USB Environmental Protection Cover GT14-50UCOV
The USB environmental protection cover GT14-50UCOV protects the
USB connector on the front face of GT1455-QTBD(E) and GT1450-
QLBD(E) (hereinafter referred to as "GOT") from dust, water, and oil.
The GOT is installed with the USB environmental protection cover at factory shipment.
Replace when damage and deterioration are caused.
1. External Dimensions
4.4
(0.18")
34.7(1.37")
Unit: mm (inch)
2. Mounting Precautions
Make sure to turn off power of the GOT main unit before installing/ uninstalling the USB environmental protection cover.
For installation method of this product or cautions of use, refer to the manual of the GT14 main unit offered separately.
Referenced Standard: GB/T15969.2
(Requirement of Chinese standardized law)
Jun. 2018
JY997D44301E Made in Japan
3. USB Environmental Protection Cover Replacement
Procedure
1) Turn the GOT power off.
2) Disconnect the USB cable from the
GOT if one is connected.
3) Open the USB environmental protection cover equipped with the GOT and remove the mounting screws.
4) Remove the old USB environmental protection cover from the
GOT to replace it with the new USB environmental protection cover.
5) Fix the projection of the new USB environmental protection cover to be fitted into the hole of the GOT, tighten the mounting screw in the specified torque range, then install it to the GOT.
Tighten the mounting screws in the specified torque range.
Not doing so may cause a damage or a drop.
USB environmental protection cover
Open
Mounting screw
Tightening torque 0.36 to 0.48 N•m
