Stinger SPXWPRGB4 4FT RGB LED TWIN STRIP DOUBLE SIDED LIGHTED WHIP Owner's Manual

Add to My manuals
2 Pages

advertisement

Stinger SPXWPRGB4 4FT RGB LED TWIN STRIP DOUBLE SIDED LIGHTED WHIP Owner's Manual | Manualzz

RGB LED LIGHTED WHIP with QUICK DISCONNECT

Before you start, read directions completely.

If your vehicle is not pre-wired for external lighting, you may need the following:

Inline Fuse Holder (SPXATC16 or similiar)

3 Amp Fuse

2 Strand Primary Wire

Wire Connectors / Solder

Wire Cover

Zip-Ties

Optional:

Switch

Relay

1. Mount the base in desired location. The base requires a 1/2”/ 13mm mounting hole.

2. Connect extension wire to the Red and

Black wires and route wiring to the battery or switch / relay location.

3. Refer to diagrams for wiring.

Diagram 1: Wiring direct to power and using remote control to turn on/off. Must add 3

AMP fuse on RED 12V+ wire.

Diagram 2: Wiring with a switch. You can add a new dedicated switch or use an existing light switch that outputs 12V+ when

ON. You will need to add a 3 AMP fuse on the RED 12V+ wire and also requires a 12V relay.

Diagram 1

Diagram 2

SPXWPRGB4

SPXWPRGB5

WHAT’S INCLUDED

4’/5’ LED Whip

Mounting Base

Flag

Remote Control

Zip-Tie for Flag

Mounting Base Cap

3

Positive +

Negative -

4. Attach whip and test.

To attach or release the whip from the base, pull up on the locking collar.

3 AMP

FUSE

87

86 87a

30

85

ON

12V+

Positive +

Negative -

When whip is not attached to base, use supplied cap to keep dirt and debris out of connector.

Use Zip Ties to secure flag to the whip

SPXWPRGB4

SPXWPRGB5

RGB REMOTE CONTROL

20 static colors, 9 dynamic modes, 5 level speed / brightness

Battery: CR2025 / 3V - included

POWER

Turn ON/OFF.

Lights will revert to last setting.

DEMO

Cycles 9 dynamic modes

COLOR+ / COLOR-

Switch to static color from dynamic mode, or between

20 different static colors

SINGLE STATIC COLOR SELECT

MODE+ / MODE-

Switches between dynamic modes... flashing, fading, color change.

SPEED+ /SPEED-

Adjusts dynamic mode lighting speed

BRIGHT+ / BRIGHT-

Adjusts lighting brightness (5 levels)

SPXWPRGB4

SPXWPRGB5

LIMITED WARRANTY:

Stinger warrants this product to be free of defects in materials and workmanship for a period of one (1) years from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized Stinger dealer in the

United States of America only. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction, Stinger will (at its discretion), repair or replace the defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse, abuse, product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not covered under warranty.

INTERNATIONAL WARRANTIES:

Products purchased outside the United States of America are covered only by that country’s Authorized Stinger reseller and not by Stinger. Consumers needing service or warranty information for these products must contact that country’s reseller for information.

Stinger is a Power Brand of AAMP Global

15500 Lightwave, Clearwater, Florida 33760

P: 888-228-5560 [email protected]

www.stingerelectronics.com

© 2018 Stinger

advertisement

Related manuals

Download PDF

advertisement