Distributed by
Any reference to Raytheon or
RTN in this manual should be interpreted as Raymarine.
The names Raytheon and RTN are owned by the
Raytheon Company.
86005_2.book Page 1 Monday, July 9, 2001 11:58 AM
ST3000 Wheel Pilot Quick Reference Guide
Basic operation
Auto mode
Making course changes
Entering Auto mode (Engaging the autopilot)
+
Course changes to port
1˚ or
10˚
Course changes to starboard
Returning to Standby (Disengaging the autopilot)
Returning to previous locked heading
+
1 sec then again to accept heading
Track mode
Entering Track mode (from Auto or Wind Vane mode) and to enter Track mode
Wind Vane mode
Entering Wind Vane mode then and to accept new heading and
Press STANDBY or AUTO to exit Wind Vane mode.
Using AutoTack
AutoTack to port
(100˚) and and
AutoTack to starboard
(100˚) Press STANDBY or
AUTO to exit.
Switching lighting on/off
(from Standby mode only) and
Press to switch between:
ON
Autopilot displays
Switching AutoSeastate on/off
(from Auto/Track/Wind Vane modes) and
Press to switch between:
ON
OFF
Wait 10 sec to return to previous mode.
OFF
D5659-1
86005_2.book Page 2 Monday, July 9, 2001 11:58 AM
ST3000 Wheel Pilot Quick Reference Guide
Compass calibration
1 Enter compass calibration
Start turning boat
(see 2 below)
1 sec
2 Turn boat in slow circles
Turn the boat in slow circles so:
• boat's speed stays below 2 knots
• each circle takes at least 3 minutes
3 Autopilot displays amount of deviation detected
Keep turning the boat until the display alternates between:
• autopilot heading
• deviation detected
4 Align the autopilot heading
Adjust the autopilot heading to match the boat's steering compass
Autopilot heading Autopilot heading or or
5 Save changes
1 sec
To:
• save deviation correction
• save heading alignment
• return to STANDBY mode
Document number: 86005-2 (use with handbook: 81194)
Date: June 2001
Steering compass
Known heading
To:
• quit compass calibration
without saving
D5660-1
