Insulated
Banquet Cabinet
Rev. 1 (10/14)
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: EB Banquet Warming Cabinets
FL-2370
Page 1 of 4
ELECTRICAL SPECIFICATIONS:
Model No.
EB-64
EB-96
EB-120
EB-150A
EB-150-XX
Volts
120
208
240
Watts
1500
1500
1500
Amps
12.5
7.3
6.3
Hertz
60
60
60
Models are designed for AC Service.
Model Nos. may include suffixes: L, U, US, W, ST, Z and S.
Phase
1
1
1
NEMA
5-15P
6-15P
6-15-P
HOW TO INSTALL UNIT:
1. Remove all packing material from inside the cabinet and clean cabinet thoroughly.
2. Install all channels and shelves before the unit is put into operation.
3. Plug the power cord into the proper wall outlet.
4. For “W” Humidity Models: Add water to pan in hot unit.
TO TURN OFF UNIT:
Push the POWER switch to “OFF”.
The yellow light will go out.
HOW TO START UNIT :
1. Turn the POWER switch “ON” . The yellow light will turn on.
2. Turn the thermostat to no. 10.
3. Preheat (assuming a “cold” cabinet of 75°F/25°C):
To 150°F/65°C takes about 30 mins.
To 175°F/79°C takes about 45 mins.
To 190°F/88°C takes about 1 hour.
4. Put food into the cabinet.
5. Turn the thermostat to the required temperature.
NOTE : No. 8 is about 180°F/82°C
No. 7 is about 160°F/71°C
No. 6 is about 145°F/63°C
Proper food holding temperature is 140°F / 60°C or higher.
Thermometer Switch w/Light
Thermostat
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Insulated
Banquet Cabinet
Rev. 1 (10/14)
FL-2370
Page 2 of 4
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: EB Banquet Warming Cabinets
WARNING
MAINTENANCE:
Hot Unit Removal Instructions
1. Unplug power cord from wall outlet and remove cord from clip.
2. Lift up the bottom shelf: then lift up the hot unit about 5 inches and pull out.
Cleaning hints:
1. Wipe up spills as soon as possible.
2. Clean cabinet regularly to avoid heavy dirt build-up.
3. Make a test spot with cleaner.
4. Follow manufacturer’s directions on cleaner.
5. Do not mix cleaners.
6. Avoid drips and splashes.
7. Do not use “Cres Clean” on plastic parts or labels.
HOW TO CLEAN THE UNIT:
BEFORE Cleaning the Cabinet:
1. Allow cabinet to cool.
2. Remove hot unit from cabinet.
3. Do NOT use abrasives or harsh chemicals.
4. High pressure cleaning is recommended for cabinet exterior.
CABINETS
(Stainless Steel)
Soil Cleaner
Routine Cleaning Soap, ammonia, or detergent* and water
Stubborn spots and stains
Mild abrasive made for stainless steel
Burnt-on foods or grease.
1. Apply with damp cloth.
2. Rub lightly.
Method
1. Sponge on with cloth.
2. Rinse.
Chemical oven cleaner 1. Apply generous coating.
2. Allow to stand for 10-15 minutes.
3. Rinse.
4. Repeat application if necessary.
Hard water spots and scale.
Vinegar 1. Swab or wipe with cloth.
2. Rinse dry.
*Mild detergents include soaps and non-abrasive cleaners.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Insulated
Banquet Cabinet
Rev. 1 (10/14)
FL-2370
Page 3 of 4
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: EB Banquet Warming Cabinets
TROUBLE-SHOOTING CHART:
FAILURE:
1.
Yellow light at switch does NOT light.
POSSIBLE CAUSE:
1a. Circuit breaker/fuse to wall outlet is blown
1b. Cord is unplugged from wall outlet.
1c. Switch is “OFF.”
2. Unit does not heat.
2a. Thermostat set too low or is “OFF.”
2b. Switch is “OFF.”
3. Unit gets too hot or won’t shut off.
4. Blower does not work or makes noise.
3a. Defective electrical parts.
UNPLUG UNIT FROM WALL OUTLET
4a. Defective blower
5. Excess moisture in cabinet.
5. “Slack out” foods from oven or fryer for 5 minutes before putting in hot cabinet.
If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400
REPLACEMENT PARTS:
DESCRIPTION
Power Unit
Blower Kit
Heater Kit
Thermostat Kit
Thermometer Kit
Power Cord
Power Switch
Terminal Block
Water Pan
120 VOLT
1254-065
0769-180-K
0811-244
0848-062-K
5238-030-K
0810-029-02
0808-113-K
0852-091
1017-129
CABINET MODEL NOS:
Door Latch
Door Strike
Door Hinge
Door Gasket Kit
Door Assembly, Complete
Wire Grid
Pull Handle
EB-64
1006-143-K
1006-151-K
0519-084
0861-285-K
1221-615
1170-232
0911-087
For Sterno “ST” Models: 5037-012
5037-013
0977-083
208 VOLT
1254-066
0769-182-K
0811-245
0848-062-K
5238-030-K
0810-039-03
0808-113-01-K
0852-091
1017-129
EB-96
1006-143-K
1006-151-K
0519-084
0861-285-K
1221-615
1170-228
0911-087
RH Can Holder
LH Can Holder
Sterno Cover
EB-120
1006-143-K
1006-151-K
0519-084
0861-281-K
1221-607
1170-205
0911-119
240 VOLT
1254-067
0769-182-K
0811-246
0848-062-K
5238-030-K
0810-039-03
0808-113-01-K
0852-091
1017-129
EB-150A/EB-150XX
1006-143-K
1006-151-K
0519-084
0861-282-K
1221-611
1137-231
0911-119
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Insulated
Banquet Cabinet
Rev. 1 (10/14)
FL-2370
Page 4 of 4
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: EB Banquet Warming Cabinets
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
