the event of a breakdown contact your Numatic dealer or the
Numatic Technical help line +44 (0)1460 269268
Caution Floor Sign
Information for Wet & Dry use vacuum cleaners
WARNING
Read the instruction manual before using the machine. Operators shall be adequately instructed on the use of these machines.
As with all electrical equipment, care and attention must be exercised at all times during use, in addition to ensuring that routine and preventative maintenance is carried out periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard could render this equipment unsafe and the manufacturer can accept no responsibility in this respect.
The machine shall be disconnected from the mains by removing the plug from the supply socket during cleaning or maintenance and when replacing parts or converting the machine to another function.
This machine is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience or knowledge.
Children being supervised are NOT to play with the machine.
This appliance is intended to be assembled, cleaned and maintained by an adult.
This machine is not a toy.
This machine is not suitable for the collection of flammable liquids, biological hazards, and hazardous or explosive dust.
You should contact your local distributor if you require a machine capable of performing these tasks.
If foam/liquid comes out of machine exhaust, switch off immediately. Allow the accumulated liquid to drain out through the machine exhaust, check the float assembly to ensure correct operation, empty the container if full of liquid, reassemble the machine. Immediately upon start up there will be a certain amount of liquid issuing from the machine exhaust which will be the residue of liquid still within the power head. This will be quickly discharged after which the machine should function normally.
Liquid ejected from the machine could be hazardous as a result of its temperature, pressure or chemical content.
Ensure that the filtration system fitted to the machine is suitable for the material being collected.
This machine is for indoor use only.
This machine shall be stored indoors only.
When moving from one place to another, consider the weight of the machine.
CAUTION
NOTE: This product complies with the requirements of clause 20 of IEC/EN 60335-2-69 Stability and Mechanical Hazards.
If the supply cord is damaged, it must be replaced by a special cord assembly available from the manufacturer.
This machine is also suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offices for other than normal housekeeping purposes. This machine can be used for wet and dry pick up.
DO
•
•
•
•
•
•
•
•
Keep your machine clean.
Keep filters clean.
• Regularly clean the water level limiting float safety valve and examine for signs of damage or correct
operation.
Keep hoses clear.
Replace any worn or damaged parts immediately.
Regularly examine the power cord, if damage is found, power cord must be replaced by a qualified person using the correct Numatic original part.
Empty dust container frequently.
Keep diffuser filter (where fitted) clean.
Dispose of waste in an enviromentally responsible way.
DON’T
•
•
•
•
•
•
•
•
•
•
•
Use steam cleaners or pressure washers to clean the machine or use the machine in the rain.
Immerse in water for cleaning.
Allow any inexperienced repairs. Call the experts.
Use wet if float valve is not functioning or fitted.
Use to suck up hot ashes, or lighted cigarette ends.
Run the machine over the power cable during operation as a hazard may occur.
Pull on the cable to unplug the machine from the power supply.
Walk over-wet carpets, upholstery or fabrics.
Walk on clean carpets until fully dry.
Spray onto people or animals.
Attempt machine maintenance or cleaning unless the power supply plus has been removed from the supply outlet.
Fault Finding
If the vacuum cleaner stops working switch off and remove the plug from the wall before investigating where the fault lies.
If the vacuum cleaner has a blockage and will not pick up material, switch off and remove the plug from the wall. Check if the float valve has operated, this will shut off the suction and the pitch of the vacuum motor will change. Remove the power head and float cage and empty the waste out of the container, if the container is empty check that the floor tool, wands and hose are not blocked.
After use always inspect the machine for damage.
Data
CV / CVD 570
Motor
CV 570
CVD 570
1060 W
1060 W x 2
CV 570
CVD 570
CV 900
CVD 900
CV 900
CVD 900
NUMBER
207124
207124
207126
502988
Motor
1060 W
1060 W x 2
AirFlo
(motor only)
49 L/sec
98 L/sec
Capacity
Wet/dry
13 Ltrs
13 Ltrs
Suction
2400
2400
Size
415x415x645mm
AirFlo
(motor only)
49 L/sec
98 L/sec
Capacity
Wet/dry
30 Ltrs
30 Ltrs
Suction
2400
2400
Size
490x800x880mm
ITEM
CARTRIDGE FILTER
(H10) CARTRIDGE FILTER
MESH FILTER
FLOAT ASSEMBLY
Cleaning
Range
26.8m
26.8m
Weight
16.3 Kgs
18.5 Kgs
Class
II
Sound Pressure (LpA)
Uncertainty (KpA)
73.6-79 dB (A)
0.2 dB
CV / CVD 900
Cleaning
Range
Class
26.8m
26.8m
Weight
II
25.2 Kgs
27.7 Kgs
Sound Pressure (LpA)
Uncertainty (KpA)
73.6-79 dB (A)
0.2 dB
Spare Parts
NOTES
REPLACEMENT ITEM
ACCESSORY ITEM
REPLACEMENT ITEM
REPLACEMENT ITEM
Wiring Diagram
14” CV 570 / 900 - 240V /120V
14” CVD 570 / 900 - 240V /120V
Notes
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
........................................................................................................
Distributed by
Numatic International Limited, Chard,
Somerset, TA20 2GB
Telephone: 01460 68600
Fax: 01460 68458
UNITED KINGDOM: www.numatic.co.uk GERMANY: www.numatic.de
SWITZERLAND: www.numatic.ch FRANCE: www.numatic.fr
NETHERLANDS: www.numatic.nl SOUTH AFRICA: www.numatic.co.za
PORTUGAL: www.numatic.pt SPAIN: www.numatic.es
Specification subject to change without prior notice www.numatic.co.uk © Numatic International Limited
Subject to change without prior notice. Numatic International Limited 244360 09/17 (A05)
