Jueapu GV40 GPS Tracker User Manual

Add to My manuals
1 Pages

advertisement

Jueapu GV40 GPS Tracker User Manual | Manualzz
 1.Overview 2.Device appearance 4.LED indications - Under the dash board below the front windshield; 8.Operations 87 Functions 8.3 Server setting
1.1 Features Green LED(GSM indicator ) = H- - In the parcel shelf in the rear; The following operation can be achieved through the terminal Default platform is www.tracksolid.com
LTE & WCDMA & GSM = ) platform or APP provided by the dealer. To connect to other platform, please send the SMS
- WiFi hotspot POWER Status Definition Nano - In the front bumper (non-material face), make sure the = * 8.1 SOS b command to change the DNS or server IP:
- ACC detection for ignition status 0.3s ON, 0.3s OFF GSM initializing xl device does not get wet; ° number DNS : SERVER,1,DNS,Port,0#
IP65 f 9 . . ; E.g: SERVER,1,gpsdev.tracksolid.com,21100,0#
+ P65 water proo T 1s ON, 3s OFF GSM normal . . - Under the wiper version (non-metal), make sure the (1) Add SOS number via SMS command IP: SERVER 0 IP Port 0#
* Remote cut-off (petrol/power) = | GSM : 6.Device Installation device does not get wet: Send SMS command: SOS,A,numberl,number2,number3 # > ити ОГ,
- Multiple alerts 7 0.1s ON, 3s OFF GPRS online ; | g ; (A means add number). It will reply “OK” after set successfully.
OFF No GSM or SIM card You need to choose somewhere that it won't be found, _ on - fi ; 3 SOS numbers can be set. If set successfully, the terminal will
1.2 Specifications because the whole point of fitting covert GPS vehicle non covert installation fix the device on the dash герм ‘ок. у 8.4 Center number
° tracker is the secrecy element. Gard below windshield. e.g. SOS,A,13510****60,135116****6,136126****84t
ali = a - ' Set center number :
. Red LED ( Power indicator (set all 3 SOS numbers)
GSM: 850/900/1800/1909 MHz GPS ( ) 1. Your device has built-in GSM antenna and GPS antenna. SOS,A, 13510****60# (set the first SOS number) CENTER A.phone humber#
Frequency WCDMA: Liars pg, MZ Status Definition During installation, please make sure the receiving side 7.Wiring SOS,A, ,135116****6# (set the second SOS number) CENTER D# `
(B1/B2/B5/B8) 0.3s ON. 0.3s OFF Low batte face is up ; any high power devices such as reversing | a SOS,A, , 136126****8# (set the third SOS number)
LTE:B1/B2/B3/B4/B5/B7/B8 - — y radar, anti-theft device or communication equipment 1. The standard voltage is 9V-36V, the red wire is the 3 load exe e d larl
Chipset : U-blox 7020 1s ON, 3s OFF Work normally would affect the signal of the device. positive, the black wire is the negative. (2) Delete SOS Numbers 5 Up oa positioning ata regularly
GPS Pe: ox . . Solid Red Charging 2 he black wi d Send SMS command: SOS, D,1,2,3# Command
Frequency: GPS L1, 1575.42MHz 3.Wiring Diagram OFF No batter,/Malfunct 2. All metallic cases of the windshield will attenuate the . Connect the black wire to ground. = 2A FUSE (D means delete SOS number) TIMER T1 T2#
Location accuracy | <10 meters o battery/Malfunction signal on the tracking device. It's sim ply d ue to the Red m eg. 208 me mean delete tae Fest number T1: ranges from 0/5 - 18000 seconds, the upload interval when
o shielding effects of the metal compound of the case. ‚ В, АСС ОМ
WiFi 2.4 GHz Blue LED(GPS indicat т Black If you don’ t know the sequence number, you can also delete T1=0: no data uploaded
LED indicator GPS (blue), GSM(green), power (red) POWER AND I/O ue ( indicator ) 3. The device should be fixed into position with cable ties Yellow the number by SMS command like this: SOS,D,number# T1=5 ~ 18000 seconds (Default: T1=10)
Battery 450mAh/3.7V Status Definition or wide double-side tape. Orange 5 e.g. SOS,D,13527852360# means delete this SOS number T2: ranges from0/5 - 18000 seconds, the upload interval when
Purple:SOS+ 4 Red:DC Storage directly. о ; ACC OFF
Working 9-36V 0.3s ON, 0.3s OFF Searching GPS signal CL battery It will reply “OK” if the number is deleted successfully. T2=0: no data uploaded
voltage/current | 12VDC/76mA(12VDC); 38mA(24VDC) Black:GND Orange:ACC je Under rear windshield О 12V or 24V _ ‚то
1s ON, 3s OFF GPS positioned successfully . T2=5 + 18000 seconds (Default: T2=0)
Operating 20°C ~ 70°C White:SOS- x Yellow:Relay FF | PS si doesn’ k Under front windshield 12/24V (3) Add SOS numbers via platform
temperature с би 2 = e or coset t wor Relay or You can set SOS number via the platform or APP when device 8.6 Arming time setting
; ; oli uetooth configuration 86 30 87a 85 ;
Dimension 113(L)"51(W)"20(H)mm 9 Ignition key . Delay time for device entering arming state after the vehicle
Weight 105g Note: LED indicators will be off after 180s when ACC is OFF. — + 8.2 APN setting power is off and ACC is in low-level. In the arming state, if the
A LQ Pu Power 0-36 ° To ensure GPRS is activated, please make sure APN is alarm system, If the vehicle Battery is still not on (ACC is in low
A2 Orange ACC ACC 5.H ° = correct. You can send SMS command to set APN: — . . NDA
. Hardware Operation = Pump ‚ , level) after 3 minutes, the device will start vibration alarm.
1.3 Accessories A3 Yellow Relay Fuel/Power cut-off (1)SIM Card Pe APN command int eb PA ier) SMS format:
I I 9: interne internet” is the of carrier #
505 cable Ad Black | @ GND ¡END WE SIM card should h GPRS and SMS NOTE: The device will reply "OK" if setting successfully. The time ranges from 1 to 60 minutes, default is 10.
bl A5 Purple @ SOS + SOS (Positive) card should have access to tio an di Please pay attention to the diagram description
Power cable A6 lwhi O sos - OS (Negati Remove the cover, switch the device to OFF and insert the SIM pay g ption, Note: The APN of some countries have user name and NOTE:
— ; (egative card in correct direction. battery is 9-36V and relay remains 12V / 24V. password, you may need to send SMS command as 1. Preset SOS numbers before sending SMS alarm messages
following: APN,APN name,user name,password# and calls. 9 9
2 If there fs no need for vibration alarm, please send SMS 8.9 Restoring Oil After receiving this command, the device will reboot after 10. Warning SIM has no access to Contact network Maintenance Record
, O close It. . seconds . . lier to get GPRS
1. Via platform Battery specified by manufacturer is recommended. GPRS supp 9
8.7 Wire cut-off alarm When the alarm is off, sending recover oil commands Maintenance or service arising from any other accessories Fail to locate Е Service Date Serviced by
When the electrici ly of device | et it will manually. Device will restore oil supplying, and vehicle will 8.13 SOS is not guaranteed. y cpu, Address Contact supplier AG V hi | GPS T k
en the electricity supply of device Is cut off, it wi work normally again. ; Manufacturer assumes no responsibility for any damage caused
activate cut-off alarm. In this case, the device will send Platform account password is needed when sending oil In emergent case, press 205 fof 3 seconds to activate SOS by non-original accessories Product Mode! enicie racker
related SMS to the SOS numbers and dial the numbers in toff d Р 9 alarm. Then the device will send SOS SMS to preset SOS у 9
cutoff command. numbers and dial the numbers in a loop for 3 times till the call Do not bend or open the battery , A A
circles. 1 nobody answers, the call just pa Door cut 2. Via SMS picked up. Alarm message will also be sent to the platform. Do not immerse or burn the battery Warranty instructions and service IMEI Number U ser M an ual
off alarm data to the server. And it will send: Only center number can send the command to the device Device dis-assembly is strongly forbidden. 1.The warranty is valid only when the warranty card is properly ,
Cut off Power Alarm! <06-17 14:53> to restore oil. 8.14 Wi-Fi hotspot Nonprofessionalsbperation may cause device damage. completed, and upon presentation of the proof of purchase (Version 1.0)
http: | ” 5 2 13 E113.91 The format is: RELAY,O# consisting of original invoice indicating the date of purchase,
asp //MAPS-g009 e.com/maps?q=N22576713,E113.9165 After the command is carried out, it will receive "RELAY:OFF" Command: HOTSPOT,S,N,P# model and serial No.of the product. We reserve the right to
î refuse warranty if this information has been removed or changed
8.10 Over Speed Alarm S=ON/OFF Default: OFF (uppercase required) 11. Troubleshooting | after the original purchase of the product from the dealer,
NOTE: ° Р N=Name, 20 characters, default: last four digits of IMEI If you are having trouble with your device, try these 2. Our obligations are limited to repair of the defect or replacement
The SOS numbers should be preset, please refer to 8.1. When the car is moving over a limited speed in average in P=Password, minimum eight, default password: 11111111 troubleshooting procedures before contacting a service the defective part or at its discretion replacement of the product
a limited time period, then the device will send over professional. itself.
speed alarm SMS to user. 3. Warranty repai t be carried out by our Authorized Servi
. Problems Causes Solutions . y repairs must be carried out by our Authorized Service
8.8 Oil cut-off Loan on the over speed function, please send below 9.Platform & APP The signal waves are Centre. Warranty cover will be void, even if a repair has been Fault
command: . . . . au
1. via platform SPEED ON Time. Limited s 9.1 Login service platform unable to transmit attempted by any unauthorized service centre.
. ON, ' peed,way of alarm# ; . . Descriptions
Send oil cut-off command on platform. To make sure the Time range (Second) : 5-600s (default as 10s). Please login the designated service platform to set and when use the GPS Using the GPS tracker 4. Repair or replacement under the terms of this warranty does
security of vehicle, tracker can only indicate to cut off oil Limited s ‚ ‚ operate the device tracker in the places | in the places that have not provide right to extension or renewal of the warranty period.
в , e . peed range ( km/h): 1-255, default : 100. p . Poor signal ‚ м
when GPS is in valid position status, and the speed is less Way of alarm: 0, GPRS only; 1, SMS+GPRS; default : 1. that have poor signal | good signal condition. 5. The warranty is not applicable to cases other than defects in
than 20KM/H or in static. Platform accou nt password is Example: SPEED,ON,10,120,1# ' 9.2 Download APP reception, such as: tall material, design and workmanship.
needed when sending oil cut off command. ; ; ; ; building around or
: Means when the car 5 Will send ove 120 km/h n ao ee n Please download and install the APP in designated website, basement
2 М SMS ould ber PI вл seconds, the device will send over speed alarm to user. APP store or Google Play. 5 - т —
irstly, you should set a center number. Please refer to 8.4. . Unable to ower switch is o witch to
Only center number can send the command to the device 8.11 Restore to factory setting boot Battery low charge
fo cut off and restore oi SMS command format: "FACTORY#" to set all parameter 2 No SIM card Insert SIM card
e format is: - . a x SIM card inserted
I и . ПД |
After the command is carried out, it will reply “RELAY:ON" to default factory value. Once received "FACTORY:OK! \/ Г incorrectly Check SIM card
If the command didn't carry out, it will reply the reason ` y Dirtv thinas exi
about fail to carry out = ' RU Sst Clean SIM card
y . 8.12 Reboot device | | Unable to above the SIM card Comments
. . . . iOS Android connect to | Contact network В
NOTE: When there is something wrong with the link of GPRS, the network Invalid SIM card supplier One side of the device is marked _" THIS SIDE
To ensure the safety of the driver and the car, this e.g. the parameter setting of the device is correct, but you Not in GSM service | TOWARDS SKY” , place the unit upside down will
command is valid onlv under two conditions: the GPS is can't track the car on the platform. At this moment you After receiving this command, the device will reboot after Move to service area result in connection issues.
y . . area
. : can send a command to the device to reboot the device. 20 d ; Avoid placing the device somewhere that metal will
located; the speed is less than 20km/h. - seconds Move to area with ina i
The format is: RESET# Poor signal ; ‚ла be covering it up.
strong signa

advertisement

Key Features

  • Covert installation for discreet tracking
  • Multiple alerts for various scenarios
  • Remote cut-off to prevent unauthorized vehicle use
  • Built-in GSM and GPS antennas for reliable connectivity
  • SOS button for emergencies
  • IP65 water resistance for outdoor use

Related manuals

Frequently Answers and Questions

How do I set the SOS number?
Send SMS command: SOS,A,number1,number2,number3 #
How do I set the center number?
Send SMS command: CENTER A.phone number#
How do I delete SOS numbers?
Send SMS command: SOS,D,1,2,3#
What is the default upload interval?
T1=10 seconds, T2=0 (no data uploaded)
What is the operating voltage range?
9-36V
What is the operating temperature range?
20°C ~ 70°C

advertisement