INSTALLATION GUIDE - MUST BE READ IN CONJUNCTION with Pump & RainBank/s
Installation & Operating Instructions
WHERE MAINS PRESSURE EXCEEDS 600kPa.
A PLV* MUST BE FITTED TO INLET!
* Pressure Limiting Valve
NOTE: Australian Building Standards stipulate incoming mains pressure should not exceed 500kPa.
MAINS
WATER SUPPLY
TO TOILETS
AND/OR
LAUNDRY
(do not mix/cross-connect with mains water supply)
Stop valve 3/4" BSP M
3/4" BSP M
Power to pump via
3 pin socket - plug the rainwater pump in here.
1" BSP M
Incoming power to RainBank ® via 3 pin plug
200 Micron
‘Y’ Strainer
RAINWATER
SUPPLY from discharge of auto submersible rainwater pump
PLEASE NOTE: ILLUSTRATION NOT TO SCALE
ATS 5200.477 Lic WMKA 22042
IMPORTANT: ALL PIPEWORK AND OUTLET FITTINGS FROM RAINBANK MUST BE LABELLED TO
AS3500. DO NOT CONNECT WITH CRIMPED FITTINGS.
Davey Water Products Pty Ltd
Member of the GUD Group
ABN 18 066 327 517
AUSTRALIA
Customer Service Centre
6 Lakeview Drive,
Scoresby, Australia 3179
Ph:
Fax:
1300 232 839
1300 369 119
Email: [email protected]
Website: davey.com.au
NEW ZEALAND
Customer Service Centre
7 Rockridge Avenue,
Penrose, Auckland 1061
Ph:
Fax:
0800 654 333
0800 654 334
Email: [email protected]
Website: daveynz.co.nz
® Davey is a registered trademark of Davey Water Products Pty Ltd. © Davey Water Products Pty Ltd 2016.
P/N 401432-6
401432-6_RB_In_Tank.indd 1 23/11/2016 3:30 PM
