Whirlpool WME36252 W Refrigerator Program Chart

QUICK START GUIDE
ON/STANDBY function
To put the product in
Stand-by, press and hold
the On/Standby button
for 3 seconds. All the
temperature indicators turn
off. Press again to reactivate
the appliance. (see the
Instructions for Use)
1
2
3
4
16
5
12
7
X
TEMPERATURE button
X
8
9
10
Led ON
17
11
13
14
15
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
ON/STANDBY button.
18
6
19
Main LED’s lighting
Fan*
Electronic control panel / light unit
Lighting in Multi-flow*
Shelf divider*
Multi-flow cold air area*
Bottle rack *
Sensor cover
Zero degrees drawer*
Rating plate with commercial name
Cooler compartment* (best for meat and fish)
Area shelves
Fruits and vegetables crisper
Crisper divider*
Door reversibility kit
Egg tray*
Bottle holder*
Door trays
Door seal
Important: The refrigerator compartment light switches on when the
refrigerator door is opened. If the door is kept open for more then 8 minutes
the light will be automatically switched off.
high temp.
med-high temp.
med-high temp.
The function is automatically deactivated after 6 hours and
return to previous selected set point. The function can be
manually deactivated by press Temperature button on the
control panel.
medium temp.
med-low temp.
low temp.
Fast Cooling
Led ON
Led OFF
Note: Displayed set points correspond to the average
temperature throughout the whole refrigerator.
6th SENSE FRESH CONTROL
This function automatically works
to ensure the optimal conditions
to preserve the stored food.
FAN
The Fan improves temperature distribution inside the refrigerator compartment, allowing better preservation of stored food. By default, the fan is switched on.
Fan deactivation/reactivation: Fan is active by default.
To deactivate/reactivate the fan follow the process described below:
- Push the Light Button as indicated in picture 2: the light will switch off;
- Without releasing the Light button, keep pressed the Temperature button too as indicated in picture 3: the light will blink once if the fan has been deactivated (OFF) , or it will
blink three times if the fan has been activated (ON).
HOW TO START THE APPLIANCE
After plugging the appliance to the mains, it starts the
operation automatically. After starting the appliance, wait
at least 4-6 hours before placing food into the appliance.
When the appliance is connected to the power supply,
the display lights up and all the icons appear on the
display for approximately 1 second. The default (factory)
values of the fridge compartment settings light-up.
Specifications, technical data and images may vary
from model
high temp.
medium temp.
FAST COOLING function
The use of the Fast Cooling function is recommended:
med-low temp.
- to increase the cooling capacity of the refrigerator
low temp. of food within
compartment when placing a very high quantity
it,
To activate the Fast Cooling function, press the Temperature
button cyclically on the control panel till all the 3 LEDs blink and
remain on.
REFRIGERATOR LIGHT
The light system inside the refrigerator compartment uses LEDs light,
allowing a better lightning as well as a very low energy consumption.
If the LED light system does not work, please contact the Service to replace
it.
* Available on selected models
HOW TO REVERSE THE DOOR SWING
- see enclosed Instructions for Use
Is recommended to reverse door swing by two persons.
There is not foreseen door reversibility for:
- models with integrated handle
- models with glass panel on the door.
Led OFF
TEMPERATURE setting
Press the Temperature button on the control panel to adjust
the temperature from the warmest through the lower to the
coldest level.
Pressing the Temperature button, the temperature setting
will change cyclically.
At first plug-in of appliance temperature setpoint is present at
medium position (factory setting).
Following table shows temperature setpoints:
Note: Deactivation of the fan switches off function 6th Sense Fresh Control in the fridge.
ALARMS TABLE
ALARM TYPE
Signal
Cause
Cure
Door open alarm
Refrigerator Light blinks
The door has remained open for more than 5 minutes.
Close the door
Door open alarm
Refrigerator Light OFF
The door has remained open for more than 8 minutes.
Close the door
Malfunction
Any temperature indicators blinks
Product malfunction.
Contact the After-sales Service
DE GB FR
NL
ES
PT
IT
GR SE NO DK
FI
PL
CZ
SK HU
RU
BG RO
UA
KZ
AE
07/14 - Whirlpool® Registered trademark/TM Trademark of Whirlpool, USA - © Copyright Whirlpool Europe s.r.l. 2014. All rights reserved - http://www.whirlpool.eu
Indicator LEDs to display the current temperature setpoint or the Fast
Cooling function.
Printed in Italy
Read the Instructions for Use carefully before
using the appliance.
EN
5019 320 00120/A

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project