®
Lenco
Stereo portable CD player
with cassette
SCR90
/ \
CLASS 1 LASER PRODUCT
| CAUTION
CLASS 1 LASER PRODUCT INVISIBLE LASER RADIATION
APPAREIL A LASER DE CLASSE 1 WHEN OPEN AND INTERLOCKS
PRODUCTO LASER DE CLASE 1 DEFEATED.
AVOID EXPOSURE TO BEAM
| This product contains a low power laser device.
Warning: Do not touch the lens,
DO NOT THROW BATTERIES IN FIRE !
PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
. Do not use the unit in places which are extremely hot, cold, dusty, or humid.
. Place the unit on a flat and even surface.
. Do not restrict the air flow of the unit by placing it in a place with poor air flow, by covering it with a cloth,
or by placing it on a carpet.
ON SAFETY
. When connecting and disconnecting the AC cord, grip the plug and not the cord itself. Pulling the cord
may damage it and create hazard.
. When you are not going to use the unit for a long period of time, disconnect the AC power cord.
ON AC VOLTAGE
. Before use, check that the rated voltage of your unit matches your local voltage.
ON CONDENSATION
. When left in a heated room where it is warm and damp, water droplets or condensation may form inside
the CD player.
. When there is condensation inside the unit, the unit may not function normally.
. Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit
before use.
* Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation,
* Ensure that the ventilation is not impeded by covering the ventilation openings with items,
such as newspapers, table-cloths, curtains, etc..
Do not place naked flame sources, such as lighted candles on the apparatus.
Take attention to the environmental aspects of battery disposal.
Use the apparatus only in moderate climates (not in tropical climates).
Do not expose the apparatus to dripping or splashing.
Do not place objects filled with liquids, such as vases, on the apparatus.
Should any trouble occur, disconnect the AC power cord and refer servicing to qualified personnel.
* * * * *
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightening flash with ATTENTION : To reduce the risk of The exclamation point within
arrowhead symbol within the electric shock, do not remove the cover. the triangle is a warning sign
triangle is a warning sign ; alerting the user of important
alerting the user of There are no user serviceable parts instructions accompanying
the unit. qualified personnel.
Ín case of misfunction due to electrostatic discharge the apparatus has to be reset by disconnecting it from
mains supply.
| | SCR90-LENCO-ENG-TCD06.p65 2 12/8/2005, 12:43 PM
ю 0 м О о В 0 № ~~
TELESCOPIC ANTENNA
MODE SWITCH
CARRYING HANDLE
CD DOOR
OPEN / CLOSE CD BUTTON
CD BACK BUTTON |<<
CD PLAY / PAUSE BUTTON pI
DIAL SCALE
FM STEREO LED INDICATOR
CD PROGRAM BUTTON
CD REPEAT BUTTON
BBS SWITCH
CD NEXT BUTTON >>]
CD STOP BUTTON Ш
CASSETTE PLAY «€
| | SCH90-LENCO-ENG-TCD06.p65 3
GB 1
e
16.
17.
18.
19.
20.
21.
23.
24.
25.
26.
27.
28.
CASSETTE REWIND №»
SPEAKER
BATTERY COMPARTMENT
CASSETTE DOOR
CASSETTE F.-WD «<
CASSETTE STOP/EJECT M4
CASSETTE PAUSE El
CD DISPLAY
FUNCTION SWITCH
TUNING CONTROL
AC SOCKET
VOLUME CONTROL
PHONES JACK
12/8/2005, 12:43 PM
USING HOUSE CURRENT
Before use, check that the rated voltage
of your unit matches your local voltage.
USING BATTERIES
Disconnect the AC power cord from the AC inlet of the
unit. Battery power is cut automatically by the cord
while it is connected.
battery door
ADJUSTING THE SOUND
VOLUME
— 7
MIN. МАХ,
BASS BOOST
LISTENING TO THE RADIO
1. Set to RADIO
FUNCTION
RADIO
3. Tune in to a station.
TUNING
UIT
О
| | SCR90-LENCO-ENG-TCD06.p65 4
—"
To AC outlet
When the volume decrease, or the sound distorts,
replace all of the batteries with new ones.
Insert 8 UM-2 ( size C ) batteries.
TO ADJUST THE VOLUME
FOR PRIVATE LISTENING
Plug in headphones (23.5 mm stereo mini-plug) to the
PHONES jack.
When headphones are plugged in, the speakers are
automatically disconnected.
Press the BASS BOOST button to increase or reduce
the bass.
2. Select a MODE.
MODE
FM ST. FM MONO
4. Adjust the sound.
VOLUME
CITES
Were ss
MIN. MAX.
GB 2
6 12/8/2005, 12:43 PM
F
A
| | SCR90-LENCO-ENG-TCDO06.p65 5 ; 12/8/2005, 6:00 PM | |
NOTE: 1. FM stereo LED indicator lights if receive FM stereo broardcast and the MODE switch set on "FM
STEREO".
2. When too much noise is heard during FM STEREO reception, set MODE switch to FM mono,
AFTER LISTENING
Set the FUNCTION selector to OFF.
COMPACT DISC PLAYBACK
1. Seto CD FUNCTION 2. Open the CD door by pushing Open/ Close CD
CD button. :
3, Insert a disc with the label side facing up.
4. Close the disc holder, 5. Press the Play/Pause PI button. a
The disc will rotate and the total tracks of the " PLAY p>" & Track number " 1 " will be shown.
disc will show on
the display. :
CD display
Li
TO INTERRUPT PLAYBACK
Press the Play/Pause PI button and the word " PLAY
B>" will be flashed. Press the button again to resume
playback.
TO STOP PLAYBACK
Press the STOP button and the display shows the
total tracks of the disc.
oe
CD display
CD display
GB3
TO SKIP TO THE BEGINNING OF A TRACK
. Press either one of the [44 >> skip buttons according to the desired skip direction.
. Play/back resumes from the selected track.
° When the (44 button is pressed once during play, the previous track starts again.
. When the ppp] button is pressed once during play, the next track plays.
SEARCHING FOR A PASSAGE WITHIN A TRACK
, Keep the [O or DD] button pressed during playback, and release the button as soon as you recognise
the desired passage. Then normal CD playback will resume from this point.
CD display
REPEAT PLAYBACK
This function allows a single track or all tracks on a disc to be played repeatedly.
TO REPEAT THE SAME TRACK TO REPEAT THE WHOLE DISC
Press the REPEAT button once during playback, the Press the REPEAT button twice until * REPEAT ALL *
CD display will indicate " REPEAT 1". displays.
" REPEAT 1"
" REPEAT ALL"
CD display CD display
TO CANCEL REPEAT PLAYBACK FUNCTION
Press the REPEAT button again until * REPEAT 1 " or
“ REPEAT ALL " disappears from the display.
CD display
GB4
| | SCR90-LENCO-ENG-TCD06.p65 6 e 12/8/2005, 12:43 PM
PROGRAM PLAYBACK
PROGRAMMED PLAYBACK
Programmed playback enables tracks on a disc to be played in the desired order. Up to 20 tracks can be programmed.
1.
2
3
4
5.
6.
7
8.
N
Press the " PROGRAM " button.
Press the " F.SKIP " and " B.SKIP " buttons to select the desired track number,
Press " PROGRAM " button again to memorize the track.
Repeat steps 2 and 3 until all desired tracks are programmed.
Press the " PLAY/PAUSE " button to start. " PROGRAM " is flashing on the CD display.
Press " STOP " button to stop programmed playback.
Press " PROGRAM " and " PLAY/PAUSE " buttons to resume programmed playback.
Open the CD door or turn off the CD player to clear the programmed memory.
ote : Programming can only be made when the player is in stop mode.
"PROGRAM"
CD display
Note on CD-R/RW discs
Because of non-standardized format definition/ production of CD-R/RW, playback quality and performance are not
guaranteed.
Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions, such as PC performance,
writing software, media ability, etc.
Do not attach a seal or label to either side of the CD-R/RW disc. It may cause a malfunction.
1.
2.
SE
TAPE PLAYBACK
Set to TAPE 3. Press the « PLAY button. PLAY
FUNCTION :
ТАРЕ ©
i , REW PLAY
| 4
TO STOP PLAYBACK
Press the STOP / EJECT button.
Insert the cassette.
TO INTERRUPT PLAYBACK
Press the PAUSE button.
To resume play, press the PAUSE button again.
TO FAST WIND
Press the REWIND or F.FWD button. Press the
STOP/EJECT button to stop winding at the desired
position.
СВ 5
| | SCR90-LENCO-ENG-TCDO6.p65 7 12/8/2005, 6:11 PM
MAINTENANCE
CLEANING CD
If the CD skips or will not play , the disc may need cleaning . Before
playing, wipe the disc from the centre out with a cleaning cloth. After
playing, store the disc in its case.
CLEANING THE TAPE HEADS
To maintain optimum sound quality, clean the playback heads (a)
,erasure head (b), pinch rollers (c), and capstans (d) regularly (every
10 hours of use ). Use a colton swab lightly moistened with cleaning
fluid or denatured alcohol.
o
Ja
AU]
a
o
SPECIFICATIONS
CASSETTE SECTION
Track format:
Erasing system:
Tape speed:
F.F. & REW time:
Frequency response:
CD SECTION
Channels:
S / N ratio:
Wow & Flutter:
Sampling frequency:
Quantization:
Pick up light source:
Pick up wave length
RADIO SECTION
Tuning ranges:
Antennas:
GENERAL
Output power:
Power consumption:
Speaker:
Phones jack:
Power source:
Dimensions:
Weight
CLEANING THE CD LENS
Ifthe CD lens is dusty, clean it with a brush-blower. Blow several times
on the lens and remove the dust with the brush. Finger prints may be
removed with a cotton swab moistened with alcohol.
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly wiping with
a soft cloth.
IMPORTANT NOTE
If an abnormal display indication or an operating problem occurs,
disconnect the AC power cord and remove the batteries. Wait at least
5 seconds, then reconnect the AC power cord or reinstall the batteries.
WARNING
Should the CD door be opened before the reading of the CD completed,
a jamming noise may occur. This is resolved by closing the CD door.
2 track stereo
Magnetic erase 6 poles
4.75 cm / sec.
170 sec. (F-60 tapes)
125 Hz - 8000 Hz (Normal tape)
2 channels
60 dB
undetectable
44.1 kHz 8 x over sampling
1 bit DA converter
Semi - conductor laser
790 nm
FM 87.5 - 108 MHz
FM Rod antenna
1.2W + 1.2W (RMS)
13W
3" 8 OHM
3.5MM
AC: 230V / 50Hz
(INDICATED ON THE REAR OF THE UNIT)
DC: 12V 1.5 x 8 UM2 / R14 / "C" SIZE
290(L) x 273(D) x 163(H)mm
2.3KGS
Due to continuing improvement, the features and the design are subject to change without notice.
Where to place the item :
Today's furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive
range of cleaning products. Therefore, the possibility that some of these substances contain components that react
adversely to the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the
appliance can cause discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.
If at any time in the future you should need to dispose of this product please note that: Waste electrical
products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice. (Waste Electrical and Electronic
Equipment Directive)
GB 6
o
| | SCR90-LENCO-ENG-TCD06.p65 8 12/8/2005, 12:43 PM |
">