JL Audio Stealthbox SB-F-F1502/10W3v3/TP Installation guide
JL Audio Stealthbox SB-F-F1502/10W3v3/TP is a high-quality enclosed subwoofer system designed for 2004-2008 Ford F-150 Super Crew & Super Cab and 2006-2008 Lincoln Mark LT. It features a 10W3v3-4 driver with a nominal impedance of 4 ohms and a continuous power handling of 500 watts. The bass reflex (ported) enclosure type delivers deep, powerful bass. The Stealthbox is designed for easy installation and includes all necessary hardware. It fits seamlessly into the vehicle's rear seating area without compromising legroom or storage space.
Advertisement
Advertisement
I N S T A L L A T I O N G U I D E
for the
Thank you for choosing a JL Audio Stealthbox ® for your automotive sound system. With proper installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox ® installed by your authorized JL Audio dealer. The installation professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle properly. If you prefer to perform your own installation, please read this installation guide completely before beginning the process.
If you choose to perform the installation yourself, it is absolutely vital that the Stealthbox ® be properly mounted to the vehicle according to these instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.
INSTALLATION
D I F F I C U L T Y : 1
5
OUT
OF
ESTIMATED TIME:
S T E P 1
Remove all contents from the rear seating area.
Lift up both seats.
Remove the jack, jack tools and the jack’s mounting bracket.
The jack and the jack tools must be relocated.
S T E P 2
Thread a supplied socket cup screw into the driver’s side rear of the Stealthbox®, leaving 1.0” of the threads exposed.
S T E P 3
Thread another supplied socket cup screw into the passenger’s side rear of the Stealthbox®, leaving 1.0” of the threads exposed.
Continued on Next Page
STEALTHBOX WALL
THREADED INSERT
Page 3 • JL Audio, Inc 2007
S T E P 4
Run speaker wire from the amplifier’s location to the
Stealthbox ® location and check for proper operation of the woofer.
S T E P 5
Guide the two socket cup set screws through the existing holes that are located on the rear seat brackets.
REAR SEAT BRACKET
LOCK WASHER
HEX NUT
SOCKET CUP SET SCREW
FLAT WASHER
S T E P 6
Place a supplied flat washer, lock washer and then hex nut onto each socket cup set screw and secure.
I N C L U D E D H A R D W A R E
(2) 3/8” -16 x 2-1/4” Socket Cup Set Screw
(2) 3/8” Flat Washer
(2) 3/8” Split Lock Washer
(2) 3/8” -16 Hex Nut
S P E C I F I C A T I O N S
Enclosure Type: Bass Reflex (ported)
Driver Type: 10W3v3-4
Nominal Impedance: 4 ohms mono
Continuous Power Handling: 500 Watts
JL Audio recommends using a high quality amplifier such as the JL Audio 500/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2 when being used to power your Stealthbox ® .
+12VDC Ground Remote
500 /1
Monoblock Subwoofer Amplifier
Preamp Output Section
Output Mode Filter Slope
Full Range | Amp Filter | Out Filter
55
45
12dB | 24dB
65
80
100
Filter Mode
40 200
LP | HP
Left Output Right Output Filter Freq. (Hz)
Infrasonic Filter
Mode
18
22
15
Off | On
30
45
55
60
Infrasonic Freq. (Hz)
1.1
0.7
0.5
“Q”
1.6
2.7
Center Freq.
40
30 60
Boost (dB)
+10
+4 +13
Bass EQ
Off | On
25
4.3
20
75
80 0
Remote Bass Port
Amp LP Filter
Mode | Slope
Advanced
Bass
Control
+15 Off | 12dB | 24dB
65
45
55 80
100
40 200
Filter Freq. (Hz)
Amplifier Input Section
Input Voltage Input Sens.
Signal Sensing
Low | High
Left Ch.
Right Ch.
Off | On
Subwoofer Output
MONO OUTPUT ONLY
The JL Audio 500/1v2 is a very versatile audio component. Please consult the owner’s manual for even more detailed information about installing and tuning this amplifier.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5” x 7” / Front Doors
Fits JL Audio Models: TR570-CXi, C5-570, C5-570x & ZR570-CS
Rear Speaker Size / Location: 5” x 7” / Rear Door
Fits JL Audio Models: TR570-CXi, C5-570, C5-570x & ZR570-CS
C O N G R A T U L A T I O N S
You have completed the installation for this model!
Please refer to the Power Recommendation section for an amplifier recommendation and basic set-up help.
(954) 443-1100 w w w . j l a u d i o . c o m
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
8 • Printed in USA • ©2007 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending. For more detailed information please visit us online at www.jlaudio.com.
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A
Advertisement