Contour Series (Flex 800 Solo 5877) CN KURTZ DESIGN 16.01.07
5736456_Contour380_CH Seite 11 Donnerstag, 12. April 2007 11:47 11
Contour Series
washable start
• stop washable
380
370
360
Type 5736
Type 5738
Type 5739
5736456_Contour380_CH Seite 2 Donnerstag, 12. April 2007 11:47 11
6
7
8
9
10
1
2
5 washable
3 start
• stop
4 charge re pl ace re s e t
360
6
7 charge empty re pl ace re s e t
370 washable
11 start
• stop on •
of f oil
5736456_Contour380_CH Seite 3 Donnerstag, 12. April 2007 11:47 11
3
5736456_Contour380_CH Seite 4 Donnerstag, 12. April 2007 11:47 11
4
5736456_Contour380_CH Seite 5 Donnerstag, 12. April 2007 11:47 11
5
5736456_Contour380_CH Seite 6 Donnerstag, 12. April 2007 11:47 11
6
5736456_Contour380_CH Seite 7 Donnerstag, 12. April 2007 11:47 11
English
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Gillette
Shaver.
Warning
Your shaver is provided with a special cord set with an integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock.
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch («start/stop»)
5 Long hair trimmer
6 Charging lights (green)
7 Low-charge light (red)
(370/380 models only)
8 Replacement light for shaving parts
9 Reset button
10 Special cord set
11 Model 380 only: charging stand
Charging
The best environmental temperature for charging is between 15°C and 35°C.
• Using the special cord set, connect the shaver/charging stand to an electrical outlet with the motor switched off.
• When charging for the first time, leave the shaver to charge continuously for 4 hours.
• Once the shaver is completely charged, discharge the shaver through normal use.
Then recharge to full capacity. Subsequent charges will take about 1 hour.
• A full charge provides up to 50 minutes of cordless shaving time depending on your beard growth.
• Maximum battery capacity will only be reached after several charging/discharging cycles.
• If the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set.
7
Charging lights
360 and 370 models: The green charging light blinks when the shaver is being charged. When the battery is fully charged, the charging light lights permanently.
380 model: The 3 segments of the green charging light indicate the charging level by thirds. When fully charged, all 3 segments of the charging light shine permanently.
Low-charge light
(370/380 models only)
The red low-charge light flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.
Tips for the perfect shave
• We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin. Stretch the skin and shave against the direction of beard growth.
• To maintain 100% shaving performance, replace the shaver foil and cutter block, when the replacement light (8) comes on
(after about 18 months), or when the shaving parts are worn.
5736456_Contour380_CH Seite 8 Donnerstag, 12. April 2007 11:47 11
Cleaning
This appliance is suitable for cleaning under an open water tap.
Warning: Detach the hand-held part from the power supply before cleaning it in water.
Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse the shaving head under hot running water.
A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
• Next, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil.
Alternatively, you may clean the shaver using the brush provided:
• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil.
Change both parts at the same time for a closer shave with less skin irritation.
(Shaver foil and cutter block: 31 B/S)
The replacement light will remind you during the next 7 shaves to replace the shaving parts. Then the shaver will automatically reset the display.
After you have replaced the shaving parts (foil and cutter block), use a ball-pen to push the reset button (9) for at least 3 seconds to reset the counter.
While doing so, the replacement light blinks and goes off when the reset is complete.
The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity. Do not expose the shaver to temperatures higher than 50°C for extended periods of time.
Environmental notice
This product contains rechargeable batteries. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country.
Keeping your shaver in top shape
About every four weeks, clean the cutter block with Braun cleaning agents. Put a drop of light machine oil onto the long hair trimmer and the shaver foil.
Replacement light for shaving parts / Reset
To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light for shaving parts (8) comes on
(after about 18 months) or when worn.
8
Subject to change without notice.
This product conforms to the European
Directives EMC 89/336/EEC and Low
Voltage 2006/95/EC.
For electric specifications, see printing on the special cord set.
5736456_Contour380_CH Seite 10 Donnerstag, 12. April 2007 11:47 11
Internet www.braun.com/register
Braun GmbH
Frankfurter Straße 145
61476 Kronberg/Germany
5-736-456/00/IV-07
China/GB
