Label Blaster/Label Buddy Guide
Extend the embossing tape about one inch. This will allow for easier loading into the Label Blaster/Label Buddy.
Push in and upward on the tab located on the back of the Label Blaster/Label Buddy .
This will allow you to open the door to the tape compartment .
Insert the embossing tape into the slot located in the tape compartment.
Feed the tape in as far as you can.
Squeeze the handle two times to help feed the tape through the unit.
Place the embossing tape in the tape compartment and close the compartment door.
Squeeze the handle two more times to continue feeding the tape through the unit.
Turn the wheel to select different characters. Once you have selected the character you’d like to emboss, firmly squeeze the handle on the
Label Blaster/Label Buddy.
Firmly squeeze the handle to cut the tape.
Select the following symbol:
Remove the backing and apply the tape to the desired surface.
