Brother PT-P910BT Quick setup guide

Brother PT-P910BT Quick setup guide
,[email protected],,5
0) 2 1
P-TOUCH CUBE XP (PT-P910BT)
Thank you for purchasing the PT-P910BT (hereafter referred to as "the
label printer"). Your PT-P910BT produces professional, high-quality,
durable labels. In additional, the variety of tape cartridges available
allows you to print labels with different widths and exciting colors.
Please read this guide, including all Precautions, before using this label
printer. After reading this guide, keep it in a safe place.
44)A!+ ! B
! Supplies
+C+2
2 " 32 +2
. & * ,5-!,:-!,->!,6D!,D,!,?6!565 ->!9!?!5:!5E!:6!-9
+C2&9
()*+*,,-
F F @G H Product Safety Guide
Safety Precautions
Follow these guidelines to avoid the risk of heat generation,
smoking, explosion, fire, or injury.
DANGER
4 Rechargeable Li-ion Battery
! ! 056,7489,721
0 *6748*:,721
20()*2*,,:1;
< = * ! ;% 4 ! 4 WARNING Rechargeable Li-ion Battery
< !#
!
! ! ! Safety Precautions (cont)
Label Printer and USB Cable
! ! !
! !
! " ! ! !# CAUTION
4 Rechargeable Li-ion Battery
# ! $%&'()*+*,,-. & * / Label Printer and USB Cable
0()*+*,,-1
" 22! ! ( 3 +( 3 / ) !( 3 / + # 1. Components
+ / 2. Parts Description
(&@
[email protected]/ ( (
&@
2
2
+I @ +
3. Insert the Battery and Charge
. 0 1 (* 5
:
-
2
6
>
9
(0 1
5 V DC, 0.5 A or above
)2)0 5 V DC, 0.5 A or above
1
D 2 ! )2) 2 &@
!# CAUTION
)&")'@[email protected](@2 4 @
L$&+)[email protected])%[email protected])2))([email protected]
[email protected]&)@&(. %[email protected]+$
([email protected]@%+)%')F)[email protected]$.4) &[email protected]
3. Insert and Charge the Battery (cont)
Notes on Using the Rechargeable Li-ion Battery
>,74 ?>748
5,72 ->72! ! &@ " / ( 2 " ! * DANGER
+ # !/ ! 4. Insert the Tape Cassette
) +
I ! # F# +
2
5
+2
#
2 [email protected]/ : (+2 5. Turn Power On or Off
(
(
(( ( ( (&@ To print from your Mobile Device, go to Step 6.
To print from your Computer, go to Step 8.
6. Print from Your Mobile Device
)I ( J
P-touch
Design&Print 2
#
Brother
iPrint&Label
2 !
!
!
! ) 2 $%! / ,EE 8:: +! K
P-touch Design&Print 2 *+ 2 K$44
Brother iPrint&Label *+ 2 ( K$%
+ ) !( # % ,EE 8:: / 7. Pair the Label Printer with Your Mobile Device
On your mobile device:
1. Go to the Settings menu and make sure the Bluetooth® option is on.
2. Select PT-P910BT**** (where **** is the last four digits of your label
B + “serial number is located inside the
Cassette Cover, underneath the TZe Tape Cassette.).
# a PIN Code, enter "0000".
( slightly, depending on your mobile
device.
not discovered by your smartphone or tablet via
Bluetooth, check the following:
- Place your mobile device as close as possible to the label printer.
- Make sure there are no obstacles or items that emit radio waves,
such as a microwave oven, between the label printer and your mobile
device. If such obstacles or items are present, use the label printer
away from them.
+ not support Wi-Fi connections.
8. Print from Your Computer
In the address bar, enter http://install.brother,
install the Printer Driver and P-touch Editor by
following the on-screen instructions.
Software
Printer Driver
P-touch Editor
P-touch Update Software
Printer Setting Tool
http://install.brother
Features
Software required to print from a label printer.
Label creation software for computers. This
application comes with built-in drawing tools
that allow you to print a wide variety of custom
labels in complex layouts with text of different
fonts and styles, frames, imported images,
barcodes, etc.
Update applications to the latest version.
(Windows only)
Configure settings for the label printer.
e, when Auto Cut is ON, the label
printer feeds approximately 0.88 8:: every new label. When printing multiple labels, you can prevent the
generation of the blank space on the second and subsequent labels.
Select Chain Printing in the optional settings of printing. Then print
your labels and leave the last label in the label printer until you are
ready to print a new label.
) !ss the Power Button twice quickly to
eject and cut the last label. Note that the label printer will feed about
,EE 8:: before the next new label when you
use this method.
" er, you must connect the label
printer and computer with the included USB cable. Printing can also
be performed from your computer via Bluetooth connection.
+ support Wi-Fi connections.
LED Indications
Power
LED
Lit/Flashing
Lit
4 ( Flashing
(1 second intervals)
. computer
+ Lit
Initializing or shutting down
Flashing
(1 second intervals)
Cooling
Green
Orange
Condition
Battery
LED
Lit/Flashing
Condition
Not lit
Fully charged
Lit
Charging
Flashing
(0.5 second intervals)
Refer to the LED Troubleshooting
section in this guide to solve the
problem.
Orange
LED Troubleshooting
Power
LED
Lit/
Flashing
Condition
Solution
Battery is not
inserted.
Insert or replace the
battery.
No Tape
Cassette or an
incompatible
Tape Cassette is
installed.
+
Cassette.
2 2
Cover.
Lightly
press the
Power
Button.
Flashing
(1 second
intervals)
Transmission
error
Red
How to
Clear
an Error
If using a mobile device
or computer, establish a
Bluetooth connection.
If using a computer,
reconnect the USB
cable, or change the
USB port.
When using a computer:
. cable.
2 port.
@ connection.
Flashing
twice per
second,
then off for
1 second
Lit
charge
( high voltage
error
Restart the If the problem is still not
label
resolved, replace the
printer.
battery.
Cutter error
Restart the label printer.
Recovery mode
Transfer the program again.
If the problem is still not resolved,
contact Brother customer service.
Troubleshooting
If you need additional help, visit support.brother.com.
Problem
Solution
2 #+2is inserted correctly.
+2 ! 2 #22ver is securely closed.
2
2 # 2 # B setting is on.
2 # or your mobile device via Bluetooth.
2 # (* app.
The label printer does 2 # device.
not print.
F# computer are close enough to communicate.
2 # Bluetooth re-connection
setting of another computer or mobile device is not
enabled.
F# 0
example, a microwave oven) are located nearby.
2 # printing from a computer.
2 included USB cable when printing from a computer.
2 # #
! off the bent section.
+ !move the tape cassette,
feed correctly.
remove the jammed tape, and then cut it.
+ #
2 # / +I inside the label
2 [email protected]/ printer.
. An error occurred
I B ˆ
when using a mobile
Support pageˆFAQs & Troubleshooting
app.
I want to cancel the
Make sure that the label printer is on, and then lightly
current printing job.
press the Power Button.
Troubleshooting (cont)
Problem
Solution
printer driver even if I If you cannot use your printer even though you have
follow the correct
installed the printer driver:
procedure.
1. Download the Printer Driver Uninstaller from
support.brother.com.
printer listed in
2. Use the Printer Driver Uninstaller to remove the
P-touch Editor even
printer information.
though I have
3. Run the installer again and follow the on-screen
installed the printer
instructions to proceed with the installation.
driver.
If the ink ribbon is broken,
Spool
replace the tape cassette.
The ink ribbon is
If not, leave the tape uncut and
separated from the ink
remove the tape cassette, then
roller.
wind the loose ink ribbon back
onto the spool.
Select Auto Cut.
The tape is not cut
If using special tapes like Ribbon Cassettes, cut the
automatically.
tape using scissors.
2 Printed barcodes or
Recommended: Black on white tape
QR codes cannot be
@ A. ! read.
possible.
Windows:
I want to check I am Use the P-touch Update Software to confirm if you have
using the latest
the latest version. See the 8VHU¶V*XLGH8SGDWH3WRXFK
version of the
(GLWRU.
software.
Mac:
See support.brother.com.
Regulation
Federal Communications Commission (FCC) Supplier’s Declaration of Conformity (USA)
Responsible Party: Brother International Corporation
200 Crossing Boulevard
Bridgewater, NJ 08807-0911, U.S.A.
TEL: (908) 704-1700
Product Name:
Model Number:
Brother Label Printer Electronic Labeling System
PT-P910BT
Label printer complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) Label printer may not cause harmful interference, and (2) label printer
must accept any interference received, including interference that may cause undesired
operation.
Label printer has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. Label printer generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If label printer
does cause harmful interference to radio or television reception, which can be determined
by turning the label printer off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
. 2 is connected.
2 / 8+L + * or transmitter.
Important
+ for a Class B digital device.
2 / Brother Industries, Ltd. could void the
user's authority to operate the label printer.
RF Exposure Notice (USA)
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines. This
equipment has very low levels of RF energy that it deemed to comply without maximum
permissive exposure evaluation (MPE).
RF Exposure Notice (Canada)
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment should be installed and operated keeping the radiator at least 20 cm or more
away from person's body.
Regulation (cont)
Industry Canada Compliance Statement (Canada)
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to
the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
CAUTION (USA)
RISK OF EXPLOSION IF BATTERY IS REPLACED WITH AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
ATTENTION: (USA and Canada)
The product you have purchased is powered by Rechargeable Li-ion
Battery which is recyclable. At the end of their useful lives, under various
state and local laws, it is illegal to dispose of this battery into your
municipal waste stream. Please call 1-800-8-BATTERY for information
on how to recycle this battery.
Contact Information
Customer Service for USA
Phone: 1-877-BROTHER (1-877-276-8437)
Fax: 1-901-379-1210
To order supplies and accessories:
www.brother-usa.com
Phone: 1-877-552-6255
Customer Service for Canada
8 To order supplies and accessories:
www.brother.ca
Other countries or regions
support.brother.com
DON'T FORGET TO REGISTER!
Registering your product will provide purchase confirmation, proof of ownership and, if you
choose, allow us to notify you of product enhancements and special offers!
You can register online at: www.registermybrother.com (USA)
8 8oduct-registration (Canada)
LIMITED WARRANTY
Product warranty information can be found online at:
www.brother-usa.com8* (USA)
8 (Canada)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement