ELECTRIC WINDOW SQUEEGEE
READ ALL WARNINGS AND INSTRUCTIONS IN FULL BEFORE USING
°°...
WARNINGS
- When using any electrical appliance, always observe basic safety precautions. The
following instructions should be followed to reduce the risk of fire, electric shock, or
injury.
* This is not a toy. Use adult supervision.
* Use appliance only as described in this manual.
+ Ensure the voltage indicated on charger corresponds to local voltage before connecting
the device.
- Always use grounded socket.
* Check device regularly for damage. Do not use device if power cord, plug, or charger
are damaged, or when any component of the device has been dropped or damaged. If
power cord is damaged, call customer service number at the end of this manual for a
replacement in order to avoid safety hazards.
Do not attempt to repair device yourself.
Keep out of reach of children, and away from plants and pets.
Do not allow children to play with packaging due to risk of suffocation.
Always disconnect device from adapter when filling, emptying, or cleaning.
Do not pull power cord to disconnect charger from socket; instead, hold adapter and
gently pull to disconnect.
Do not use device with an extension cord unless extension cord has been checked and
tested by a qualified technician.
Do not close door on power cord or pull around sharp edges or corners. Do not allow
power cord to be compressed or curled.
Keep device, charger, and power cord away from flames and hot surfaces.
Do not use attachments which are not manufacturer approved.
Do not use accessories which are not supplied with device.
Do not use device near flammable vapors such as paint thinner, flammable material, oil
based paint and varnish, or flammable liquids and gases.
Do not immerse device and/or adapter in any liquid.
Do not touch charger with wet hands.
Do not touch electric device if it has fallen in water or other liquids. If this occurs, unplug
from wall immediately.
Do not add any other liquids to water being used in water tank as this may damage the
device or make it unsafe to use. Only use water. Use of distilled water is recommended
in areas with hard water to avoid lime scale deposits.
Use suction function only to remove liquids used during cleaning process.
Only use device on a smooth, solid, flat surface that is capable of withstanding moisture.
Make sure air exhaust is not blocked when unit is in use.
Only use charger supplied with device.
Use caution when cleaning on ladders.
Store appliance indoors.
Damage caused by improper use of this device on objects, materials, persons and/or
animals or by not observing the instructions in these directions is excluded
from warranty.
Product is not designed for commercial use.
PARTS DIAGRAM
OO мч о о SON A
Pad attachment area
Squeegee
Spray nozzle
Water collection tank
Spray trigger
Clean water tank
Air outlet
Squeegee head release button
Power button
Handle
Battery indicator light
Charging port
AC adapter (not pictured)
Pad (not pictured)
Filter (not pictured)
Cleaning pads (not pictured)
USE INSTRUCTIONS
See parts diagram to aid in assembly
and operation. В FIG. 1
BEFORE FIRST TIME USE 4 FT "
1. Remove all packaging materials. A 0
2. Clean unit as outlined in the CARE г
INSTRUCTIONS section of this manual. ) f
3. Check unit for damage before each use. Do not
use if power cord or adapter is damaged or not
functioning properly. FIG. 2
INSTALLING FILTER
1. Attach filter onto peg inside top of unit (fig. 1).
Press firmly to ensure fully installed.
2. Install squeegee head over filter and onto unit,
(fig. 2) being sure squeegee is locked in place prior
to use.
FIG. 3
CHARGING BATTERY
Attach adapter to unit using the charging port before
plugging adapter into a grounded outlet. Make sure
power supply indicated on adapter corresponds with
outlet voltage. The battery indicator light will turn blue
to indicate the unit is charging. All four LED lights
will turn on when battery is fully charged. It takes “Top of
approximately 2 hours to fully charge the battery. It is reservoir mn
suggested to fully charge battery before using unit. > | —
Unplug adapter when charge is complete.
FIG. 4
FILLING WATER TANK 5
1. Ensure unit is turned off and unplugged.
2. Remove water tank from unit by pulling on tabs at
the top of water tank (fig. 3). € FIG. 5
3. Remove cap on clean water tank (fig. 4). x
4. Fill with clean water, tilting unit slightly forward to
prevent spilling. Once water tank is filled to top of
reservoir* (fig. 4), replace cap. Do not overfill water
tank.
5. Reattach water tank to unit by placing base of
water tank in unit first and then pushing top until it
clicks into place (fig. 5).
NOTE: Unit must be unplugged while filling tank.
NOTE: Do not add harsh cleaning materials, caustics,
acids, scented perfumes, oils or cleaning products to
the water or the water tank as this may damage the item
or make it unsafe to use. Only use clear and pure water.
The use of distilled water is recommended in areas with
hard water to avoid lime scale deposits.
ATTACHING CLEANING PAD
Align cleaning pad with hook and loop fastener on
squeegee head and press down to attach. Pull up
on pad from a corner to remove or reposition. Clean
pad after each use for best results. See CARE
INSTRUCTIONS section on how to clean pads.
CLEANING INSTRUCTIONS
1. Spray surface with water by holding unit by handle
and pressing spray trigger (fig. 6). Ensure spray
is directed towards area to be cleaned and cover
surface with water.
2. Turn unit over and hold by the water tank portion
of the unit (fig. 7) to use the cleaning pad to clean
surface. If needed, a mild glass cleaner can be
sprayed on surface.
3. Once surface is clean, turn unit over again and
turn on suction by pressing power button. Keep
unit in a horizontal position and move squeegee
over surface in a gentle, top-to-bottom movement
to remove excess water and dirt. When finished,
turn off suction by pressing power button again.
4. Remove water tank from unit and remove water
collection tank cap and water filter cap (fig. 8).
Empty water collection tank by turning upside-
down over a sink until all water
is gone.
FIG. 7
FIG. 8
5. Remove squeegee head to remove filter. Clean filter after every use. See CARE
INSTRUCTIONS for how to clean filter.
NOTE: Do not spray into eyes or onto surfaces with electronic components, such as power
plugs, switches, cables, stereo equipment, computer screens, or household appliances.
WARNING: Use suction function only to remove liquids used during cleaning process.
CARE INSTRUCTIONS
CLEANING UNIT
1. Turn off unit and unplug.
2. Press release button to remove squeegee head. Remove filter.
3. Lift water tank from unit. Remove caps from water collection tank and water filter
openings. Empty water tank by turning unit upside-down over sink or bathtub.
4. Clean unit and accessories with damp cloth and mild detergent. Allow to dry completely.
5. Wash filter carefully before placing back in unit. Collected water is recycled through this
filter. Be sure to clean after every use.
NOTE: Do not use abrasives, bleaching agents, or steel wool to clean unit. This could
cause damage to unit.
CLEANING PADS
For best results, pads should be cleaned regularly. Machine wash cold, with mild detergent,
and air dry. Do not place in dryer.
RINSING WATER TANK
To clean water tank, fill both sections of tank with water and close caps. Shake unit
vigorously to release any lime-scale deposits that have collected on bottom of tank. Pour
out water by holding unit upside-down over sink or bathtub.
LIME-SCALE REMOVAL
To extend life of product, it is recommended to descale unit every six months. Turn off unit
and unplug, then fill tank with equal parts boiling water and white vinegar. After 30 minutes,
dispose of water by holding unit upside-down over sink or bathtub. Rinse tanks thoroughly.
STORAGE
Clean unit and all attachments before storing and ensure they are completely dry. Do not
store with water in water tank. Store indoors in a cool, dry place.
TECHNICAL SPECS
* Window cleaner input: 3.7V DC 9W
* Adapter input: 100-240V~50/60Hz, 0.2 A
* Adapter output: 5V DC 1000mA
NOTES
Read Instructions — MADE IN X PATENT |
A Before Operating CHINA С € PATENT Рем 111418 VIATEKPRODUCTS.COM
п.
For questions, assistance, or replacement parts, do not return to your retailer. Contact Viatek® customer service below.
For refunds on items not purchased from Viatek® directly, please contact your retailer.
VIATEK® 1-YEAR LIMITED WARRANTY
Viatek® warrants this product to be free of manufacturing defects. Should any such defect develop or become evident within one year from
the date of purchase, Viatek® will replace the entire product or, at its option, repair or replace the defective part(s) without charge.
Contact Viatek® customer service at 888.784.2835 or at [email protected] to determine whether it is necessary to return the unit. To return,
securely pack the entire unit. Be sure carton clearly identifies sender by name and address. Attach a letter or card describing defect and
original sales receipt. Mail prepaid to Viatek Consumer Products Group, Inc. 6011 Century Oaks Dr. Chattanooga, TN 37416.
This warranty is void if damage or malfunction is due to abuse or failure to operate product in accordance with instructions and on
recommended electrical current. This warranty gives you specific legal rights and you may also have other rights which vary from state to
state. If you have any questions, or would like to learn more about Viatek®, please contact us at 888.784.2835 or at [email protected].
Register your product online at viatekproducts.com/register-your-product-warranty/
Customer Service / Le service a la clientele / Servicio al Consumidor Model:
. 888.784.2835 (+1.423.402.9010) = [email protected] CWC-302
DO NOT DISPOSE OF BATTERIES IN FIRE. ALWAYS DISPOSE OF BATTERIES PER LOCAL & FEDERAL GUIDELINES.
© 2018 VIATEK CONSUMER PRODUCTS GROUP, INC. All specifications are subject to change without notice. All rights reserved.
Viatek Consumer Products Group, Inc. 6011 Century Oaks Dr. Chattanooga, TN 37416
">