Contour | Mouse Wireless | Owner's manual | Contour Mouse Wireless Owner's manual

Contour Mouse
Wireless
Product Manual
4
Box Contents
1.
2.
3.
4.
5.
Contour Mouse
Dongle (Wireless receiver)
USB 2.0 cable adapter
USB to Micro USB cable
User Guide
2
3
4
5
Contour Mouse
Wireless
1
1
Contour Mouse Wireless
/1
Topside Functions
Right click
Middle click
Auto scroll/Scroll wheel
Left click
Forward/Backward
toggle switch
Contour Mouse Wireless
/2
Charge port
Underside Functions
Sensor
On-Off switch
Cursor speed
adjustment (DPI)
Contour Mouse Wireless
Cursor speed/Battery
level indicator (LED)
/3
Power Switch
The power switch can be found on the underside of
the Contour Mouse. Before using the Contour
Mouse please make sure the power switch is set to
the ON position. Turning off the device is only
necessary for long-term storage or during travel.
Contour Mouse Wireless
/4
Connecting to a Computer
Charging
Plug the wireless receiver or the charging cable into the
computer’s USB port. Allow your computer a few seconds
to automatically install mouse drivers.
To charge your Contour Mouse remove the dongle from the
extender cable and plug the Micro USB into the Contour Mouse.
Your Contour Mouse will charge in 2 hours and you may continue
to use your Contour Mouse while it charges.
Contour Mouse Wireless
/5
Pairing
With the Contour Mouse in close proximity to the
dongle, hold left click, right click and the cursor
speed buttons at the same time until the LED
indicator turns blue and pulses twice in succession.
Left click
Right click
Cursor speed
Contour Mouse Wireless
/6
Battery Level
100%
Your Contour Mouse comes pre-charged and has an expected battery life of up to 3
months with average daily use.*
Contour Mouse has a built-in rechargeable battery. To see the battery level on your
device, press the cursor speed button once. The Contour Mouse will first display the
current cursor speed (DPI), then display the current battery level.
If your Contour Mouse is running low on battery, the center LED light will start blinking
red.
To charge your battery, plug the charging cable into your Contour Mouse and connect
it to a USB port on your computer (see page 5). The Contour Mouse will charge in 2
hours and you may use your Contour Mouse as it charges.
50%
*Battery life may vary based on user and computing conditions.
5%
Contour Mouse Wireless
/7
Change Cursor Speed
Press the cursor speed button to cycle through cursor speeds.
There are ten speed selections ranging from slow (800 DPI) to fast (2800 DPI).
Speed is indicated by the LED lights as shown.
1) 800
2) 1000
6) 1800
7) 2000
Contour Mouse Wireless
3) 1200
8) 2200
4) 1400
5) 1600
9) 2400
10) 2800
/8
For more information please visit:
www.contourdesign.com
Contour Design, Inc.
10 Industrial Drive
Windham, New Hampshire 03087, USA
Phone: (603) 893-4556
Email: [email protected]
Contour Design Nordic A/S
Borupvang 5B, St.
DK-2750 Ballerup/Denmark
Phone: +45 32 46 11 20
Email: [email protected]
Tested to comply with FCC
and IC standards
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicable aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement
Warranty
If there is a functional defect due to faulty manufacturing, we will replace the product. This warranty does not cover damage
that results from misuse of the product.
Attention!
If you attempt to dismantle your Contour Mouse, you will invalidate your warranty.

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project