Instruction Manual
Window Wiper
AFW900
(Read carefully before use)
When using electrical appliances, basic precautions should always be followed, including the fact READ ALL INSTRUCTIONS IN THIS MANUAL PRIOR
TO USE AND FOLLOW ALL INSTRUCTIONS RECOMMENDED, particularly to avoid the risk of fire, electric shock, injury or damage to your device.
We recommend that you keep this booklet carefully and refer to them in case of problems or doubts of use, and transmit to all prospective new owners.
Safety Recommendations
•
This appliance is intended for domestic use only.
•
This appliance is not intended to be used by persons whose physical, sensorial or mental abilities are reduced (children and teenagers included), or by persons without any experience or knowledge, except if they have been given supervision or preliminary instructions for use of the appliance by somebody responsible for their safety.
•
Children shall be supervised to ensure they do not play with the appliance.
•
In hazardous locations (service station for example) you must comply with the relevant safety requirements.
•
In dangerous places with explosion risks, use is forbidden. Do not place the appliance near a source of heat.
•
Never plunge the appliance in water or any other liquid.
•
Never leave the appliance unattended when plugged.
•
Never leave packing materials (plastic bags, polystyrene, etc .) within reach of children, as these are sources of potential danger.
•
Do not connect the device to an outlet whose voltage is not in accordance with the manufacturer's instructions, listed on the nameplate on the charger or on the device.
•
Use only original wipes.
•
Always unplug the appliance after use and when it is not being used.
•
To avoid any risk of electric shock, do not dismantle or attempt to repair the appliance on yourself.
•
If the power cable is damaged, it should be replaced by the manufacturer, its after-sales service or similarly qualified technical persons in order to avoid any danger.
•
In case of damage or malfunction, you must contact your distributor or an authorized service center.
•
Never insert objects into the ventilation slots. (12)
•
Never touch the power plug with wet hands.
•
You should under no circumstance dismantle the device by yourself under penalty of cancellation of the warranty.
•
Avoid liquid splashes on electrical components, such as plug, switch, cable, stereo equipment, computer screen, or appliances.
•
Do not use the appliance on delicate or glued materials: water paint, silk, terylene, leather, velvet, wallpaper, unvarnished wood, waxed or glossy wood, or any other materials not resistant to moisture. In case of doubt regarding
resistance of the support to moisture, it is better to always test the surface to be cleaned on an invisible part by rapid passing .
The manufacturer does not assume any responsibility in case of damage of any support to be cleaned.
•
After each use, empty and rinse the tank (6) , never forget to wash the small filter
(8) and put it back.
•
Only use the appliance on smooth, solid, flat surfaces that are able to withstand moisture.
•
Do not add additives, dangerous goods as caustics or acids, or cleaning products not originally intended for the same type of cleaning. Only use clear and pure water.
PARTS OF THE APPLIANCE
HOW TO USE YOUR WINDOW CLEANER
Charging the battery
Connect the charger to charger socket (11) and take the terminal on the other hand to power supply, which must comply with the standards. A red light will illuminate and change to green when the battery is fully charged.
We recommend that you unplug your charger when charging is fully completed
(green light on) after 2 hours of charging
It is better to store the unit only after recharging for optimum battery life.
Filling and cleaning the tank
1 Open the tank cap (7) remove the small filter (8) Figure 1, fill the tank with clean water by slightly tilting the appliance (head down), Figure 2 , to facilitate the exit of air. The appliance must be disconnected from the charger during all operations. Then replace the clean filter and cap.
After each use, empty and rinse the tank (6) , never forget to wash the small filter (8) and put it back.
Never place the appliance under the tap to fill the tank without first unplugging the charger, Figure 3.
Effectiveness
With its EMERY wipe this appliance does not need detergent but in case of heavy dirt or in heavily polluted environments, diluted cleaning products may be added or even just a few drops vinegar or alcohol. This solution is more convenient, ecological and economic.
Finish off your cleaning with the microfiber wipe.
Cleaning
Press on the spray trigger (2) Figure 4 , and place the water or the mixture on the surface to be cleaned by directing the spray (10) in its direction. You can turn around the device by grasping handle B , and then you can rub your smooth surface with either one of the 2 wipes.
Once this is done you return your hand to handle A and suck the water through the scraping joint (4) by scraping up and down while maintaining the suction control (1) at on position Figure 5 . It is not necessary to press too hard on the device during the finishing scraping operation.
Sometimes a slight grip is necessary to achieve best results.
Do not project spray to eyes with or without product, or on surfaces of electronic components, such as plug, switch, cable, stereo equipment, computer screen, or household appliances.
Replacing the water tank
The dust and dirt is left on the cloth and the residual water is sucked for recycling.
Generally, it is not necessary to change the water in the tank too often during use. You can, depending on the state of cleanliness of the surfaces. Recycled water may have a little color but will not affect the result of expected cleanliness.
Setting and cleaning wipes
Put the wipe support (3) in front of you Figure 6 , then position the pad in place taking care to keep even the entire length, then press the entire surface to increase the effect of scraping.
The change of wipe will simply be made by tearing it off Figure 7 .
Wipes should be replaced regularly during work according to their cleanliness. We cannot give you an idea of the rate of change, it varies and it is at your sole discretion. These wipes are machine washable. You do not have to iron or use fabric softener or bleach, and do not put in dryer.
Charger
•
The charger must not be exposed to direct sunlight, fire, or heat, as there is a risk of explosion.
•
Never insert objects into the charger socket.
•
In case of unexpected loss or destruction of your charger, do not use any other charger than the original. Contact your supplier immediately. Otherwise any other charger with the same characteristics would likely destroy your device.
•
Never attempt to repair the cable from your charger. If it is damaged, replace it.
•
Before you connect your charger, make sure the voltage of your power outlet is the same as indicated on the label.
•
Never unplug the charger by pulling the cable but take care to grasp the plug. It is advised to store your charger in dry area between 5°C and 40°C maximum.
•
Never open your charger, potentially harmful substances may emerge and affect your health, and short-circuit is always possible.
Battery charge level
Your appliance is equipped with 2 safety systems: one is the battery and the other is the electrical circuit. They cut the battery when necessary so as not to over
discharge which would be detrimental to your battery life. Therefore there is no monitoring or control light, your device automatically stops.
Technical problems and solutions
Problems encountered Possible identifications
The device suddenly stops or does not start
Battery charge is too low
Proposed solutions
Recharge the battery
No liquid spray Needs more cleaning water
Exit hole is blocked
Fill the tank
Unclog the exit
Marks are left on cleaned surface
Scraping joint is dirty
Wipe is dirty
Scraping joint is damaged
There is too many detergent
Water is dirty
Clean the flexible seal
Replace clean wipe
Replace the scraping joint
(Service assistance)
Reduce the dosage
Change water in tank
All these solutions are basic elements to perform before any requests for technical assistance. For all other possible problems, contact your dealer or the manufacturer.
Specifications
(subject to technical modifications)
Nominal power of the appliance
Nominal LITHIUM battery voltage
8
3.6
Watts
Volts
Nominal battery capacity
Nominal charger voltage
Nominal charger capacity
Duration of use in full charge
Maximum charging time
Tank volume
2000
5
900
30
2
130 mAH
Volts mAH
Minutes
Hours ml
Noise level
Product weight
Working width
62
0.7
28 dB(A)
Kg
Cm
This appliance complies with CE, IPX 4, EMC, Low Voltage, Reach, and ROHS regulations.
