Parts
• 1 Safety Key
• 2 Water Bottle Holders
• 1 Hardware Pack (contents listed below)
• Left and right outer console mast boots
• Console
Tools (included)
• 5rnm Alien Wrench/Phillips Screw Driver
• Flat Wrench
• 6mm Alien Wrench
HARDWARE
A) Linkage Arm
40mm bolt
Quantity: 2
B) Console Assembly
Bracket
45mm bolt
Quantity: 2
D) Console Mast Boot
16mm bolt
Quantity: 6
C) Console Assembly
13mm nylon nat
Quantity: 2
A
= Tighten
F) Screw
Quantity: 16
NOTE: Console screws come Pre-Attached.
NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your treadm[ll_ to prevent loosening and noise. Abo, during each assembly step_ ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.
\\\
F
U N P A C K I N G
Take caution when handffng and transporting this unit. Never open
box when it is on its side. Once the bandh_g straps have been removed, do not llft or transport this unit unless it is fully assembled and in the upright folded posff[on, with the lock Jatch secure.
Unpack the unit where it wlll be used. The enclosed treodmlll is equipped wffh high-pressure shocks and may spring open if mishandled.
See owner's guide for reference.
FAILURE TO FOLLOW
THESE INSTRUCTIONS COULD RESULT IN INJURY_ Pk_ce your treadln[ll on a level fiat surface. It is recommended that you place a proted_ve covering on your floor.
F
SEARS CUSTOMER ASSISTANCE CENTER
1.800.469.4663
or www.sears.com
CORE FITNESS SYSTEM
