CNB D1760N/D1760P Owner's Manual


Add to my manuals
1 Pages

advertisement

CNB D1760N/D1760P Owner's Manual | Manualzz
 USER INFORMATION: DIMENSIONS(mm):
CAUTION | | Po
RISK OF ELECTRIC SHOCK | *Dome (985) J
DO NOT OPEN {
CAUTION! TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE A
COVER {OR BACK). NO USER-SERVICEABLE PARTS INSIDE. st
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. |
Explanation of two Symbols _
The li Hing Lead with arrowhead symbol, within an equilateral SPECIFICATIONS:
AN triangle 15 In mo to ser Esto to the Oe rigs we
2 erous voltage" within duct's enclosure ma o
sufficient mamie ts contitule a rue of electr ahocke te NE signal System NTSC : 525 Lines PAL : 625 Lines
The exclamation point within, an equilateral triangle is intended to Scanning System 2 : 1 Interlace
уе the user 10 the presence Sra JC, ua a Scanning Frequency (H) 15.734kHz 15.625kHz
Е PE PP Scanning Frequency (V) 59.94Hz 50Hz
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ARE ON THE BOTTOM
OF THE SYSTEM. Image Sensor
"WARNING-TO PREVENT FIRE OF. SHOCK HAZARD, DO NOT EXPOSE THE UNIT
TO RAIN OF MOISTURE" 5/N Ratio
Resolution
PRECAUTION: Video Output Level
Lens- Mirror Cover
& All the warnings and instructions of this manual should be followed. Lens- Smoke Cover
1/3 inch SONY Super HAD CCD
Total/Effective Pixels No. 410K/380K [Normal:270K/250K] 470K/440K[Normal:320#/290K]
More than 48dB
550 TV Lines / 480 TV Lines / 380 TV Lines
1.0 Vp-p (75 Ohms, composite)
Fixed Lens (f=3.8mm, 6.0mm Selectable)
Fixed Lens (f=2.45mm)
P/N:3810-0056D
=
1/3" SONY CCD
GO Remove the plug from the outlet before cleaning. Do not use liquid Focus Manual Da D f À
aerosol detergente: Use water damped cloth for cleaning. Sync. System Internal M af vo NN
© To reduce the risk of fire or electric shock. do not expose this appliance Sensitivity 0.3 Lux(High) / 0.1 Lux(Normal) | =
© Do not place anything on top of the unit that might spill or fall into : Fr sé vt PEO CE ee LENS вы лете | CCD COLOR
Do not atte to thi If removi
> covers may you to d dangerous voltage or of Her Hazara. Please AGC / BLC Auto
all servicing to qualified service Input/Output Connector Power{Red Jack), Video(Yellow Jack) mo &
© Keep enguah space around the unit for vante де MERE | OC SV —13V (Recommendation DC 12:05
D a as or htni ks of thunder, hen the
9 no fused foral lon time, unplug the system power supply to Dome Size (@) 85mm AWB “sarita = AGC A DSP =
protect the unit from lightening or power surges. Weight Approx. 2 20g
lo Changes in this user manual can
INSTALLATION: be made without notice, in order TROUBLESHOOTING:
A to improve the product quality.
manu val explains 8 the installation and operating method for COMPOSITION: If you have trouble operati r camera, refer to the following.
der camera. installation mak е sur” you are familiar | AR If the guidelines do not enable you to solve the problem,
with this products special features and proper r operating technique. contact an authorized technician.
Dome Camera Guide Pattern
Asch the wall or collinear © The image does not * Check the power source for the monitor
etnia appear on the screen. and camera and assure that the voltage
ua em Mountl and polarity are properly connected and
Fixed the camera to a Owners Manual nd being supplied correctly.
ceiling using two screws.
( The image on the * Check if the lens is stained. If dirty,
ih Sang ih sept i CONNECTION: “screen is dim. clean the lens with a soft, clean cloth.
properly. * Adjust the Back Focus of the lens again.
After adjust them, fixed Video Ourput +} © The camera does not * Check if you have connected the camera
the dome cover. work properly, the to a proper power source and If there is
END GND surface of the camera no problem with the power, turn the unit
case is hot, and a off immediately and seek assistance from
Dome Cover
@ Insert coin to the side hole and
remove the dome cover by twist coin.
Oo—e—©
(DC 12V/ Over 0.3A Power Adapter)
| No. Function Terminal Color
#1 Video Output Yellow
#2 Power Input Red
black line appears on
our After Service department.
the screen. pa
* Check if the camera is pointed toward
© The screen blinks a lot.
the sun or a fluorescent lamp.
* Adjust the angle or location of the
camera if too much light is coming into
the screen.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement