Sheffield PLA1327F Water Cooler Filter 3 Pack Instruction Manual

Add to my manuals
1 Pages

advertisement

Sheffield PLA1327F Water Cooler Filter 3 Pack Instruction Manual | Manualzz

PLA1327 Replacement Filter

1: SOAK THE WATER FILTER

Remove the replacement filter from its packaging, place in a bowl or sink and fully cover the filter with water.

Soak the filter for at least 30 minutes and then rinse off with cold clean running water.

2: CHECK THE RUBBER STOPPER

Ensure the rubber stopper as shown in Fig. A is inserted correctly as shown in Fig. B

A B

3: ASSEMBLE THE CHILLER UNIT

Insert filter into the upper water tank and ensure that it is fully seated. Place the Base water tank and the

Upper water tank onto the Chiller unit.

4: FLUSH WATER

Fill the Upper water tank with cold clean water.

Operate the taps to circulate the water and to flush it through the system to remove any black carbon dust, repeat as many times as necessary.

NOTE: The discarded water can be used on plants without harm.

5: OPERATE

Fill the Upper water tank with cold clean water again and switch the Chiller “ON” at the back of the unit.

Both the “COLD” indicator (Blue) and “POWER” indicator (Yellow) will illuminate.

Allow approximately 30-40 minutes for the water to chill.

When the “Cold” indicator turns off the water in the internal tank is fully chilled.

PLEASE NOTE: You may notice some fine black carbon dust coming out or the water filter. These are actually activated carbon from the filter which are used to purify the tap water. The black carbon dust in the water is non-toxic and will happen on all new filters and when the water is flushed through the first couple of times .

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement