Supermicro Super X6DHR-TG User Manual Addendum
Advertisement
Advertisement
Addendum to X6DHR-TG Motherboard User’s Manual
Attention!!
Important Notice!!
(Read the information listed below before using this product.)
Jumpers J4F4/J4F5 (PLLSEL Select): These jumpers allow the user to select PLLSEL (Memory Speed). Make sure that the jumper settings are set correctly according to your memory speed before you power on the system.
(*Warning!! If these jumpers are not set correctly according to your memory speed, video display failure may occur!!!)
(*Note: the default setting is “Closed” for both jumpers to enable DDR Memory at 333MHz. However, if your memory speed is 266MHz, please make sure to set both jumpers to “Open”.)
PLLSEL Select
Jumper Settings
(J4F4/J4F5)
DDR
*333 MHz
266MHz
J4F4 J4F5
Closed Closed
Open Open
(*Default:Closed-333MHz)
J4F4/J4F5
K B
U S B
0 / 1
DIMM 1A
DIMM 1B
DIMM 2A
DIMM 2B
DIMM 3A
DIMM 3B
DIMM 4A
DIMM 4B
PW SMB
Bank1
Bank2
Bank3
Bank4
CPU1
4 Pin
PWR
8 Pin
PWR
12V 12V
20-Pin ATX PW
JP11
PWR
Fail
JP10
F A N 1
FAN2
G L A N
C T R L
GLAN1
GLAN2
IPMI 2.0
PCI-X 100 MHz
PCI-X 133 MHz
E 7 5 2 0
(North Bridge)
Graphic
Memory
S I/O
RAGE-
X L
Battery
P X H
S P K R
JPL1
JPG1 SMB IPMB COM2
PCI-Ex8
PCI-Ex8
CPU2
J 4 J 3
ZCR RAID
WOR
ICH5R
(South
Bridge) SATAII
JBT1
U S B 2 / 3
BIOS COM2
J S 9
J W D JOH1 J L 1 J D 1 WOL Fan3
Add-X6DHR-TG-11/10/04

Public link updated
The public link to your chat has been updated.
Advertisement