Aries Offroad 111001 Installation Instructions
Aries Offroad 111001 is a headache rack designed to fit 1999-2012 Ford F250 Super Duty trucks. It provides additional protection for the rear window and cab of the truck, and can also be used to mount accessories such as lights or a ladder. The headache rack is made of steel and is powder coated for durability. It is easy to install and comes with all necessary hardware.
Advertisement
Advertisement
INSTALLATION INSTRUCTIONS
1999-2012 FORD F250, SUPER DUTY
(LARGER MULTI FIT BLACK) PART # 111001
PARTS LIST:
Qty Description
1
Headache Rack
1 Driver/Left Mounting Bracket
1 Passenger/Right Mounting Bracket
4 12mm x 40mm Hex Bolts
Qty Description
4 12mm x 50mm Hex Bolts
8 12mm Lock Washers
16 12mm Flat Washers
8 12mm Hex Nuts
Headache Rack
Driver/left side
Mounting Bracket
Passenger/right side
Mounting Bracket
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. From the list above select the Driver/Left side mounting bracket and secure to the bottom of the outside mount of the Headache rack with (2) 12mm x 40mm Hex Bolts, (4) 12mm Flat
Washer, (2) 12mm Lock Washers and (2) 12mm nuts, repeat this process for Passenger/right side mounting bracket, (Fig 1) shows Driver/left side bracket attached to Headache rack, Snug but do not tighten hardware at this time.
3. Next, with help place the Headache rack up on the upper rails of the trucks box and begin to align the rack to the edge of the truck box (were the box ends not to where it meets the cab)
(Fig 2) shows brackets lined up on the truck rails, ounce you have it aligned and are satisfied with the look and fit mark your mounting holes, and begin to drill the 12mm holes on the upper rails ounce done fasten the Headache rack to the truck rails with (2) 12mm x 50mm Hex Bolts,
(4) 12mm Flat Washer, (2) 12mm Lock Washers and (2) 12mm nuts per side (Fig 2A & 2B) shows bracket attached to Truck rails, Snug but do not tighten hardware at this time.
4. Level and align Headache Rack properly; then tighten all hardware at this time.
5. Do periodic inspections to the installation to make sure all hardware is secure and tight.
DRIVER SIDE SHOWN
Fig 1 Fig 2
Fig 2A
Install mounting bracket with
(2)12mm x 40mm Hex bolt
(4)12mm Flat washer
(2)12mm lock washer
(2)12mm Nuts
Secure brackets to rail with
(2)12mm x 50mm Hex bolt
(4)12mm Flat washer
(2)12mm lock washer
(2)12mm Nuts
Driver side shown repeat for passenger side
Mark front & back holes then drill with
1/2" bit for mounting bracket
Driver front side shown repeat for rear
& passenger side
Fig 2B

Public link updated
The public link to your chat has been updated.
Advertisement