Stinger SEADP2BLU 12" BLUE MARINE LED DRAIN PLUG Owner's Manual

Add to My manuals
1 Pages

advertisement

Stinger SEADP2BLU 12

SEADP

Marine Drain Plug Light

IPX68 - 9 X LED

IMPORTANT NOTES!

 Lights are for underwater use only.

 Do not operate above water for over 5 minutes.

 12V / DC operation only.

 Supplied fuse must be used on Positive lead.

INSTALLATION

1.

Remove existing drain plug.

2.

Feed the SEADP power wire through the drain opening and screw in the light assembly. Hand tighten firmly.

3.

On the inside of the boat, leave enough slack in the power cable so the drain plug can be removed. Secure and route power cable to switch.

4.

You can add a new dedicated switch or use an existing light switch that outputs 12V+ when ON. A 12V relay is recommended.

ON

Positive +

SWITCH

12V+

  

  

  

87

86 87a

30

85

Negative -

SEADP SPECIFICATIONS

Housing Material

Light Source

LED Power

Beam Angle

Working Temperature

IP Rating

Certification

Dimensions

Weight

Bronze

LED x 9

9W

120°

-4° - 104° (F)

-20° - 40° (C)

IP68

CE, RoHS

ATC(ATE20081436)

0.9 x 0.9 x 2.12in

23 x 23 x 54mm

4.52oz / 128g

LIMITED WARRANTY:

Stinger warrants this product to be free of defects in materials and workmanship for a period of one (1) years from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized Stinger dealer in the United

States of America only. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction,

Stinger will (at its discretion), repair or replace the defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse, abuse, product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not covered under warranty.

INTERNATIONAL WARRANTIES:

Products purchased outside the United States of America are covered only by that country’s Authorized Stinger reseller and not by Stinger. Consumers needing service or warranty information for these products must contact that country’s reseller for information.

Stinger is a Power Brand of AAMP Global

15500 Lightwave, Clearwater, Florida 33760

P: 888-228-5560 [email protected]

www.stingerelectronics.com

© 2019 Stinger

advertisement

Related manuals

advertisement