Omega STR-604D+ Installation Manual

STR-604D+

Installation Guide

Not Used

1

- Head 1&2

- Head 3&4

IV . Wiring Control Harness. The YELLOW wire is for fl ash pattern selection. Connect the YELLOW from the supplied push button to the YELLOW of the Control

Harness. Connect the RED wire of the supplied push button to battery (+). Pressing the button momentarily will change to the next fl ash pattern. Press and hold the push button for 2 seconds will change the to the previous fl ash pattern. Pressing and holding the push button for 5 seconds will reset to Flash Pattern 0. (See chart)

Flash Pattern

Number

0

1

2

3

8

9

10

11

4

5

6

7

12

13

14

15

Flash Pattern Name

Demo

Quad

Quint

Double

Twin Double

Mega

Quint Mega

Double Quint

Double Delay

Single H/L

Wave

Single-Triple-Quint

Single-Quad

Dual: Quint

Dual: Single-Triple-Quint

Def Jam Mode

STR-604D+

Installation Guide

•

•

The GREEN & BLUE wires are for strobe activation.

Connect the GREEN & BLUE wires to the output side of the supplied ON/OFF switch. The input side of the

ON/OFF switch should be connected to a fused (+) voltage:

The

The

GREEN wire activates head 1 & 2.

BLUE wire activates head 3 & 4.

2