CY

CMY

CM

MY

K

C

M

Y

SAFETY FIRST!

For your continued safety and to reduce the risk of injury or electric shock, please follow all the safety precautions listed below.

• Read all the instructions carefully before using the appliance and keep them for future reference.

• Retain the manual. If you pass the appliance onto a third party make sure to include this manual.

• Check that the voltage marked on the rating label matches your mains voltage.

• Consult your dealer if you are ever in doubt about the installation, operation or safety of your appliance.

• Do not remove any fixed cover as this may expose dangerous voltages.

• Do not allow any electrical appliance to be exposed to dripping or splashing.

• To protect against electrical shock, do not immerse the mains cable, mains plug, or any part of the appliance in water or other liquids.

• Make sure the dust bag is properly installed before use.

• Never vacuum up water or any other liquids. Never vacuum up flammable substances and do not vacuum up ashes until they are cold.

• Never use the appliance without the motor protection filter. This damages the motor and shortens the life of the appliance.

• If a blockage is found in the brushes, hoses or tubes, it should be removed before use.

• Store and use the appliance well away from heat sources such as radiators or gas / electric fires.

• Do not run over the mains cable with the appliance.

• Close supervision is necessary when any appliance is used by or near children.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instructions concerning the use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• Do not point the hose, tube or any other accessory at the eyes, ears or mouth during operation.

• Unplug the appliance from the mains socket when it is not in use and before replacing the dustbag or filter.

• Allow the appliance to cool completely before cleaning or storing.

• Do not use the appliance for other uses than its intended use.

• The use of accessories not recommended by the appliance manufacturer may cause injuries.

• Do not use the appliance outdoors.

• Do not operate an appliance with a damaged mains cable or mains plug, or in an abnormal state. If the mains cable is damaged it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.

• Do not continue to operate the appliance if you are in any doubt about it working normally

(e.g. abnormal noise, smell, smoke), or if it is damaged in any way - switch off, withdraw the mains plug and consult your dealer.

• Any maintenance and repair must be handled by a professional technician. Do not try to repair by yourself.

141mm

SPECIFICATIONS

Supply voltage : 230V~50Hz

Power input : 1200W (1400 MAX)

Dust capacity : 1.5L

We continually strive to improve our products. Specifications may change without prior notice.

Visit Partmaster.co.uk today for the easiest way to buy electrical spares and accessories. With over 1 million spares and accessories available we can deliver direct to your door the very next day. Visit www.partmaster.co.uk or call 0844 800 3456 (UK customers only) Calls charged at National Rate.

This symbol on the product or in the instructions means that your electrical and electronic equipment should be disposed at the end of its life separately from your household waste. There are separate collection systems for recycling in the EU. For more information, please contact the local authority or your retailer where you purchased the product.

GB-4

BAGGED VACUUM CLEANER

INSTRUCTION MANUAL

C14BVR10

Thank You

141mm

for purchasing your new Currys Essentials Bagged Vacuum Cleaner.

We recommend that you spend some time reading this instruction manual in order to fully understand all the operational features it offers.

Read all the safety instructions carefully before use and keep this instruction manual for future reference.

UNPACKING

Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.

The following items are included:

• Main Unit • Hose

(P.N.: CH846-HS)

• Telescopic Tube

(P.N.: CH846-TB)

• Dust Bag Holder x 1

(P.N.: CH846-DBH)

• Dust Bag x 3

(P.N.: CH846-DB)

• Combination Nozzle

(P.N.: CH846-CN)

• Floor Brush

(P.N.: CH846-HF)

• Instruction Manual

(P.N.: C14BVR10-003)

DSG Retail Ltd • Maylands Avenue • Hemel Hempstead

Herts • HP2 7TG • England

GB-5

(P.N. C14BVR10-003)

If items are missing or damaged, please contact Partmaster (UK only).

Tel: 0844 800 3456 for assistance.

CY

CMY

CM

MY

K

C

M

Y

9

C14BVR10_IB_110718.pdf 2 7/18/11 10:35 AM

141mm

PRODUCT OVERVIEW

1

2

18

4

19 20

3

5

12

17

21

1

3

6

5

22

7

8

10

15

16

11

13

14

11

12

13

14

8

9

10

5

6

7

3

4

1

2

18

19

20

21

15

16

17

22

23

Hose connection opening

Dustbag-full indicator

ON/OFF button

Cord rewind button

Dust cover

Motor protection filter

Dustbag

Dustbag holder

Grill

Exhaust filter

Handle

Clip

Mains plug

Rear wheel

Handgrip

Wheel

Combination nozzle compartment

Handgrip of hose

Hose connector

Hose

Tubes

Hard floor brush

Combination nozzle

GB-1

23

3

7

9

11

10

GB-2

12

141mm

2

4

6

8

138mm

PREPARATION BEFORE USE

1. To connect the hose, insert the hose connector into the hose connection opening until you hear a ‘click’ sound (Fig 1).

2. To connect the tubes to the handgrip of the hose, insert the narrow section into the wider section while turning a little (Fig 2).

3. Connect the two tubes together, insert the narrow section into the wider section while turning a little (Fig 3).

4.

Connect a nozzle/brush suitable for the floor type to be cleaned. The hard floor brush can be used with brush strips lowered or raised (Fig 4). You may also connect the combination nozzle to vacuum corners, slots or grooves. It can also be used as a brush nozzle by turning the brush out in the direction of the arrow. It is stored in a compartment at the rear of the vacuum cleaner.

OPERATION

1. Hold the mains plug and pull the retractable mains cable out of the vacuum cleaner. Connect it to the mains socket. The YELLOW mark indicates the ideal length to extend the cable. Do not extend the mains cable beyond the RED mark which indicates the maximum length.

2. Press the ON/OFF button on the top of the vacuum cleaner to turn it on.

3. To move the vacuum cleaner from room to room, you can unplug and carry it by either the handle or the handgrip. Never use the mains cable to pull the vacuum cleaner.

POWERING OFF AND STORAGE

1. Press the ON/OFF button on the top of the vacuum cleaner to turn it off and then remove the mains plug from the mains socket.

2. Press the cord rewind button to rewind the retractable mains cable.

3. Put the vacuum cleaner in an upright position and attach the lower tube to the clip on the vacuum cleaner (Fig 5).

REPLACING THE DUSTBAG

Replace the dustbag when the dustbag-full indicator turns red.

Always unplug the vacuum cleaner from the mains socket before replacing the dustbag.

1. Open the dustbag compartment cover (Fig 6).

2. Take out the dustbag holder and gently remove the full dustbag from the holder with the dustbag’s opening facing upwards (Fig 7).

3. Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder (Fig 8).

4. Relocate the dustbag holder back into the lower housing and close the dustbag compartment cover until you hear a ‘click’ sound (Fig 9).

The dustbag compartment cover cannot be closed unless the dustbag is installed properly.

USING A REUSABLE DUSTBAG

You can use a reusable cotton dustbag (not supplied) instead of the paper dustbag. To remove and replace a cotton dustbag, simply follow the instructions for replacing the paper dustbags.

CLEANING THE MOTOR PROTECTION FILTER

The motor protection filter should be cleaned twice a year, or when it appears to be visibly clogged.

Always unplug the vacuum cleaner from mains socket before replacing the filter.

1. Open the dustbag compartment cover (Fig 6).

2. Take out the dustbag holder and remove the motor protection filter (Fig 7 & Fig 10).

3. Shake out the dust accumulated on the filter into a dustbin.

4. Relocate the filter and dustbag holder back into the lower housing.

5. Close the dustbag compartment cover till you hear a ‘click’ sound (Fig 9).

CLEANING THE EXHAUST FILTER

Always unplug the vacuum cleaner from mains socket before replacing the filter.

1. Unclip the grill and take out the exhaust filter (Fig 11 & Fig 12).

2. Shake out the dust accumulated on the filter into a dustbin.

3. Relocate the filter and the grill.

GB-3