IMALENT Shark DDT40 flashlight User manual

Below you will find brief information for flashlight DDT40. The DDT40 offers a multi-functional touchscreen floodlight with a built-in digital compass, temperature sensor & remote control capabilities in 1 light. It comes with 4 spot Cree XM-L2s at the front outputting 4000 lumens along with 2 more Cree XP-Ls LED at the sides that give 360 degree lighting that outputs 1,180 lumens. This is the craziest light from Imalent that we have seen. Uses 4 x 18650 batteries with a powerful beam that goes up to 450 meters.

PDF Download
Document
IMALENT DDT40 Flashlight User Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Multi-functional touchscreen floodlight
  • Built-in digital compass
  • Temperature sensor
  • Remote control capabilities
  • 4 spot Cree XM-L2s
  • 2 Cree XP-Ls LED
  • 4 x 18650 batteries
  • Powerful beam that goes up to 450 meters

Frequently asked questions

Unscrew the tail cap. Insert 4pcs 18650 rechargeable Li-ion batteries or 8pcs CR123A (3.0V) batteries into the flashlight with the positive (+) towards the head. Replace the battery tube.

With the light on (spot or flood), press and hold the upper button '+' on the top of the touch screen, the brightness will increase itself, while press and hold the bottom button '-' on the touch screen, the brightness will decrease itself, release your finger at any output you need, will save it.

With the light on, put the remote controller towards any receiver on both sides of the flashlight head, press power switch on the remote controller to turn on and turn off the light, pressing mode button to transfer the light from main spot light to flood light to red light, press button to increase the brightness while press button to decrease the brightness,release your finger at any output level will save it.
Preparing document for printing…
0%