Instructions Manual
2 in 1 vacuum cleaner
Model : VC-1156
Read and save these instructions for future reference
BEFORE USING THE APPLIANCE, CAREFULLY READ THESE INSTRUCTIONS:
WARNING: To reduce the risk of fire, electrical shock, or injury:
1.
Do not leave the appliance unattended when plugged in. Unplug from the outlet when not in use and before servicing.
2.
Do not use outdoors or on wet surfaces.
3.
Do not allow to be used as a toy. Close attention is necessary when the appliance is used near children.
4.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
5.
Do not use the appliance with a damaged cord or plug. Do not operate the appliance if it has been dropped, damaged, left outdoors, or dropped in water. Return it to an authorized service center.
6.
Do not pull or carry the appliance from the cord, do not use the cord as a handle, do not close a door on the cord, neither pull the cord around sharp edges or corners.
7.
Do not unplug by pulling the cord. To unplug, grasp the plug, not the cord.
8.
Do not handle the plug or the appliance with wet hands.
9.
Do not put any object into the openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may reduce air flow.
10.
Keep hair, loose clothing, fingers, and all parts of the body away from the openings and moving parts.
11.
Turn off the appliance before unplugging.
12.
Use extra care when cleaning on stairs.
13.
Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
14.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
15.
Do not use without the filters in place.
16.
Look on your vacuum and follow all label and marking instructions.
17.
Keep end of hose, wands and other openings away from your face and body.
18.
Always unplug this appliance before connecting or disconnecting the stick or floor brush.
19.
Store the vacuum indoors. Put the vacuum away after use to prevent tripping accidents.
20.
Using improper voltage may result in damage to the motor and possible injury to the user.
Correct voltage is listed on the rating label.
21.
Use only on dry, indoor surfaces.
22.
Do not use for any purpose other than the one described in this user’s guide.
23.
If the cleaner is damaged, it must be repaired by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
24.
Do not run the appliance over the cord. Keep the cord away from heated surfaces.
25.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
26.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
27.
Children should be supervised to ensure that they do not play with the appliance.
1.
If the suction nozzle or floor nozzle are blocked, turn off the unit, unplug the power cord from the outlet, and only after making sure that the two previous operations have been successfully carried out, remove the obstruction from the device.
2.
Before operating the unit, be sure to remove from the surrounding every sharp or large object that can clog or damage the device.
3.
Avoid using the unit without the filter.
1.
Stick and handle
2.
Switch
3.
Release button
4.
HEPA filter
5.
Dust bin
6.
Release button for dust bin
7.
Hooks for wire
8.
Floor Brush
ASSEMBLY
(before assembling, make sure that the device is powered off and the cord is unplugged)
1.
Insert and connect the floor brush onto the lower part of the main body (as show in the figure.
2.
Press the clip of the main unit and insert the handle into the opening.
Ensure that the handle is placed securely.
OPERATING:
1.
Make sure that the floor brush or cleaner nozzle are properly assembled, according to the intended use.
2.
Roll out the cable and connect the plug to an appropriate power supply socket.
3.
Press the start button and slide it to “I”. The unit will start to operate.
CLEAN:
1.
After each use, place the switch to “0” and disconnect the plug from the mains.
2.
Always allow the appliance to cool down before storing.
3.
Remove the floor brush or vacuum cleaner nozzle.
4.
To empty the dust box press the release button - the bottom compartment will open and you can release the content. CAUTION: Make sure to do this when you are positioned over a waste container.
Note: Empty the compartment when you see that it is full.
CLEANING THE FILTER:
Before cleaning, make sure the device is powered off and the cord is unplugged. Always operate the cleaner with the filter installed.
The filter must be washed at least 2 times a year or more often if dirty.
1.
Allow the appliance to cool down before cleaning.
2.
Remove the filter and clean it under running tap water.
3.
Tap the filter to remove thoroughly any water remaining in the filter and let it dry completely for 24 hours before refitting into the device.
IMPORTANT: DO NOT CLEAN YOUR FILTER IN THE WASHING MACHINE AND DO NOT
USE THE HAIR DRYER FOR DRYING IT.
IMPORTANT: THE FILTER MUST BE CHECKED REGULARLY FOR SIGNS OF DAMAGE,
AND MUST BE REPLACED IMMEDIATELY IF DAMAGED.
TROUBLESHOOTING :
Problem
Weak suction
Appliance is not working
Overheat of the body of the device
Possible cause
Dust in the filter
Dust bin full
Obstacles in the openings of the device
The plug is not connected to the main wall socket
Slight temperature rising on the accessible surfaces of the device is normal during use. In case of higher temperature rise, check that the device suction nozzles and openings of the device are not blocked
Proposed solution
Wash the filter
Empty the dust bin
Remove all obstacles
Connect the plug of the appliance to the main wall socket
Check all opening of the device and remove obstacles that block and prevent air circulation.
NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste. Please dispose of this equipment at your local community waste collection/ recycling centre. In the European
Union there are separate collection systems for used electrical and electronic products. Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Amiridis-Savvidis S.A. states that this product, complies with the requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
ErP Directive 09 / 125 / EC
CE Marking: 93 / 68 / EEC
RoHS Directive: 11 / 65 / EU
The detailed declaration of conformity can be found at www.united-electronics.gr
Exclusive importer in Greece:
Amiridis – Savvidis S.A.
87A, 17 th Noemvriou str, P.C. 55534
Thessaloniki – Greece
T: +302310944944 | F: +302310944940 www.amiridis-savvidis.gr
