Dunlop CSP105 MXR '75 VINTAGE PHASE 45 Manual

Dunlop CSP105 MXR '75 VINTAGE PHASE 45 Manual
92503009392revA
Operation
Manual
CSP105 ‘75 VINTAGE PHASE 45
DESCRIPTION
• Hand-wired circuit board built with
original-spec 1975 components
• Original high-quality Switchcraft
Input/Output jacks and Carling
bypass switch
• Hand-selected FETs, matched to
produce deep and rich phasing
• All analog circuitry for warm
analog tone
POWER
The MXR Phase 45 is powered by one
9 volt battery, accessed by removing the
bottom plate of the pedal.
Controls
• Footswitch toggles effect on/bypass
• Speed knob regulates overall effect rate
DIRECTIONS
• Run a cable from your guitar to the
Vintage Phase 45’s Input jack and run
another cable from the Vintage Phase
45’s Output jack to your amplifier.
• Set the Vintage Phase 45’s Speed
control knob to the 12 o’clock position.
• Turn the effect on by depressing
the footswitch.
• Rotating the Speed knob in a clockwise
motion results in a faster phase effect,
counterclockwise for a slower effect.
SPECIFICATIONS
Input Impedance
Output Impedance
Max Input Level
Signal to Noise Ratio*
Phase Shift Range
Bypass
Current Draw
Power Supply
500 kΩ
5 kΩ
-5 dBV
> 96 dB
360°
Hardwire
< 1 mA
9 volt battery
*All controls at mid position, A-weighted, VREF = 1VRMS
Sample Settings
“DIAMOND LUCY”
60’S PSYCHEDELIC
“PHASE OF SIGHS”
70’S STONER
“GRAFFITI PHYSICALLY”
CLASSIC ROCK
“NASHVILLE”
CLASSIC COUNTRY
4:00
1:00
9:30
1:00
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement