Advertisement
Advertisement
February 2010
701P30730
Xerox ® Wide Format Stacker HS
User Guide
©2010 Xerox Corporation. All rights reserved. Xerox, the sphere of connectivity design, and Xerox
®
Wide Format Stacker
HS, are trademarks of Xerox Corporation in the United States and/or other counties.
Printed in the United States of America.
Changes are periodically made to this document. Changes, technical inaccuracies, and typographic errors will be corrected in subsequent editions.
Document Version: February 2010
Table of Contents
It’s Illegal
In the USA
FCC Compliant
In the USA
Identifying the Parts on the Stacker..............................................................5
Location of Stacker Serial Number
.................................................................................. 6
Stacker Operation
.................................................................................................................... 6
Stacker Jam Clearance
Stacker Relocation
Technical Data and Specifications
.................................................................................. 9
Xerox Wide Format Stacker HS
User Guide i
ii Xerox Wide Format Stacker HS
User Guide
About This Guide
It’s Illegal
In the USA
It is against U.S. law to copy copyrighted material without permission of the copyright owner unless the copying falls within the “Fair Use” library reproduction rights of the copyright law.
Further information on these U.S. provisions may be obtained from the Copyright Office,
Library of Congress, Washington, D.C. 20550, or telephone the Copyright Office at (202) 707-
9100 and ask for circular 21. Copying other items may be prohibited. If you have any questions seek legal advice.
FCC Compliant
In the USA
Class A
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communication. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at their expense.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user may find the following booklet prepared by the Federal
Communications Commission helpful:
How to Identify and resolve Radio-TV Interference Problems
Stock Number: 004-000-00345-4.
Xerox Wide Format Stacker HS
User Guide
1
1
Introduction
Congratulations on acquiring your new Stacker.
This User Guide provides information that is needed to operate the Stacker.
The information below is needed when you call your Xerox support experts.
1.
Customer Account Number: _______________________________
2.
Stacker Serial Number: ___________________________________
To locate the Stacker Serial Number, refer to page 7.
3.
Printer Serial Number: ____________________________________
To locate the Printer Serial number, refer to the Printer User Guide.
Note
All service calls should be reported under the printer serial number.
For Service: 1-800-822-2979
A Customer Service Representative will assist you in keeping your stacker operational and, if required, will arrange for a Customer Service Engineer to visit your stacker and restore the performance.
Purchase of Other Equipment:
Call a local Marketing Representative. They will assist you in determining and ordering other office equipment that will further increase your productivity.
Local Marketing Representative phone number.
_____________________________________
2 Xerox Wide Format Stacker HS
User Guide
Safety Notes
Your stacker has been designed and tested to meet strict safety requirements. These include safety agency examination and approval, and compliance to established environmental standards. Please read the following instructions carefully before operating the Stacker.
NOTE: Refer to Instructions as needed to ensure the continued safe operation of your stacker.
FOLLOW all warnings and instructions marked on or supplied with the product.
UNPLUG the stacker from the wall outlet before cleaning. Always use materials supplied or approved by Xerox. Use of other materials may result in poor performance and could create a hazardous situation.
DO NOT use aerosol cleaners
NEVER use supplies or cleaning materials for purposes other than what they were intended.
Keep all supplies and materials out of reach of children.
DO NOT use the stacker near water, wet locations, or outdoors.
WARNING
The Copier must be grounded.
THIS PRODUCT is equipped with a 3-wire grounding-type plug (i.e., a plug having a third grounding pin) and an additional safety device. This plug will only fit into a groundingtype power outlet. This is a safety feature. To avoid risk of electric shock, contact your electrician to replace the receptacle if you are unable to insert the plug into the outlet.
Never use a ground adapter plug to connect the copier to a power source receptacle that lacks a ground connection terminal.
THIS STACKER should be operated from the type of power source indicated on the marking label. If you are not sure of the type of power available, consult your local power company.
IF AN EXTENSION CORD is used with this stacker; ensure that the total of the ampere ratings of the products plugged into the extension cord does not exceed the extension cord ampere rating. Also, make sure that the total amperage of all products plugged into the wall outlet does not exceed the outlet protection.
DO NOT install the stacker in direct sunlight, a high humidity or dusty environment.
DO NOT install the stacker where the floor or base is unstable. The stacker may fall, causing personal injury and/or serious damage to the stacker.
NEVER spill liquid of any kind on the stacker.
Xerox Wide Format Stacker HS
User Guide
3
DO NOT allow anything to rest on the power cord. Do not locate this stacker where people will step on the cord.
NEVER remove any covers or guards that require a tool for removal. There are no operator-serviceable areas within these covers.
THE POWER SUPPLY CORD is the disconnect device for this stacker. Ensure that installation is near the outlet and is easily accessible.
NEVER attempt any function that is not specified in this User Guide or directed by an authorized Xerox representative.
UNPLUG this stacker from the wall outlet and refer servicing to qualified service personnel under the following conditions:
When the power cord is damaged or frayed.
If liquid has been spilled into the product.
If the stacker has been exposed to rain or water.
If the stacker is producing unusual noises or odors.
If the stacker has fallen or the cabinet has been damaged.
The safety feature has been activated for a second time
The stacker still does not work, or continues to malfunction, after following the procedures in this User Guide.
If you need additional safety information concerning the copier or materials supplied by
Xerox, you may call the following toll-free number: 1-800-828-6571 .
4 Xerox Wide Format Stacker HS
User Guide
2
Identifying the Parts on the Stacker
Xerox Wide Format Stacker HS
User Guide
5
Stacker Jam Clearance
The paper fed from the printer will be either cut or uncut.
CAUTION
To ensure the safety of the user, be aware during jam clearance that the surface will be hot,
Cut
In order to clear a jam in the stacker, lift the Upper Panel Assembly and clear any paper
(Figure 2). If the jam still exists, push down on the release lever and move the stacker away from the printer (Figure 1). Clear any visible paper from the paper path.
Uncut
Cut the paper in the printer (refer to the printer user guide) and follow the above procedure.
Xerox Wide Format Stacker HS
User Guide
7
Stacker Relocation
The stacker cannot be moved except by a DRC rigger.
To ensure that the stacker operates reliably after moving it to a new location, consider the following guidelines:
The new location must provide minimum clearance around the stacker. These clearances are shown in the diagram below.
The flooring in the new location must be adequate to support the weight of the stacker and be reasonably level.
The new location must be well ventilated and maintain an even temperature. Extreme temperature or humidity changes can affect the stacker.
Power source receptacles must be properly grounded.
8 Xerox Wide Format Stacker HS
User Guide
Technical Data and Specifications
Specifications
Dimensions
Weight
Width: 34”
(864mm)
Depth: 41”
(104.1mm)
Height: 28.5
(724mm)
108lbs. (49kg)
Paper Size
Stacker Capacity
Electrical
36 x 48” (914mm x
1219mm) Max.
200 sheets of plain paper with minimal scatter
Current Service
Power Supply
Frequency
60W
500 plain paper sheets Max.
3 Amps or more
110V – 240V
50/60Hz
Power Consumption
57.5” (146mm) w/paper supports extended
10°C - 32°C
Temperature 50°F - 90°F
Humidity 20 – 85%
Noise Level 57dB Max.
(during operation)
Xerox Wide Format Stacker HS
User Guide
9
Advertisement