Morris MHT-60037 User manual

Morris MHT-60037 User manual
0+7
7(/(6&23,&&22.(5+22'
Thank you for choosing our product. Please read carefully the following
important information regarding installation, safety and maintenance.
Keep this information booklet accessible for further consultations.
COOKER HOOD INSTRUCTIONS MANUAL
MODEL: MORRIS MHT-60037
2
Dear Customer,
If you follow the recommendations contained in this Instruction Manual, our
appliance will give you constant high performance and will remain efficient
for many years to come.
RECOMMENDATIONS AND SUGGESTIONS
INSTALLATION
* The manufacturer will not be held liable for any damages resulting from incorrect or
improper installation.
* Please read this instruction manual before installing and using this range hood.
Please keep this instruction manual in a safe place for future reference.
* Only a qualified and trained service technician can undertake the work of installation
and servicing.
* Check that the main voltage corresponds to the one indicated on the rating plate fixed
inside the hood.
* If the hood is used in conjunction with non-electrical appliances (e. g. gas burning
appliances), a sufficient degree of ventilation must be guaranteed in the room in order
to prevent the backflow of exhaust gas. The kitchen must have an opening directly with
the open air in order to guarantee the entry of clean air.
* The minimum distance is 750mm from the range hood to a gas hob, and is 650mm
to an electric hob. If the installation instructions for gas hobs specify a greater distance,
this must be taken into consideration.
NOTICE: Two or more people are required to install or move this appliance. Failure to
do so, can cause physical injuries.
USE
* The range hood has been designed only for domestic use to eliminate kitchen fumes.
* Never use the hood for purposes other than what it has not been designed for.
* Never leave high naked flames under the hood when it is in operation.
* Adjust the flame intensity to direct it onto the bottom of the pan only; making sure that
1
it does not engulf the pan sides.
* Deep fat fryer must be continuously monitored during use: overheated oil can burst
into flame.
* The cooker hood should not be used by children or persons not instructed for its
correct use.
MAINTENANCE
* Proper maintenance of the range hood will assure proper performance of the unit.
* Disconnect the hood from the main supply before carrying out any maintenance work.
* Clean and/or replace aluminum grease filters and activated charcoal filters after
specified period of time.
* Clean the hood using a damp cloth and a neutral liquid detergent.
* DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of
such waste separately for special treatment is necessary.
WARNING!!
In certain circumstances electrical appliances may be a danger hazard.
* Do not check the status of the filters while the cooker hood is operating
* Do not touch the light bulbs after appliance use
* Do not disconnect the appliance with wet hands.
* To reduce the risk of fire or electric shock, do not use this fan with any solid-state.
* Avoid free flame, as it would do damage to the filters from a fire hazard
* Constantly check food frying to avoid that the overheated oil may become a fire
hazard
* Disconnect the electrical plug prior to any maintenance or servicing.
* Children do not recognize the risks of electrical appliances. Therefore, use or keep
the appliance only under supervision of adults and out of the reach of children.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards, including fire-rated construction.
b) Sufficient air is needed for proper combustion and exhausting of gases through the
flue (chimney) of fuel burning equipment to prevent back drafting.
c) When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
d) Ducted fans must always be vented to the outdoors.
x
Do not use this product outdoors.
2
x
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction,
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
x
There shall be adequate ventilation of the room when the range hood is used
at the same time as appliances burning gas or other fuels.
x
There is a fire risk if cleaning is not carried out in accordance with instructions.
x
The exhaust air must not be discharged into a flue which is used for
exhausting fumes from appliances burning gas or other fuels.
DIMENSIONS
INSTALLATION & USE
Ducting or circulation
The hood draws the cooking fumes saturated with
fumes and odor, through the grease filters and
expels it to the outside through an outlet pipe, or
circulates it back into the kitchen through carbon
filter.
3
Cautions: To reduce the risk of fire, the use of metal ductwork is preferred.
Do not use flammable material to convey exhaust air.
1. Decide where the ductwork will run between the hood and the outside.
2. A straight, short duct run will allow the hood to perform most efficiently.
3. Long duct runs, elbows, and transitions will reduce the performance of the hood.
Use as few of them as possible. Larger ducting may be required for best performance
with larger duct runs.
4. The air must not be discharged into a flue that is used for exhausting fumes from
appliance burning gas or their flue. Regulations concerning the discharge of air have
to be followed. Check with the local authority and building codes for exhausting ducting
requirements.
5.Install a roof/wall cap. Connect round metal ductwork to cap and work back towards
hood location
Electrical Connection
*Electrical wiring must be done by a qualified person(s) in accordance with all
applicable codes and standards. Turn off electrical power at service entrance
before wiring.
*If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
*Do not use the plug and an extension cord other than the ones initially supplied with
the hood.
INSTALLATION
Before beginning installation, for better handle of the hood, we advise removing
the aluminum filter.
Before fixing, the outlet exhaust duct for air evacuation to the outside must
be installed. Use an outlet exhaust duct with:
4
- Minimum indispensable length;
- Minimum possible bends (maximum angle of bend: 90°);
- Certified material (according to local, building & fire
regulations); and as smooth as possible inside.
It is also advisable to avoid any drastic changes in duct
cross-section (recommended diameter: 125mm).
Drill the hole in the wall for the air outlet (133
mm diameter) referring to drawings here on
the right where the measurements for the
various possibilities are indicated.
Decide on the position of the hole for the air
outlet: The hole must be in the ceiling,
according to your requirements, but must be in
vertical line with your hood. Bear in mind that
the hood can expel air through the top air outlet only.
Fitting under wall unit
1. Before fixing the hood to the wall
unit, drill a hole of 130mm diameter
in the wall unit.
2. In any case, check the position of
the power outlet considers where
the power cable will run, since a hole
might have to be made in the wall
unit to accommodate it.
3. Drill 4 holes in the wall unit,
respecting the distance indicated.
Push the hood up against the wall unit and insert the 4 screws operating
from inside the wall unit
4.Make the electrical connection.
Installation is now complete.
5
Notice:
-Exhaust air must not be discharged into a flue which is used for exhausting
fumes from appliance burning gas or other fuels.
-If the instructions for installation for the gas hob specify a greater distance
than 650mm, this has to be taken into account.
-The regulations concerning the discharge of exhaust air must be
followed.
OPERATION
The hood is operated using the touch control on the front panel.
From left to right, the sequence is Timer, Speed, Display, Lamp, On/Off.
1. Switch background light: red.
2. On/off: After power connection, touch "On/off" key to enter standby mode, with the
display shows "0".
3. Lamp: Touch the "lamp" key to turn on/off the lamp. Lamp is under independent
control, turning on/off the hood motor does not affect the lamp.
4. Display: The display shows the speeds and timer setting.
5. Speed: Touch the speed key to adjust the motor speed from speed1,2,3,....with the
Display shows the number accordingly.
6. Timer: When the hood motor is running, touch the "Timer" key to enter timer mode,
at the 1st touch, the Display shows"1", at this moment, touch "Timer" key can adjust
the timer time from 1 to 9 minutes, timer setting is done 10 seconds after the adjust.
End the timer mode with one more touch of the "Speed" key or "On/off" key.
6
MAINTENANCE
GREASE FILTER
The grease filters should be cleaned frequently (every two months of operation, or
more frequently for heavy use). Use a warm detergent solution.
Grease filters are washable.
LAMPS
This range hood requires one LED lamp (AC 230V, 2W Max).
Product Specification & Technical Parameters
Model
MHT-60037
Rated Voltage
230V
Rated Power Frequency
50Hz
Light Power
1x2W
Motor Power
1*230W
Total Power
232W
Motor
1
Diameter of Outlet Adapter
150mm, with adapter to 120mm
7
3URGXFWILFKH
Brand: 0255,6
Model name: 0+7
Energy efficiency classes of domestic range hoods (A-G)
B
Annual Energy Consumption - AEC hood (kWh/a)
72
Fluid Dynamic Efficiency classes for domestic range hoods (A-G)
c
Lighting Efficiency classes (A-G)
A
The Grease Filtering Efficiency classes (A-G)
C
Sound power level L WA - (dB)
68
Time increase factor - f
1,2
Fluid Dynamic Efficiency - FDE hood
21,1
Energy Efficiency Index - EEI hood
68,4
Measured air flow rate at best efficiency point - Q BEP (m 3 /h)
377,2
Measured air pressure at best efficiency point P BEP (Pa)
317,5
Maximum air flow - Q max (m 3 /h)
Measured electric power input at best efficiency point - W BEP (W)
Nominal power of the lighting system - W L (W)
Average illumination of the lighting system on the cooking surface - E middle (lux)
Measured power consumption in standby mode - P s (W)
Measured power consumption off mode P o (W)
630
157,8
2
56,2
-
0,47
Limitation of exhaust air - t limit (above 650m3/h) (min)
Lighting Efficiency LE hood - (lux/Watt)
28,1
Grease Filtering Efficiency GFE hood - (%)
78%
The air flow (in m3 /h, and rounded to the nearest integer),
at minimum and maximum speed in normal use, intensive or boost
excluded
If available, the air flow (in m 3 /h and rounded to the nearest
integer), at intensive or boost setting
The airborne acoustical A-weighted sound power emissions (in dB rounded to the
nearest integer),
at minimum and maximum speed available in normal use
If available, the airborne acoustical A-weighted sound power emissions (in dB rounded
to the nearest integer),
at intensive or boost setting
394min /630max
-
56min/68 max
-
Product fiche according to "COMMISSION DELEGATED REGULATION (EU) No 65/2014 "
NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality
materials and components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at
their end-of-life,
should be disposed of separately from your household waste.
Please dispose of this equipment at your local community waste
collection/ recycling centre.
In the European Union there are separate collection systems for used electrical and
electronic products.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Kalliopi Karyda & CO., LP states that this product complies with the
requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14 / 35 / EU
ErP Directive: 09 / 125 / EC
CE Marking: 93 / 68 / EEC
RoHS Directive 11 / 65 / EU & 15 / 863 / EU
The detailed declaration of conformity can be found at
www.morris.gr
Exclusive importer in Greece:
Kalliopi Karyda & CO LP
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki – Greece
T: +302316006600 | F: +302316006650
www.morris.gr
9
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement