George Kovacs GKTF01-084 Transformer-For Use Instruction Manual

Install the Transformer GKTF01-084/GKTF01-467/GKTF02-1-084/GKTF02-1-467

Step 1.Locate transformer(a) and transformer mounting hardware package in box(A)which contains 2pcs Screws and 3pcs wire nuts.

Step 4. Connect the white (neutral) wire from

the transformer to the white wire from the junction box .

use a wire nut to secure the connection.

A a

Step 2.Remove and set aside the 3 screws from the transformer to release the back plate.

Back Plate

Electrical box white wire

Transformer white wire

Step 5.Connect the black (hot) wire from the transformer to the black wire from the junction box use a wire nut to secure the connection.

Electrical box black wire

Transformer black wire

Step 3.Line up the back plate with the two screw holes from the junction box and secure the two screws supplied with the junction box.

Back Plate

Step 6.Tuck the wire nut connections into the electrical junction box. Slide the transformer housing up until the holes line up to the back plate,make sure all wires are tucked in.

secure it in place with the 3 screws previously removed.

Note: MAKE SURE THAT THE STAND OFF IS IN

ALIGNMENT WITH THE RAIL.

Step 4.Connect the bare (ground) wire for the transformer to the bare or green ground wire from the junction box use a wire nut to secure the connection.

Junction

Junction

Box Bare

Transformer

Bare wire

Stand off

IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A

QUALIFIED ELECTRICIAN TO ENSURE PROPER

WIRING AND INSTALLATION.

LA-1227E