Extron MMK 1 Template

Drill Template for the Extron

MMK 1

LED starts here

D= 1/8" (3.2mm)

D= 5/8" max.

(15.9 mm) max.

D= 1/8" (3.2mm)

Page Size: 8.5" x 11"

Print Scale 1:1

Do not Shrink

1. Confirm the product to be installed and make sure the page is not scaled.

2. Cut along the outer red line and tape the template on the mullion where it will be installed.

Place the template so the solid black line aligns with the front of the mullion.

3. Mark the center points of the drilling circles and remove the template.

4. Drill 1/8" (3.2 mm) top and bottom pilot holes.

5. Drill a 5/8" (15.9 mm) max diameter center hole to allow wires to exit the mullion.

6. Remove the template and follow the steps

in the Installation Guide. e

P/N 68-3498-01 Rev. A