VTech BM3510 Quick Start Manual

BM3510 Baby Unit

Quick Start Guide

(for use with BM3500 parent unit)

3

Align the wall mount and screws with the holes in the wall as shown. Tighten the screw in the middle hole first, so that the wall mount position is fixed. You can tighten the other screw in the top hole.

4

ON/OFF

VOL

Mount the baby monitor

1

1

NOTE

Check for reception strength and camera angle before drilling the holes.

Place the wall mount on a wall, and then use a pencil to mark the top two holes as shown. Remove the wall mount and drill two holes in the wall (7/32” drill bit).

2

If you drill the holes into a stud, go to step 3.

-OR-

If you drill the holes into an object other than a stud, insert the wall anchors into the holes.

Tap gently on the ends with a hammer until the wall anchors are flush with the wall.

2

3

Place the baby unit on the wall mount.

Tighten the screw into the threaded socket at the bottom to secure the baby unit.

5 Power outlet

VOL

ON/OFF Self-adhesive trap

Plug the power adapter into the baby unit, plug the other end of the power adapter into the wall outlet. Bundle the power cord neatly with the self-adhesive strap. Make sure to keep the power adapter cord away from children’s reach.

Pair/unpair the baby unit

Pair new baby unit

The new BM3510 baby unit must be paired to the BM3500 parent unit before use. Please refer to BM3500 user’s manual for complete instructions, including baby unit installation.

To pair a baby unit:

Make sure you power on the baby unit and the parent unit before pairing.

1.

Press when the parent unit is not in use.

2.

Press or to choose PAIR/UNPAIR , then press .

3.

Press or to choose Pair Baby unit , then press .

4.

Press or to choose a desired baby unit slot, then press .

5.

Make sure the new baby unit is turned on. On the new baby unit, immediately press and hold PAIR for five seconds when the parent unit screen displays Press and hold PAIR on Baby Unit to start Pairing .

Parent unit screen displays Pairing...Please

Wait... and emits beep sound every two seconds. The LED light on the new baby unit flashes quickly.

6.

When pairing is successful, the screen displays Pairing completed . You hear a confirmation tone. The LED light on the new baby unit turns on. The parent unit returns to the previous menu.

•

•

•

NOTES

If pairing fails, the screen displays failed . Try the pairing process again.

During registration, you may press to cancel the registration when parent unit screen displays

Pairing... Please Wait...

.

Pairing

Only one baby unit can be paired at a time.

Unpair the baby unit

Make sure you powered on the baby unit and the parent unit before unpairing the baby unit.

To unpair a baby unit:

1.

Press use.

when the parent unit is not in

2.

Press or to choose PAIR/UNPAIR , then press .

3.

Press or to choose Unpair Baby unit , then press .

4.

Press or to choose a desired baby unit or all baby units, then press .

5.

When the screen displays Confirm to unpair?

, press .

6.

When unpairing is successful, the screen displays Unpairing completed . The LED light on the selected baby unit flashes slowly. Then, the parent unit returns to the previous menu.

If you have any problems with your baby unit, refer to the

TROUBLESHOOTING section of your BM3500 User’s manual.

For technical support, please call VTech Technical Inquiry Hotline

852-2667 7433.

© 2014 VTech Telecommunications Ltd. All Rights Reserved.