AIRFLO AFV67A Instruction Manual
Airflo AFV67A is a powerful wet and dry vacuum cleaner with a variety of features that make it perfect for any cleaning job. With a powerful 800W/1000W motor, it can easily suck up both wet and dry messes, and its large 16kpa of suction power ensures that it will get the job done quickly and efficiently.
The Airflo AFV67A comes with a variety of attachments that make it perfect for any cleaning task. The small brush is perfect for getting into corners and tight spaces, the floor brush is perfect for carpets and floors, the flat suction nozzle is perfect for crevices and corners, and the blowing port is perfect for blowing out dust from the crevice of the machine.
advertisement
INSTRUCTION MANUAL
Wet and Dry
Model AFV67A
Wet and Dry Diagram
2
Important Safeguards
1. Please do not use the vacuum cleaner near any liquid or gas which is flammable or explosive to avoid injury.
3. Please do not touch the plug when your hands are wet to avoid getting an electric shock.
5. Do not vacuum the following objects: Non-extinguished cigarettes, gas, kerosene, and other objects which may be flammable, explosive or volatile.
2. Before you plug in / out, turn off the power to avoid fire or get an electric shock.
4. Please do not plug up the vent in order to avoid damaging the machine as the temperature may get too high.
6. Do not pick up sharp objects.
7. Avoid vacuuming print toner, lime powder, gypsum and the like as it may damage your vacuum’s motor.
8. During use, there is a slight chance that the tube or machine could generate electricity so please take extra care.
9. Be careful not to tip your appliance in order to avoid water going into the vacuum’s
10. Warning: Do not use this product as water pump to avoid damaging the machine.
11. When cleaning the appliance or not in use, turn off the power and plug out.
12. Please do not put the appliance under the sun or other high-temperature places to avoid the plastic deforming.
13. The tube should not be stretched excessively or it may damage the tube.
14. Do not immerse or rinse the container in water to avoid electrical components getting wet which may cause accidents. To clean, use a soft and moist cloth to wipe the surface.
How to Install
A. Linking up the tube and the
Vacuum cleaner:
Insert the tube connector into the cleaner and then rotate it clockwise until it locks.
To disconnect: Simply rotate it counter-clockwise
.
B. To use the blowing function
:
Insert the main suction pipe into the blowing port then rotate it clockwise until it locks.
C. Connecting hand lever and long link pipe:
Contact joint: insert one end of the tube into the long link pipe's inside diameter, then rotate it clockwise until it's tight.
To disconnect: Hand both ends of the long link pipe, rotate it counter-clockwise until it's out.
How to Use
1. Power on
Insert the plug into the socket.
Turn on the switch.
2. Air register
Adjust the suction by opening the air register block. The suction will then gradually decrease. Once you close it, the suction will gradually increase.
Accessories
Small brush is suited for corners and tight areas, as well as windows, tables, etc.
Great for dusting.
Flat suction nozzle is suited for crevices and corners.
Floor brush is perfect for carpets and floor.
Blowing Port is perfect for blowing out dust from the crevice of the machine.
Special Instructions
1. When the water in the barrel is full, suction will stop. To restart suction: first cut off the electricity and throw out the water. Then turn the machine on. It will work normally again.
2. Only connect to a proper 220- 240 volt / 50 Hz socket.
3. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent to avoid a hazard.
4. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
5. Children should be supervised to ensure that they do not play with the appliance.
6. The plug must be removed from the socket before cleaning or maintaining the appliance.
Maintenance Method
1. Dust container should be emptied when full, otherwise the vacuum will not function well. To clean: turn off the power supply and clear the rubbish inside container.
2. Take out of the filter bag, clear the dust from inside the dust container. Filter bags must be thoroughly cleaned with clean, warm water. If necessary, you can use neutral cleaning detergents.
3. Put the filter bag back to its original position.
Voltage Rating:
Rated Frequency:
220-240V~
50Hz
Rated Input Power: 800W/1000W
Maximum Suction: 16kpa
advertisement
Related manuals
advertisement