Delonghi TRH0715 Hvac Owner's Manual

Add to My manuals
6 Pages

advertisement

Delonghi TRH0715 Hvac Owner's Manual | Manualzz
 ELECTRIC OIL FILLED RADIATORS
INSTRUCTIONS FOR USE
SAVE THESE INSTRUCTIONS
Register this product on-line and receive a free trial issue of
Cook's Illustrated. — Visit www.prodregister.com/delonghi.
Visit www.delonghi.com for a list of service centers near you.
(U.S. Only)
TYPE/MODELE/MODELO/MODELLO:
EW050/-EW050/W-250/1-EW650/1-9/0/1-TRHO/15
IMPORTANT SAFEGUARDS
When using electrical appliances, basic precautions should always be followed to reduce
risk of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. If your radiator is equipped with a polythene tape used as carry handle, remove it before
connecting appliance fo the outlet.
3. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
Use handle when moving this heater. Keep combustible materials, such as furniture, pil-
lows, bedding, papers, clothes, and curtains at least 3 feet (0,9 m) from the front and top
of the heater and - them away from the sides and rear.
Extreme caution is necessary when any heater is used by or near children and whenever
the heater is left operating and unattended.
Always unplug heater when not in use.
IF the ot cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Do not any with a damaged cord or plug or after the heater malfundions, has been drop-
ip soc] manner. If heater has leaked any oil, disconfinue using the heater and contad
service center as indicated in the instruction leaflet. Return heater to authorized service facility for exa-
mination, electrical or mechanical adjusiment, or repair.
Do not use outdoors.
This heater is not intended for use in bathrooms, laundry areas and similar indoor loca-
tions. Never locate heater where it may fall info a bathtub or other water container.
10. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like.
Arrange cord away from traffic area and where it will not be tripped over.
11. To disconnect heater, turn controls to off, then remove plug from outlet.
12. Connect to properly polarized outlets only.
13. Do not insert or alle foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock, fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use
on soft surfaces, like a bed, where openings may become blocked.
15. A heater has hot or arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as describa in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
17. To prevent overload and blown fuses, be sure that no other appliance is plugged into the
same outlet recep) or into another outlet (receptacle) wired info the same circuit.
18. It is normal for the s plug and cord to feel warm to the touch. A plug or cord which becomes hot
fo the touch or becomes distorted in shape may be a result of a wom electrical outlet. Wom outlets or
receptades should be replaced prior fo further use of the heater. Plugging heater into a wom outlet
/ receptade/ may result in overheating of the power cord or fire.
19. Do not use an extension cord because it may overheat and cause a risk of fire. However, if you have
to use an extension cord, the cord shall be No. 1 4 AWG minimum size and rated not less than
1875 watts, and has to be used only for supplying power fo this heater.
20. Be sure that the plug is fully inserted ape po Please remember that outlets also deterio-
rate due to aging and continuous use: periodically if signs overhedtfing or deformations are evi-
denced by the plug. Do not use the outlet and CALL your electrician.
21. Check that neither the appliance nor the power cable have been damaged in any way
during transportation.
22. Make sure that no pieces of polystyrene or other packaging material have been left
between one element of the appliance and another. It may be necessary to pass over the
appliance with a vacuum cleaner.
23. When switching on the appliance for the first time, allow it to run at full for about two
hours to get rid of the unpleasant smell. Make sure that the room in which the appliance is
located is well ventilated during this operation. It is normal for the appliance to emit small
cracking sounds when you turn it on for the first time.
SAVE THESE INSTRUCTIONS
N own a
a
HOW TO USE YOUR HEATER
FITTING THE WHEELS
Remove the feet and the wheels from the polystyrene packing. Turn the radiator upside-
down on a rug or a soft surface in order to prevent damaging the paint finish.
Fit the wheels to the spindles on the feet and push firmly until they click into position.
Pull each wheel to check that it is correctly inserted.
The feet with the casters must be fitted with two arc-shaped brackets and fit them
using the threaded bar and ad nut provided, only between the 1st and 2nd ele-
ment and the second to last (see fig. 1 to 3 inclusive).
fig. 2
| fig. 3
MODELS WITH “EASY WHEEL” SYSTEM
Turn the radiator upside-down on a НН a soft surface in order to prevent damaging
the paint finish. Fully unfold the castors by turning them outwards (Fig. 4).
Turn the radiator back to its upright position.
CAUTION
Always operate the heater in upright position only (wheels on the bottom, controls on
top). Any other position could create hazardous situation!
ON/OFF Switches
ё
Fa) |
600 700
WATTS WATTS
BOTH 1500 WATTS
=
e
WATTS ECONOMIZER
For more economical use, the Min. or Med. Watt
switches may be used individually, after unit has
reached the operating temperature.
With pilot lights ON, the heater is ON!
1. LOCATION
Place heater on the floor beneath the coldest window in the room, or any other location. Your hea-
ter will reduce the effect of cold drafts.
The heater should not be placed immediately below a power outlet.
Do not use this radiator in rooms with a floor area of less than 43 square feet (4 sq. m.).
2. CONNECTION
The radiator should be connected to a properly polarized A/C 110/120 V household outlet in
perfect working conditions.
Keep loose clothing or bedding, furniture and flammable material away from the heater’s wall
outlet.
3. TURNING ON TWO-SWITCH MODELS
Turn the thermostat clockwise to its maximum position. Push down both switches. The switch lights
stay on independently of the thermostat cycling. When room reaches the desired temperature, turn
the thermostat knob counter-clockwise very slowly and carefully until you hear a click. This should
set your heater to maintain the desired temperature by cycling on and off as required. (For timer
instructions, see paragraph 5.)
Note: The heater normally requires about 15 minutes to reach the desired temperature.
4. USE OF THERMOSTAT
The thermostat operates according to room air temperature, rather than radiator temperature.
Turning it counter-clockwise to smaller numbers would decrease the temperature; clockwise to
greater numbers would increase the temperature.
Antifreeze function
Turn the thermostat dial to the À position and push the switches on. The appliance will maintain a
minimum room temperature of approximately 42°F (5°C), thus preventing freezing while conser-
ving energy. In models that come with a timer, tabs must be set in the inward position.
REMINDER
To completely shut the heater off, ON/OFF switches must be set in the OFF position.
3. UNITS WITH TIMER
Clock setting
The program/timer, as with all clocks, must be set to the correct time. If for example the time is
9.30 a.m. (day zone), rotate the dial clockwise (following the direction of the arrow) until 9.30 is
aligned with the triangular pointer.
IMPORTANT:
DO NOT ROTATE CLOCK DIAL COUNTER-CLOCKWISE.
The timer is in effect an electric clock and would only work while it is plugged into a power supply.
When unplugged, the timer stops and must be later re-set.
Your product is equipped with a polarized alternating current line plug (a plug having one blade
wider than the other). There is only one way it can be plugged into a power supply. This is a
safety feature. If you are unable to insert the plug fully into the outlet, try again by turning it the
other way. If it would still not go in, it is probably due to an obsolete outlet which should be
replaced. Do not temper with the plug or outlet to defeat the purpose of this safety mechanism.
HOW TO USE THE TIMER
Please refer to the illustration below:
IMPORTANT: There are 96 tabs around the dial. Each tab represents a 1/4 hour (15 minutes) and
there is a tab for each quarter hour of the day (24 hours). Your appliance can be programmed to
switch itself ON and OFF at the time of your choice. With a timer you can approximate your set-
ting fo within 15 minutes and program up to 48 cycles (1 cycle = 1 “ON” + 1 “OFF”) over a
period of 24 hours (12 hours a.m.+12 hours p.m.).
The tabs can be pushed inwards or pulled outwards simply by using your fingers. When a tab is in
the inward position (towards the center of the dial), the heater will be on during the corresponding
15 minute period. If a tab is in the outward position, the heater will be off during that period.
Please note that when you first use your heater all the tabs are out. You must push in the tabs that
correspond to the period when you want the heater to be on. (If you want to bypass the timer you
must push all 96 tabs inward.)
Timer operation
A) Plug in the heater.
B) Turn timer dial clockwise to set clock with the current time of day (see CLOCK SETTING).
C) Push tabs inwards for the period you want the heater to operate. For example, in the shown
illustration, the heater will operate from 14.00 (2 p.m.) to 16.30 (4.30 p.m.) and from 4.45
a.m. fo 5 a.m.
D} Push switch(-es) in.
E) Once you have set the tabs for the desired heating periods, your heater will cycle on and off
according to these settings.
F) As long as you keep the heater plugged in, the timer will maintain the proper time.
A safety device
A safety device switches the heater off in the event of everheating. To restart the heater, call the
nearest Service center.
6. MAINTENANCE AND SERVICE
Always unplug the heater from the power outlet and allow the radiator to cool. Wipe radiator with
a soft damp cloth; do not use detergents and abrasives.
Should the radiator not be in use over a certain length of time, roll the cable around the holder
and store it in a dry place (see fig. on front page).
This appliance has been built to last for many years of trouble-free service.
In case of malfunction or doubt, do not try to repair the heater by yourself: this might increase the
risk of fire and electric shock.
Call nearest Service Center Visit www.delonghi.com for a completelist of Service Centers (U.S. Only).
(DeLonghi)
LIMITED WARRANTY
This warranty applies to all products with De Longhi or Kenwood brand names.
What does the warranty cover?
We warrant each appliance to be free from defects in material and workmanship. Our obli-
gation under this warranty is limited to repair at our factory or authorized service center of
any defective parts or part thereof, other than parts damaged in transit. In the event of a
products replacement or return, the unit must be returned transportation prepaid. The repai-
red or new model will be returned at the company expense.
This warranty shall apply only if the appliance is used in accordance with the factory direc-
tions, which accompany it, and on an Alternating current ( AC ) circuit.
How long does the coverage last?
This warranty runs for one year (1) from the purchase date found on your receipt and
applies only to the original purchaser for use.
What is not covered by the warranty?
The warranty does not cover defects or damage of the appliance, which result from repairs
or alterations to the appliance outside our factory or authorized service centers, nor shall it
apply to any appliance, which has been subject to abuse, misuse, negligence or accidents.
so, consequential and incidental damage resulting from the use of this product or arising
out of any breach of contract or breach of this warranty are not recoverable under this war-
ranty. Some states do not allow the exclusion or limitation of incidental or consequential
damage, so the above limitation may not apply to you.
How do you get service?
If repairs become necessary, see contact information below:
U.S. Residents:
Please contact our toll free hotline at 1-800-322-3848 or log onto our website at
www.delonghi.com.
For all accessories, spare parts or replacement parts, please contact our parts division at 1-800-
865-6330.
Residents of Canada: Please contact our toll free hotline at 1-888-335-6644 or log onto
our website at www.delonghi.com.
Residents of Mexico: Please refer to the Limited Warranty statement for Mexico.
Please refer to the back page of the manual for De'Longhi addresses.
The above warranty is in Tico of all other express warranties and representations. All
implied warranties are limited to the applicable warranty period set forth above. This limita-
tion does not apply if you enter into an extended warranty with De'Longhi. Some states do
not allow limitations on how long an implied warranty lasts, so the above exclusions may
not apply to you. De'Longhi does not ао any other person or company fo assume for
it any liability in connection with the sale or use of its appliance.
How does state law apply?
This warranty gives you specific legal rights, and you may also have other rights, which
vary from state to state.

advertisement

Related manuals

Frequently Answers and Questions

How do I know when the room has reached the desired temperature?
The switch lights stay on independently of the thermostat cycling. When the room reaches the desired temperature, turn the thermostat knob counter-clockwise very slowly until you hear a click.
What is the antifreeze function?
The antifreeze function maintains a minimum room temperature of approximately 42°F (5°C), thus preventing freezing while conserving energy.
How do I set the clock on the timer?
Rotate the dial clockwise until the correct time is aligned with the triangular pointer. Do not rotate the clock dial counter-clockwise.
How do I program the timer?
Push the tabs inward for the period you want the heater to operate. Each tab represents a 1/4 hour (15 minutes).
How many cycles can I program?
You can program up to 48 cycles (1 cycle = 1 “ON” + 1 “OFF”) over a period of 24 hours.
What happens if I want to bypass the timer?
To bypass the timer, push all 96 tabs inward.

advertisement

Table of contents