advertisement
AquaCal AutoPilot
Quick Start Guide
LTM0000 REV 1
SECTION 1 - GENERAL INFORMATION
1.1 Contacting AquaCal AutoPilot
Please have your model and serial numbers available when contacting your local authorized service partner for questions, service, or parts. Contact AquaCal AutoPilot for a service partner in your area.
Web www.AquaCal.com
Phone (1) 727-823-5642
Hours 8-5 pm, Eastern M-F
Table 1 - Contacts
1.2 Additional Information
Please go online at www.AquaCal.com for additional information regarding your equipment including: l l l
Maintenance Instructions (including winterizing)
Equipment Specifications
Additional Troubleshooting
SECTION 2 - OPERATION
2.1 Control Panel
The following information outlines the operation for a standard installation.
Control Buttons will operate differently for custom installations; such as a heat pump connected to an external controller.
Figure 1 - Control Panel
2.1.a Indicator Lights
Indicator
“Pool”
“Spa”
“Cooling”
“Desired Temp”
“Water Temp”
“Heating”
Table 2 - Indicator Lights
Page - 1
Description
Heat Pump is referencing the pool thermostat.
Heat Pump is referencing the spa thermostat.
Indicates unit is cooling water.
Please note - the compressor must be operating before this light will illuminate.
Indicates temperature set point is displayed. This is displayed when “UP” or “DOWN” is selected.
Indicates current water temperature.
Indicates unit is heating the water.
Please note - the compressor must be operating before this light will illuminate.
2.1.b Buttons
Please note - Buttons are inactive if unit under external control.
“ULC”
“ELC”
“LOC”
Button
Display Lock
“Pool / Spa”
Up Arrow
Down Arrow
“Mode”
Table 3 - Control Buttons
2.1.c Display
Display
“000”
“FLO”
“OFF”
“888”
“CFI”
Description
Sliding your finger across the buttons from left to right will disable the display lock.
Select either the pool or the spa thermostat.
Increase temperature set point.
Decrease temperature set point.
Select heat pump operating mode.
Description
Heat Pump is on and displaying current water temperature.
No water flow is detected. Circulation pump is off or
Heat Pump is not receiving correct water flow.
Heat Pump has been turned off via the mode selector button or the temperature set point has been lowered below 45° F.
Control program is initializing. This displays only as power is applied to the heat pump. The program version number will then be displayed.
Select water temperature format (in either Celsius or
Fahrenheit).
Enable heat pump lockout feature.
Select password to lock keyboard.
This is a Service Entry Point (not intended for use by the owner). The[LOC] code permits service personal to enter a factory code for access to adjustable calibration and site dependent setup parameters. Service adjustments are available to authorized installation and service personnel, only.
Table 4 - LED Display
Page - 2
advertisement
Related manuals
advertisement