- Computers & electronics
- TVs & monitors
- Wall & ceiling mounts accessories
- Pyle
- View PLCM37FRV
- User manual
advertisement
Specifications
Images sensors:
Power upply:
MT9V011
DC12V
Lens Angle(Deg.):
TV System:
Video Output:
S/N Ratio:
IP rating:
170
PAL/NTSC
1.0vp-p,75ohm
48dB
IP67
-30 ~ +70 Operating
Temperature(Deg.C):
RH95%MAX.
White Balance:
Minimum illumination:
AGC:
Resolution(TV Lines):
Auto
0.5Lux
Auto
420
1/60(NTSC) 1/50(PAL) Electronic shutter
1/10,000second
Effective pixels: 640*480
The above parameters can be modified without separate notification
Universal Mount Optional Front
View & Rear View Backup Color CMD
Camera Built-In Distance Scale Line
Model : PLCM37FRV
User Manual
Visit us online
@ w w w .PyleAudio .com
1. Wire connection
2. Installation
The camera can be installed in the following ways:
A. Bracket-mount (see diagram 1)
B. Flush-mount (see diagram 2)
C. License plate screw-hole mount (see diagram 3)
Car body
Car body
Green, Brown, and White:
Control
Wires
(A)
Red Wire:
Power
(B)
Yellow Wire:
Video Out
Connect the 12V power to the red wire (A) using the included 1.2m cable. Use the included 5m cable to connect the yellow wire (B) to your video monitor.
For further control, use the control wires (C). Connect power wire, and then connect brown and green wires to reverse the image. Connect brown and white wires first and then connect power wire to show distance lines onscreen .
(diagram 1) (diagram 2) (diagram 3)
2.1: Bracket-mount: Install in the rear bumper or on the license plate. Affix with screws.
2.2: Flush-mount: Install by drilling a hole on the rear bumper.
2.3: License plate camera: Mount in the screw hole on the license plate, then affix with a nut.
Attention: The camera switch is controlled by the reverse gear shift.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project