Vacuum Cleaner 1200W

8846

Instructions

A. Handle

B. Air intake control slide button

C. Extension Steel tube

D. Floor brush

E. Square brush

F. Crevice tool

G. Hose vacuum connector

H. Accessories Support

I. Hose

J. Power switch button (Speed control)

K. Carry-handle

L. Cable winding button

M. Dust capacity indicator

N. Fore cover

Warning

• Read this instruction booklet carefully

• This appliance is for domestic use only. Use as described in this instruction booklet.

• It is a class Ⅱ electric appliance, so it need not be earthed.

• Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the rating plate.

• Do not use the appliance to vacuum liquids, sharp items such as broken glass, hot ash etc.

• Keep the vacuum cleaner away from stoves and heatemitting appliance.

Heat can deform and discolor the plastic parts of unit.

• Do not block the flow of air. Blocking suction or allowing the dust to clog the hose will decrease the efficiency.

• Do not run the appliance over the power cable.

• Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations.

• Check the hose before use and do not use if damaged.

• If the supply cord is damaged do not use.

• Never use spirits or other solvents to clean the appliance. Only use a damp cloth and surface wipe clean only

• Never leave the appliance unattended when it is switched on. Keep the appliance out the reach of children or the infirm.

• Do not use the appliance without a dust bag or filters. Empty regularly for optimum performance.

How to use

1. Ready for use

Connect the extension tube C to the hose I and connect to the main body of the vacuum. Fix your chosen brush to the steel tube.

2. Operation

• Before using the appliance, unwind a length of cable and insert the plug into the power socket. A yellow mark on the power cable shows the ideal cable length. Do not extend the cable beyond the red mark.

• Press the ON/OFF button to switch the appliance on. Press it once more to turn off.

• Slide the air intake control button on the handle to adjust the suction. The greater air intake the smaller suction.

• Choose a suitable suction according to the surface to be cleaned. Also adjust the power switch J.

• For carpet use minimum air intake for powerful suction.

• For hard floors use medium air intake for normal suction.

• For fabric, curtains, sofas etc. use maximum air intake for soft suction.

3. Using the cleaning accessories

• On the Floor brush there are 2 settings.

Press down the button with mark “ ”and then use the brush with the bristles extended for hard floors.

• Press down the button with mark“ ━ ”and then use the bristles retracted for carpet.

• Square brush For cleaning smaller areas such as stairs.

• Crevice Tool For cleaning edges and hard to reach places.

4. Turn off the appliance

• Each time after use, press the on/off switch first and then remove the power plug from socket. To rewind the power cable, press the rewind button L with one hand, and guide the cable with your other hand to ensure that it does not cause damage when winding in. It will wind quite quickly!

Protective Device

• The indicator will become red when the air flow is obstructed or the dust bag is full. At that time, you should shut off the power, and clean the blockage or empty the bag. Then switch it on again. It is normal when the indicator is green.

How to maintain

1. Emptying the dust bag

• After removing the hose, open front cover by pressing the button and pulling upwards.

• Press the dust bag button backward and remove the dust bag.

• If the fabric bag is not in good condition, slide the plastic support from the top and dispose of the dust bag. Additional bags are available to purchase from

Customer Services on 0844 482 4400 or www.coopersofstortford.co.uk (while stocks last). Item number 8848.

• If the cloth bag is still ok, slide the plastic support from the top and empty.

Cleaning the filter

• If the filter is dirty, remove the filter.

• To clean or replace the air outlet filter, first detach the grille by pulling firmly away from the appliance.

• Remove the HEPA filter by opening the HEPA cover in the base.

• Wash carefully in liquid or water .Allow the filter to dry completely before replacing it.

Notice: Neither wash the cloth bag in washing machine nor dry it by electric heater, instead wash it in warm water and dry in natural air.

3. Clean the appliance and accessories

• Do not clean the body of vacuum cleaner with anything other than a barely damp cloth.

• Clean the debris adhering to the floor brush with an old toothbrush every month.

Troubleshooting

Trouble

Motor doesn’t work The plug is not plugged in

Suction decrease

Appliance heats

Cause

The filter is blocked

The bag is full

Resolve

Plug in

Clean it

Replace the bag or empty the bag

The flexible hose or extension tube is blocked Check and clear all blockages

Getting warm is normal. If the heat is excessive, turn off immediately and discontinue use

Technique parameter

Model No.

Power

FD2016 1200W

Voltage

220-240V 〜

Frequency

50Hz

Packaging

Dispose of the packaging at your local recycling centre.

Dispose of paper and card separately from plastic bags at your local recycling centre.

Dispose of the item at the end of its lifespan at your local authorised household waste recycling centre.