GB LOE 613
A. “Door open” indication
This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately, e.g.:
B. “Service” indication
C. “Water tap closed” indication
D. “Clean pump” indication
Programme
Cotton with prewash
95 °C
Cotton
40 - 60 - 95 °C
Synthetics with prewash
60 °C
Synthetics
30 - 40 - 60 °C
Delicates
30 °C
Quick wash
30 °C
Wool
Cold - 40 °C
Handwash
30 - 40 °C
PROGRAMME CHART
C
D
G
E
Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
Textiles made of linen, silk, wool and viscose marked as “handwashable”.
H
Type of wash/Notes
Care
Labels
- for temperature selection, respect the manufacturer’s recommendations on the care label
Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc.).
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Curtains and delicate clothing, dresses skirts, shirts and blouses.
Max
Load kg
5.0
5.0
2.5
2.5
1.5
3.0
1.0
1.0
F
A
B
E. Programme selector
F. “Start/Pause” button
G. Programme sequence indicator
H. “Reset” button
Detergents and additives
Prewash
Main wash
Softener
Yes
—
—
—
—
—
—
—
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
❉
❉
❉
❉
❉
❉
❉
❉
Special options
Half load
No Spin
Spin
Speed
❉ ❉ rpm
600
❉
❉
❉
—
—
—
—
❉
❉
❉
❉
❉
❉
❉
600
600
600
600
600
600
400
1)
Rinse & Spin — Same as the last rinse and the final spin in the “Cotton” programme.
5.0
— — ❉ ❉ ❉
600
Spin —
—
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
Gentle Spin In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Drain — Water is drained only without any spinning.
❉
: optional / Yes : dosing required
1)
For improved garment care, spin speed is restricted to 400 rpm in this programme.
5.0
1.0
—
—
—
—
—
—
—
—
—
—
—
—
—
❉
❉
—
600
600
—
5019 501 10107
CONSUMPTION DATA
Programme
Cotton
Cotton***
Cotton
Synthetics
Synthetics
Delicates
Quick wash
Temperature
(°C)
95
60
40
60
40
30
30
Load
(kg)
5.0
5.0
5.0
2.5
2.5
1.5
3.0
Water
(l)
49**
49
49
50**
45
50
40
Energy
(kWh)
1.90
0.95
0.60
0.70
0.55
0.50
0.40
Approx. Programme
Duration
(hours : minutes)*
2:00
2:20
2:00
1:30
1:15
0:45
0:30
Wool
Handwash
Handwash
40
40
30
1.0
1.0
1.0
55
45
45
0.60
0.60
0.50
0:45
0:40
0:40
Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
* The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable at that time.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
*** Reference Programme for Energy Label.
ADD DETERGENTS, CLOSE THE DOOR
AND SELECT THE PROGRAMME
Add detergent as indicated on the front page and as described in your Instructions for Use. Close the door and turn the programme selector to the desired programme and temperature. The indication lamp next to the “Start/Pause” button flashes.
SELECT ANY DESIRED OPTION
Push the button(s) of any option(s) desired - the respective indication lamp lights up.
When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically.
“Half load” button
• Reduces water consumption, above all during rinsing.
• Suitable for lightly soiled laundry and small loads
(max. 3 kg).
“No Spin” button
• Especially for delicate garments to avoid wear and tear caused by the spin.
Note: with the “Cotton” and “Synthetics” programmes, a short spin cycle is provided in any case, even if the “No spin” option has been selected, in order to optimize rinsing results.
PROGRAMME START
Open the tap and press the “Start/Pause” button.
The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/
Drain.
When the programme phase is finished, the corresponding indication goes out.
“DOOR OPEN” INDICATION
Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel
(Reset) a running programme before the end”.
RED INDICATIONS
“Service”
Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the
“Troubleshooting Guide” in your “Instructions for
Use”; if the fault persists, contact our After Sales
Service.
“Water tap closed”
The appliance has no or insufficient water supply.
Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the
Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use
(“Removing the Filter”).
PROGRAMME END
• All the lights of the programme sequence indicator are off, and the “Door open” indication lights up.
1. Turn the programme selector to the “Off/O” position.
2. Close the water tap.
3. Open the door and unload the machine.
4. Leave the door ajar to allow the drum to dry.
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
1. Press the “Start/Pause” button to pause the programme. The light flashes.
2. Select the new programme (with temperature), any options and another spin speed if you want.
3. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme.
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
The “Reset” button cancels a programme before the end.
• Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened.
5019 501 10107
