Multiplex Drain Assembly Repair Kit Installation Guide

Multiplex Drain Assembly Repair Kit Installation Guide
Foodservice Group
Multiplex Beverage Equipment Installation Instructions for
Drain Assembly Repair Kit for Dispensing Towers
P.N. 00203993
Install drain assembly repair kit as shown in figure 1 and 2.
Side Drain
Bottom Drain
Do not over tighten.
Tighten nut until
O-rings start to
compress and turn nut
one (1) full turn.
Do not over tighten.
Tighten nut until
O-rings start to
compress and turn nut
one (1) full turn.
Figure 1
Caution: To Avoid Serious Injury
Important: Read the following warnings before beginning an
installation. Failure to do so may result in possible death or
serious injury.
Figure 2
DO Store CO2 cylinder(s) in well ventilated areas.
DO NOT
Throw or drop a CO2 cylinder. Secure the cylinder(s)
in an upright position with a chain.
DO NOT
Connect the CO2 cylinder(s) directly to the product
container. Doing so will result in an explosion causing possible death or injury. Best to connect the
CO2 cylinder(s) to a regulator(s).
DO NOT
Store CO2 cylinders in temperature above 125°F
(51.7°C) near furnaces, radiator or sources of heat.
DO NOT
Release CO2 gas from old cylinder.
DO NOT
Touch Refrigeration lines inside units, some may
exceed temperatures of 200°F (93.3°C).
DO Adhere to all National and Local Plumbing and Electrical Safety Codes.
DO Turn “off” incoming electrical service switches
when servicing, installing, or repairing equipment.
DO Check that all flare fittings on the carbonation
tank(s) are tight. This check should be performed
with a wrench to ensure a quality seal.
DO Inspect pressure on Regulators before starting up
equipment.
DO Protect eyes when working around refrigerants.
Notice: Water pipe connections and fixtures directly connected
to a potable water supply shall be sized, installed and
maintained in accordance with Federal, State, and Local codes.
DO Use caution when handling metal surface edges of
all equipment.
DO Handle CO2 cylinders and gauges with care. Secure
cylinders properly against abrasion.
Manitowoc Beverage Equipment
2100 Future Drive Š Sellersburg, IN 47172-1868
Tel: 812.246.7000, 800.367.4233 Š Fax: 812.246.9922
www.manitowocbeverage.com
In accordance with our policy of continuous product development and improvement,
this information is subject to change at any time without notice.
EI203993 Revision B (KAK) 7 June, 2001
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement