GE GFD14ESSNWW 24" 4.3 Cu.Ft. Front Load Vented Electric Dryer Installation instructions


Add to my manuals
4 Pages

advertisement

GE GFD14ESSNWW 24

GFD14ESSNWW

GE ® 4.3 Cu.Ft. Capacity Electric Dryer

ELECTRIC DRYER RATING

240V 2800W, 12A, 60Hz

CIRCUIT REQUIREMENTS: An individual, properly grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay fuse, is required.

NOTE: Dryer wall outlet must be located within

36" of service cord entry and accessible when dryer is mounted in position.

INSTALLATION INFORMATION: For complete information, see installation instructions packed with your dryer.

Front View

(59.5 cm)

23-7/16"

(59.5 cm)

*33-1/4"

(84.5 cm)

Back View

Back View

(52.1 cm)

30"

(76.2 cm)

30"

(76.2 cm)

3-9/10"

(9.9 cm)

7-3/4"

(19.7 cm)

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

42-13/16"

42-13/16" (108.7 cm)

Side View

Side View

25-1/4" (64.1 cm)

25-1/4" (64.1 cm)

*33-1/4"

(84.5 cm)

*33-1/4"

(84.5 cm)

18-1/10"

(45.9 cm)

18-1/10"

(45.9 cm)

Side View

Side View

3"

(7.8 cm)

5-1/5"

(13.2 cm)

5-1/5"

(13.2 cm)

Specification Revised 4/20

GFD14ESSNWW

GE ® 4.3 Cu.Ft. Capacity Electric Dryer

SPECIAL INSTALLATION REQUIREMENTS:

ADA Compliance: 4" ADA riser and drip pan for 24" frontload model: GAF140SSNWW

ALCOVE OR CLOSET INSTALLATION:

Stacking Kit - GFA24KITL (not included)

If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 1" left and right sides, 1" top, 3" front and rear.

Minimum clearances between washer cabinet and adjacent walls or other surfaces are: 1" left and right sides, 1" top, 1" front and rear.

Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of

120 sq. in. of open area equally distributed.

No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

BATHROOM OR BEDROOM INSTALLATION:

The installation must conform with the local codes, or in the absence of local codes, with the National Electric Code and National Fuel Gas Code,

ANSI Z223 for gas dryers.

MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET

INSTALLATIONS:

Minimum clearances to combustible surfaces 0" both sides, 3" rear.

FOR MORE INFORMATION ON VENTING KITS AND

ACCESSORIES,

PLEASE CALL 1-800-GE-CARES.

66 1/2"

STACKED DIMENSIONS (IN INCHES)

23 7/16" 25 5/8"

3 3/8"

20 1/2"

33 1/4"

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

Specification Revised 4/20

GFD14ESSNWW

GE ® 4.3 Cu.Ft. Capacity Electric Dryer

DRYER EXHAUSTING INFORMATION – METAL DUCT ONLY

FOR COMPLETE INFORMATION, SEE INSTALLATION INSTRUCTIONS

PACKED WITH YOUR DRYER.

DUCTING MATERIALS: For best performance, this dryer should be vented with

4" diameter all rigid metal exhaust duct. If rigid metal duct cannot be used, then

UL-listed flexible metal (semi-rigid) ducting can be used (Kit WX08X10077). In special installations, it may be necessary to connect the dryer to the house vent using a flexible metal (foil-type) duct. A UL-listed flexible metal (foil-type) duct may be used ONLY in installations where rigid metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4" diameter can be maintained throughout the entire length of the transition duct. Please see installation instruction packed with your dryer for complete instructions when using flexible metal (foil type) ducting.

EXHAUST LENGTH CALCULATION:

1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or bottom of dryer, add one turn.

2. The maximum length of 4' rigid (aluminum or galvanized) duct which can be tolerated is shown in the table.

A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a 90° elbow.

A turn over 45° should be treated as a 90° elbow.

Dryers must be exhausted to the outside.

CAUTION: For personal safety do not terminate exhaust into a chimney, under any enclosed house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen exhaust, since the combination of lint and grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall cap must also be located at least 12" above the ground or any other obstruction with the opening pointed down.

FOR MORE INFORMATION ON VENTING KITS AND

ACCESSORIES, PLEASE CALL 1-800-GE-CARES.

For answers to your Monogram, GE Café ™ Series, GE Profile ™ Series or

GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center ® Service, 800.626.2000.

A

A

4

4

DOMESTIC

B

DRYER MODELS

A

4

2-1/2

BEST PERFORMANCE

MAXIMUM LENGTH OF 4"

DIA. RIGID METAL DUCT

EXHAUST HOOD TYPE

NUMBER

OF

90°

TURNS

0

1

2

3

A

4"

OPENING

90 FT.

60 FT.

45 FT.

35 FT.

B

2-1/2"

OPENING

60 FT.

45 FT.

35 FT.

25 FT.

4.0 CU. FT.

CAPACITY MODELS

ALL ELECTRIC DRYERS

For every extra 90° elbow, reduce the allowable vent system length by 10 ft.

Two 45° elbows will be treated like one 90° elbow. For the side exhaust installations, add one 90° elbow to the chart. The total vent system length includes all the straight portions and elbows of the system (transition duct included).

Specification Revised 4/20

GFD14ESSNWW

GE ® 4.3 Cu.Ft. Capacity Electric Dryer

FEATURES AND BENEFITS

HE Sensor Dry – Keep your clothes looking and feeling their best. Dual thermistors continually monitor temperature with a sensor bar that measures moisture to prevent over-drying

13 Dry Cycles – Delivers optimal drying results with a customized cycle for every load

WiFi Capable – Monitor performance and checks cycle status using your mobile device.

*Required ConnectPlus accessory part number PVX10W00Y0 sold separately.

Outlet for Washer – Provides an outlet for the washer for easy and flexible installation

My Cycle Settings – Dry clothes with the settings you prefer on any cycle, rather than the defaults, and store your settings for later use

ENERGY STAR ® qualified – Meets or exceeds federal guidelines for energy efficiency for year-round energy and money savings

Delay start – Lets you do the laundry on your terms

Extended Tumble – Tumble clothes without heat to help prevent creasing and wrinkling

Quick Dry – Quickly dries items and small loads for families on the go

4 temperature selections – Pick the drying temperature you prefer for enhanced drying performance and fabric care

Cycle countdown display with LED indicators – Know exactly how much time is left for each cycle with bright display and lights

Stainless steel drum – Long–lasting, durable stainless steel resists rust and won't chip, peel or snag clothes

Model GFD14ESSNWW – White on white

V E N T E D D R Y E R

DRY

High

Medium

Low

DAMP

Ex Dry

Dry

COOL

Clean

No Heat

Low Air

Damp Damp

Filter eDry

Timed

Est Time Remaining

My Cycle Tumble Delay

Temp Level

Damp

Alert

Timed

Dry eDry My Cycle

Ext

Tumble

Hold to Set

Delay

Dry

Mixed Loads

Cottons

Towels

Casuals

Sanitize

Quick Dry

Delicates

Dewrinkle

Warm up

Start

Pause

Rack Dry

Power

GFD14ESSNWW

Specification Revised 4/20

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement