SKMEI (Model 1077) DIGITAL WATCH INSTRUCTIONS
LIGHT START
MODE RESET
Four buttons on this watch are known as : LIGHT, MODE, RESET , and START
TO SELECT THE DISPLAY MODE
Push the Mode Button to select one of the following four display modes in the following order:
Normal Time -> Stop Watch -> Alarm Set -> Time Set
In the Normal Time Mode, the Day of Week, the Hour, Minute and Second are displayed (none flash). If the alarm bell icon at the bottom left is displayed, the alarm is turned on.
TO STOP/START THE ALARM
Press the MODE button x 2 to view the current alarm set time.
Press the START button to toggle between alarm on and hourly chime on, and off.
The small bell icon indicates the alarm is on.
The small triangle indicates the hourly chime is on.
TO SET THE TIME & DATE
Press the MODE button x 3 until the seconds are flashing.
To set the Hour press the RESET button x 1. Press the START button to increase the hours.
When an H is shown the watch is set in 24 hour time mode.
Press the RESET button again to toggle through Minutes -> Month -> Date -> Day of Week ->
Seconds
Press the START button to change the setting you are on.
Press the MODE button to complete.
TO SET THE ALARM
Note: The alarm is turned on every time the Alarm is set.
Press the MODE button x 2
Press the RESET button to select hours which will start flashing.
Press the START button to increase the hours
Press the RESET button to select minutes.
Press the START button to increase the minutes
Press the RESET button to complete.
A P indicates PM. No letter indicates AM.
If the time is set as a 24 hour mode, the alarm will also show only in 24 hours with a H.
Press the MODE button to finish and return to the time.
TO USE THE STOP WATCH
Press the MODE button x 1
Press the START button to start timing.
Press the START button to stop timing.
Press the RESET button to reset the stop watch to zero.
To record a LAP time, press the RESET button when the stop watch is running. Press RESET again to return to the live stop watch.
