Advertisement
Advertisement
USB Module Manual iportproducts.com/luxeport-support
2
GET TO KNOW
USB MODULE
BOX CONTENTS:
Power Supply USB Module Drill Template
The USB module was designed as an add on to your
LuxePort BaseStation. The USB module utilizes a larger power supply to provide charging to your iPad while docked to the Luxeport BaseStation as well as 2 additional 5W USB devices such as
2 phones, or 1 additional 10W device such as a tablet.
or
3
4
INSTALLING USB MODULE
INTO BASESTATION
Step 1
Insert the barrel connector from the provided power supply into the bottom of the USB module.
Step 2
Remove the USB-C cable from the BaseStation if installed and slide the USB
Module into the back of the BaseStation.
Once completed, additional devices can now be charged.
5
UNDER MOUNT USB
MODULE WIRE (OPTIONAL)
Step 1
Remove security foot from the BaseStation and place in the desired location.
For assistance in installation of the security foot, reference the BaseStation Manual.
6
Step 2
To properly align drill hole, insert the provided template into the security foot as shown.
Step 3
Mark the center hole and use a 5/8” (16mm) spade bit to drill through the table or desk.
Step 4
Run the power cable through the table and connect to the
USB module.
Step 5
Secure the BaseStation to the foot* and Slide USB module into place covering the hole for the cables.
* Refer to BaseStation Manual
7
For more help and info please visit: iportproducts.com/luxeport
CAUTION: This product contains magnets. Do not place in direct proximity with magnetically sensitive objects such as credit cards or exposed hard drives. Persons with pace makers are not recommended to use this product.
iPort
991 Calle Amanacer
San Clemente, CA 92673
United States of America
+1 949 226 5222
CAUTION: Use products as directed.
Unspecified use could result in injury.
Warranty can be found at iportproducts.com/warranty
33-7892

Public link updated
The public link to your chat has been updated.
Advertisement